Search

In recent years, the design of new electronic equipment requires the development of new topologies for power supplies. The above is clear for portable equipment, which many times is classified as light loads. These new applications require power supplies with wide conversion ratios and better efficiencies. A solution to this problem is the use of two or more conventional converters connected in cascade, which have been proposed to operate in continuous conduction mode; however, if these converters operate in discontinuous conduction mode (DCM) a better efficiency is achieved. In this paper, a cascade connection based on two boost converters operating in DCM is proposed. A step‐by‐step procedure for the proper design of the cascade connection is given. Simulation and experimental results for a low power converter validate the proposed methodology. Thus, the design procedure will help in designing converters for light power applications. © 2020 Institute of Electrical Engineers of Japan. Published by Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

In array antennas, sometimes the desired radiation pattern cannot be obtained due to coupling between element antennas, reflections from the surroundings, or amplitude and phase error of the power supply circuits or failures. In these cases, it is necessary to regenerate the desired radiation pattern by estimating the excitation amplitude and phase of the array antennas. Among methods of estimation of the excitation amplitude and phase, the rotation element field vector method of element antennas is used for the phased array antenna with variable phase shifters, and the planar near-field measurement method is used for the array antennas with no variable phase shifters. The former is limited to phased array antennas, and the latter requires a large-scale scanner for the measurement and results in increased measurement time with larger-scale array antennas. In this paper, we propose a method of estimation of excitation amplitude and phase using the radiation pattern of array element antennas and the measured radiation pattern of the array antennas. Two methods are proposed here; the first method of estimation is the least-squares method using the electrical field as the measured radiation pattern, and the second is the repeating calculation method using the electrical power as the measured radiation pattern. We describe here the principle and experimental results when the first method is used, and the principle and the effectiveness of selection of the initial value for the second method is confirmed by numerical results. © 2000 Scripta Technica, Electron Comm Jpn Pt 1, 83(9): 102–110, 2000 [ABSTRACT FROM AUTHOR]