Search

A nonlinear multivariable highly coupled system that is susceptible to both internal and external perturbations is the permanent magnet synchronous motor. A new reaching law‐based control approach that combines a sliding‐mode disturbance observer and an enhanced two‐vector model predictive current control is suggested in order to enhance the dynamic performance of the permanent magnet synchronous motor and its robustness to system disturbances. First, a new reaching law is developed in this paper to resolve the conflict between the traditional reaching law's chattering of the system and the reaching time of the sliding‐mode surface. This new reaching law not only makes the system's response more rapid but also reduces chattering; second, taking into account the possibility of systems with internal parameter uptake and external load disturbance, a sliding‐mode disturbance observer based on t is developed. Finally, the q‐axis current obtained from the speed sliding‐mode control rate is added to the model predictive current control, and an optimal duty cycle model predictive current control based on space vector modulation is designed because the traditional two‐vector model predictive current control is to optimize the duty cycle and voltage vectors separately, and the switching frequency is not fixed. The method suggested in this research may successfully suppress the sliding‐mode control system chattering and increase the resilience and dynamic response performance of the speed control system, according to simulation findings compared to the traditional reaching law and traditional duty cycle. © 2024 Institute of Electrical Engineer of Japan and Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

Aiming at the current control steady‐state error caused by sampling delay, parameters mismatch of direct‐drive permanent magnet synchronous motor (PMSM). This paper proposed a method of dual model predictive control (MPC) of direct‐drive PMSM based on sliding mode disturbance observer (SMDO). Deadbeat predictive current control (DPCC) is used for current loop, a SMDO is proposed to observe the system disturbance, the estimation is compensated to DPCC by feedback to decrease the current control steady‐state error. For speed loop, MPC with an internal model control observer (IMCO) can observe and compensate the load disturbance feedforward. The experimental results show that, the dynamic response speed of the proposed strategy is fast, the speed recovery time after sudden load torque is short, and the anti‐load disturbance performance and current tracking performance are effectively improved. © 2024 Institute of Electrical Engineers of Japan. Published by Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

The highway cycle is an important consideration in the EV's new European driving cycles (NEDCs) range, as the steady-state efficiency improvement in such conditions can be greatly beneficial. In the model predictive control (MPC) of the permanent magnet synchronous motors (PMSMs), the predicted next-step feedback reference generated by the equivalent circuit model (ECM) will contribute directly to the voltage vector selection, therefore influencing the performance of the motor control. In the current MPC scheme, when the conventional ECM is applied, it only considers copper loss, and the core loss is usually disregarded. In some circumstances, such as the highway cycle of EVs, the motors are at high speed, the torque is low, and the core loss can be significant in the losses, thus affecting the accuracy of control and the efficiency of the system; hence, the introduction of core loss ECM into the MPC would be beneficial. This paper aims to investigate the steady-state efficiency improvement of a novel ECM of PMSM considering core loss ECM, and the comparison will be based on model predictive direct torque control (MPDTC) using the core loss ECM, which will be compared to MPDTC with the conventional ECM of the PMSM. The results demonstrate the proposed ECM's efficiency improvement in various conditions, the limitations of the model and the simulation are discussed, and future work is proposed. [ABSTRACT FROM AUTHOR]