Search

This paper focuses on the self-synchronization control of cascaded-type STATCOM. One module is controlled as the current source, and the rest are regulated as voltage sources. The low-bandwidth communication is just used to transmit the given reactive powers. Via the carrier of common grid current acquired locally, the self-synchronized operation of all modules is realized. When a short interruption in communication occurs, the stable operation of the system is unaffected. Thus, the system reliability is improved in case of communication failure. The small-signal stability of the proposed scheme is proven. Finally, the effectiveness of the proposed scheme is verified by both simulation and hardware-in-the-loop results. [ABSTRACT FROM AUTHOR]

Ti-15Nb-25Zr-(0, 4, 8)Fe (mol.%) alloys were prepared via spark plasma sintering (SPS) for 10 min at 800, 1000, and 1200 °C to study the effect of sintering temperatures and Fe content on the mechanical properties of alloys. The main phase of the alloys sintered at 800 °C is α phase. When the temperature is increased to 1000 and 1200 °C, the alloys are mainly β phase. Raising the sintering temperature can promote the diffusion of elements. Therefore, high strength and high plasticity are obtained in the alloys sintered at high temperature. The compressive strength of Ti-15Nb-25Zr sintered at 1200 °C is 1604 MPa, and the fracture strain is around 35%. The strength and plasticity are influenced by the complex effects of elemental diffusion, grain boundary and solid-solution strengthening. Adding Fe can improve the diffusion of elements, promote the formation of β grains and supply solid-solution strengthening effect. As the sintering temperature is increased, the compressive strength of Ti-15Nb-25Zr-4Fe shows an increasing trend and the plasticity is almost not changed. The Fe content is excessive in Ti-15Nb-25Zr-8Fe, which leads to some disadvantages including intermetallic compounds formation and grain boundary coarsening. The mechanical properties of Ti-15Nb-25Zr-8Fe are not always better than those of Ti-15Nb-25Zr-4Fe. The compressive strength of Ti-15Nb-25Zr-8Fe shows an increasing trend and the plasticity firstly increases and then decreases when the temperature is raised from 800 up to 1200 °C. Although the sintering time of SPS is short, Ti-15Nb-25Zr-(4, 8)Fe sintered at 1000 °C and Ti-15Nb-25Zr-(0, 4)Fe sintered at 1200 °C show good combination of strength and plasticity. [ABSTRACT FROM AUTHOR]

Silage and dry are the two typical cornstalk forms. Either form could be used as substrate in biogas plants and might be replaced by another when shortage occurred. This study focused on the feeding sequence of these two kinds of feedstocks, aiming to discuss their specific methane potential (SMP). A 15-day hydraulic retention time was chosen for semi-continuous experiments based on the batch test results. In semi-continuous experiments, before and after feedstocks were exchanged, the significantly decreased and comparable SMPs of silage and dry cornstalks indicated that a basis of unstable digestion would result in incomplete methane release from the subsequent digestion. A higher similarity of bacterial community structure and greater quantity of bacteria were shown in acidified silage cornstalk digestion through band similarity analysis. Methanosaetaceae and methanomicrobiales were the predominant methanogens, and aceticlastic methanogenesis was the main route for methane production. The different feeding sequences affected the hydrolysis course and further influenced the methanogenic proliferation. Our work suggests that silage cornstalk digestion should be conducted before dry cornstalk digestion. [ABSTRACT FROM AUTHOR]