Search

Summary: This paper proposes a two‐stage planning approach for the efficient utilization of distributed generation (DG) and capacitor banks (CBs) for the simultaneous grid‐connected and islanded operations of the balanced distribution networks. The first stage determines the optimal installation locations and capacities of DGs and CBs using an improved variant of the Jaya optimization algorithm (IJaya) to minimize the power losses and voltage deviation during the grid‐connected operation of the distribution network. The second stage identifies the optimal operating point of the DG and CB combination to carry the maximum load during the islanded network operation under power supply‐demand imbalance conditions. For the second stage, an analytical approach is proposed to identify the best operating power factor for the DG‐CB combination, calculating the power loss, and under‐utilization of the installed real‐reactive power sources. Simulation results on the IEEE 33‐bus grid‐dependent distribution network demonstrate that the proposed IJaya significantly improved the network performance and outperforms various existing optimization methods. In addition, during the network's islanded operation, maintaining the network power factor equal to the source power factor (pfsource) makes the DG‐CB combination operate at their rated capacities. [ABSTRACT FROM AUTHOR]

The vigorous development of renewable energy has induced multiple sources connected to regional distribution networks. However, the high impedance ground fault that appeared in the distribution network can induce an intermittent arc accompanied by extinction and reignition, which may damage renewable energy generation devices severely. Therefore, the detection of arcing faults is profoundly necessary for practice, but the high impedance arcing fault is easily confused with switches of motor or capacitor bank. In order to solve high impedance arcing fault detection, this paper proposes a high impedance arcing fault detection method that combines complete ensemble empirical mode decomposition with adaptive noise (CEEMDAN) and Teager energy operator (TEO). Firstly, CEEMDAN algorithm is used to extract the intrinsic mode function (IMF) of transient zero‐sequence current (TZSC). According to the correlation coefficient and waveform similarity, which can select maximum correlation coefficient value as the characteristic component of TZSC; Then, TEO is utilized to track the change of signal in real‐time, meanwhile, wavelet singular entropy (WSE) is applied to calculate the characteristic component of TZSC. In particular, high impedance arcing fault (HIAF), motor switching (MS), and capacitor bank switching (CBS) can be effectively identified by comparing WSE. The effectiveness of CEEMDAN‐TEO detection method is verified by simulation, which owns advantages in extraction accuracy, calculation efficiency, and detection accuracy of feature components. [ABSTRACT FROM AUTHOR]

Summary: Conventionally, voltage profile are regulated by controllers that are not operational flexible to the system dynamism and challenges offered by the integration of renewable energy sources. Consequently, there is a need for the adaptive coordinating mechanism as an interface between the passive network and the new active network. This will provide a platform for the smooth integration of distributed energy resources in most developing countries where traditional network is still operational. This paper proposes an algorithm for real‐time multiperiod adaptive compensation of network reactive power support based on hierarchical structure and decentralized layered multiagent system voltage coordinating scheme. A multiperiod voltage control algorithm replicates the daily load flow evaluation aiming at ameliorating voltage fluctuation over a 24‐hour simulation period. The algorithm applies the decentralized voltage control mechanism to monitor the network parameters and dynamically evaluate the capacity of the capacitor banks (CBs) to be injected for voltage compensation. This mitigates the challenges associated with under and over reactive power compensation experienced in the day‐ahead programming and manual switching operation. The algorithm works in conjunction with an on‐load tap changing transformer (OLTC) and energy storage system (ESS). The ESS complements the OLTC during switching delay, dip in its output root mean square and voltage fluctuation as network loading condition varies. The effectiveness of the proposed method is verified on standard IEEE 33 and 118‐bus distribution systems. The results show an improved voltage performance and reduction in stress/complexity associated with load and renewable generation forecast in manual switching operations. [ABSTRACT FROM AUTHOR]