Search

To utilize half-metallic Heusler alloys in practical spintronic devices, such as magnetic sensors and magnetic memories, the key is to realize highly textured and structurally ordered polycrystalline thin films. In this study, we fabricated polycrystalline Co2FeGa0.5Ge0.5 (CFGG) Heusler alloy films deposited on a [001]-oriented Ag buffer layer, which was achieved by introducing N2 into Ar during the sputtering process, on a thermally oxidized Si substrate. We obtained strongly [001]-oriented CFGG films with B2 ordering and a high saturation magnetization close to the theoretical value, which can provide highly spin-polarized electric and spin current sources in spintronic devices with industrial viability., Comment: 16 papers, 5 figures

Recent advances in the study of materials with topological electronic band structures have revealed magnetic materials exhibiting giant anomalous Hall effects (AHE). The giant AHE has not only attracted the research interest in its mechanism but also opened up the possibility of practical application in magnetic sensors. In this article, we describe simulation-based investigations of AHE magnetic sensors for the applications to read head sensors (readers) of hard disk drives. With the shrinking of magnetic recording patterns, the reader technology, which currently uses multilayer-based tunnel magnetoresistance (TMR) devices, is associated with fundamental challenges, such as insufficient spatial resolution and signal-to-noise ratio (SNR) in sensors with dimensions below 20 nm. The structure of an AHE-based device composed of a single ferromagnetic material is advantageous for magnetic sensors with nanoscale dimensions. We found that AHE readers using topological ferromagnets with giant AHE, such as Co2MnGa, can achieve a higher SNR than current TMR readers. The higher SNR originates from the large output signal of the giant AHE as well as from the reduced thermal magnetic noise, which is the dominant noise in TMR readers. We highlight a major challenge in the development of AHE readers: the reduction in the output signal due to the shunting of the bias current and the leakage of the Hall voltage through the soft magnetic shields surrounding the AHE reader. We propose reader structures that overcome this challenge. Finally, we discuss the scope for future research to realize AHE readers., Comment: Revised version after peer-review

We report quantitative measurements of optically detected ferromagnetic resonance (ODFMR) of ferromagnetic thin films that use nitrogen-vacancy (NV) centers in diamonds to transduce FMR into a fluorescence intensity variation. To uncover the mechanism responsible for these signals, we study ODFMR as we 1) vary the separation of the NV centers from the ferromagnet (FM), 2) record the NV center longitudinal relaxation time $T_1$ during FMR, and 3) vary the material properties of the FM. Based on the results, we propose the following mechanism for ODFMR. Decay and scattering of the driven, uniform FMR mode results in spinwaves that produce fluctuating dipolar fields in a spectrum of frequencies. When the spinwave spectrum overlaps the NV center ground-state spin resonance frequencies, the dipolar fields from these resonant spinwaves relax the NV center spins, resulting in an ODFMR signal. These results lay the foundation for an approach to NV center spin relaxometry to study FM dynamics without the constraint of directly matching the NV center spin-transition frequency to the magnetic system of interest, thus enabling an alternate modality for scanned-probe magnetic microscopy that can sense ferromagnetic resonance with nanoscale resolution.