Search

A computationally efficient method to study the in-plane and out-of-plane dimensional instability of thin paper sheets under the influence of moisture changes is presented. The method explicitly resolves the bonded and the free segments of fibers in the sheet, capturing the effect of anisotropic hygroexpansion at the fiber level. The method is verified against a volumetric model. The importance of longitudinal fiber hygroexpansion is demonstrated in spite of the absolute value of longitudinal hygroexpansion being an order of magnitude lower than the transverse hygroexpansion component. Finally, the method is used to demonstrate the formation of macroscopic sheet curl due to a moisture gradient in structurally uniform sheets in the absence of viscoelastic or plastic constitutive behavior and through-thickness residual stress profiles. [ABSTRACT FROM AUTHOR]

The tensile response of dense fiber-based materials like paper or paperboard is mainly dependent of the properties of the fibers, which store most of the elastic energy. In this paper, we investigate the influence of geometrical and material parameters on the mechanical response of the pulp fibers used in paper manufacturing. We developed a three-dimensional finite element model of the fiber, which accounts for microfibril orientation of cellulose fibril, and the presence of lignin in the secondary cell wall. The results showed that the change in the microfibril orientation upon axial straining is mainly a geometrical effect, and is independent of the material properties of the fiber, as long as the deformations are elastic. Plastic strain accelerates the change in microfibril orientation and thus makes it material-dependent. The results also showed that the elastic modulus of the fiber has a non-linear dependency on microfibril angle, with elastic modulus being more sensitive to the change of microfibril angle around small initial values of microfibril angles. Based on numerical results acquired from a 3D fiber model supported by available experimental evidence, we propose an anisotropic-kinematic hardening plasticity model for a fiber within a beam framework. The proposed fiber model is capable of reproducing the main features of the cyclic tensile response of a pulp fiber, such as stiffening due to changing microfibril angle. The constitutive model of the fiber was implemented in a finite-element model of the fiber network. By using the fiber network model, we estimated the level of strain that fiber segments accumulate before the typical failure strain of the entire network is reached. [ABSTRACT FROM AUTHOR]