Search

• Energy harvesting from moving harmonic and continuous mass on simply supported beam. • Theoretical and experimental study of energy harvesting from moving mass. • Increase in the harvested power by adding the mass and the speed of the moving part. • Decrease in the harvested power by increasing the length of moving continuous mass. In this paper, energy harvesting from a simply supported beam using piezoelectric materials has been performed. Two different models for the moving objects were considered. First, the passing object was modeled as a concentrated mass with some amount of unbalances. The coupled governing equations of the beam, the piezoelectric patch, and the moving mass were obtained and discretized using assumed mode method. The beam response and the output voltage were calculated for different values of moving mass and unbalances. In the second model, the passing object was studied as a distributed mass. The governing equations of the system were extracted at three stages, namely entrance, main, and exit of the object from the beam. To validate the numerical findings, two test setups were erected, and the beam midpoint deflection and the piezoelectric power were measured experimentally. A good degree of correlation was found between numerical and measured values. [ABSTRACT FROM AUTHOR]

This paper aims to investigate the amount of energy which can be harvested by a cantilever beam type piezoelectric energy harvester from a bridge vibration. The sources of vibration are vehicles traversing the bridge. Two types of masses are considered as models for traversing vehicles: concentrated and distributed masses. The mass of the harvester is assumed negligible compared to that of the bridge. First, the problem of moving mass travelling with a constant speed over a beam is considered. The formulations for both concentrated and distributed masses are presented. The obtained results are then compared to the data available in the literature, in order to validate the model of a beam with a moving mass. Next, a mathematical model for the harvester is proposed, which is composed of an Euler–Bernoulli beam as a substrate, a tip mass, and a single piezoelectric patch whose electrodes are connected to a changeable resistance. To validate the model, the harvester is fabricated and tested on a shaker. The electroelastic frequency response functions of the system are measured by low-amplitude chirp excitation tests. The optimal resistive load at the resonance frequency, obtained from theory and experiments, are compared. Finally, the acceleration time histories for the beam at mid-span, where the harvester is located, are calculated for two mass types and used as base excitation signals to the harvester. These signals are replayed on an electromagnetic shaker to simulate the bridge vibrations on the fabricated harvester and the experimental results are compared with theoretical ones. Good agreement is observed. [ABSTRACT FROM AUTHOR]