Search

The energy supply mode of a micro-cathodic arc thruster (μ-CAT) was adjusted based on the charge and discharge characteristics of the energy storage element, and the cathode discharge characteristics of μ-CAT were studied under different energy supply modes. We applied an electrical method to measure the discharge characteristics of μ-CAT, with an enhanced intensified charge coupled device spectrum detector to measure the plasma parameters of μ-CAT, allowing analysis of the internal logic among thruster plasma parameters, arc discharge characteristics, and thruster energy supply mode. The mechanisms of μ-CAT were analyzed and characteristics of accumulated discharge, energy distribution, and ion velocity distribution of thruster were compared under different energy supply modes to obtain the effect of the energy supply mode on the discharge characteristics of the interelectrode of μ-CAT. The results show that the energy supply mode of μ-CAT affected the ionization characteristics and ionization stability of the micro-cathodic arc thruster, causing a multistage ionization difference in the cathode metal target. This would not only affect the propulsion performance of the thruster, but also affect the change of the number of particles in the cathode region in a single discharge cycle. [ABSTRACT FROM AUTHOR]

The impact of geometric deviation due to manufacturing on compressor performance is considerable in engineering practice. To investigate the impact of blade thickness deviation on compressor performance and flow loss at various rotational speeds, a three-dimensional steady numerical simulation on Rotor 37 was conducted. The quantification of uncertainty was accomplished using a non-intrusive polynomial chaos method. The viscous dissipation coefficient was introduced to analyze the uncertain influence of blade thickness deviation on flow loss. Based on the type of loss source, the flow field was divided into six regions, including the blade tip region, blade root region, leading edge region, trailing edge region, blade surface region, and mainstream region. The results indicate that the sensitivity of total pressure ratio to thickness deviation increases significantly with an increase in the rotational speed. Under peak efficiency conditions, the effect of blade thickness deviation on flow dissipation in leading edge region decreases initially and then increases with an increase in the rotational speed. Meanwhile, the impact on flow loss in other regions increases with the increase in the rotational speed. Under near stall conditions, the blade thickness deviation has a great impact on the flow losses in the blade tip region, leading edge region, and mainstream region at 60% design rotational speed. However, the blade tip region and trailing edge region are more noticeably affected at 100% design rotational speed. Furthermore, the quantification of standard deviation of flow losses in various regions under different rotational speeds and conditions reveals that the flow loss fluctuation in the leading edge region and mainstream region varies with changes in operating conditions and rotational speeds, but the fluctuation of flow loss in other regions is independent of the rotational speed. [ABSTRACT FROM AUTHOR]

This study proposes a newly designed ignition circuit that does not change the ignition starting parameters of a Hall thruster, reduces the critical ignition voltage, and improves ignition reliability. The complexity and weight of the Hall thruster power supply system are reduced by multiplexing the ignition and discharge power supplies. Under the condition that the design parameters are satisfied, that is, R 3 + R E C 2 is much larger than RCC1, the residual energy in the circuit after the cathode breakdown can be fed into the thruster discharge channel to improve the ignition energy supply. The experimental results show that when the anode voltage is 98 V, only nine of the 100 ignition tests are successful using the traditional ignition circuit, whereas the number of successes using the newly designed ignition circuit is as high as 99, which provides a simple solution method for improving the ignition reliability. [ABSTRACT FROM AUTHOR]