Search

Switching power supply is widely used in industrial equipment, household appliances, and other fields due to the advantages of high integration and lightweight. Voltage sags can seriously affect the output voltage of switching power supply and the working condition of its power supply equipment; at the same time, the working scenarios of power equipment using switching power supply often have different level of harmonic problems. Considering the continuous innovation of switching power supply technology, the previous analysis and test results on the effect of voltage sags and harmonics on switching power supplies may no longer be applicable. The paper reveals the mechanism of the effect of harmonic alone as well as voltage sag superimposed harmonics on the output voltage of the switching power supply. Then the test research program was developed, and four different brands switching power supplies were selected for the test research, with which the effects of different amplitude voltage sags, harmonics with different frequencies and distortion, as well as voltage sag superimposed harmonics on the output voltage of switching power supplies were investigated. The results show that the tolerance ability of switching power supplies to voltage sags has been improved compared with previous switching power supplies, and the harmonic itself has less effect on the output voltage of switching power supply, but the joint action of harmonics and voltage sags will have a greater effect on the output voltage of switching power supply. © 2024 Institute of Electrical Engineers of Japan and Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

This paper proposes a control method for step voltage regulators (SVRs) to avoid voltage violations in distribution systems with unbalanced voltages due to photovoltaic (PV) generation and electric vehicle (EV) charging. Distribution system operators must effectively address voltage problems resulting from the widespread installation of distributed energy resources under the optimizing the utilization of existing voltage regulators to establish an efficient and rational infrastructure. Therefore, this study focused on advancements in voltage control using SVR based on line‐drop compensator (LDC) control, which is widely used in actual operations. We propose a method that utilizes voltage data from information technology switches to detect and address voltage unbalances in the control section, allowing for the sequential adjustment of the monitoring target in LDC control to maintain appropriate voltage limits under unbalanced conditions. We conducted power flow calculations using a distribution system model that represents an actual distribution system in the Hokuriku area. The effectiveness of the proposed method was evaluated in terms of its impact on PV and EV hosting capacity, as well as the frequency of tap operations. © 2023 The Authors. IEEJ Transactions on Electrical and Electronic Engineering published by Institute of Electrical Engineer of Japan and Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

Off‐line partial discharge (PD) diagnosis, which requires an additional power supply has been accepted as an essential step in ensuring the integrity of power cable systems during commissioning testing. Many types of energizing voltage sources (e.g., alternating current resonance, damped alternating current, very low frequency [VLF] sine, and VLF‐cosine rectangular) have been developed, which are used in practice. However, choosing the optimal energizing voltage waveforms for PD testing is still controversial because their capability to motivate PD activities is still unclear. Accordingly, this paper compares the PD ignition capacity of the aforementioned power sources on six well‐designed PD defects in real cable joints. The influence of test voltage frequencies and waveforms are verified. The results show that the PD inception voltage and PD magnitudes in the cable joint defects do not change significantly as a function of the sinusoidal voltage frequency and the VLF‐cosine rectangular voltage exhibits excellent PD ignition capability with a low PD inception voltage and large PD magnitude. Moreover, the dynamic behavior of space charge in a PD defect caused by a gap is analyzed in order to explain the obtained results. © 2023 Institute of Electrical Engineer of Japan and Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]