Search

Synchronverter (SV) control has emerged as a popular method for distributed energy resources (DERs), to emulate response of a synchronous generator. In this work, a simple gradient descent based pre‐synchronization control for SV scheme is proposed that varies the reference frequency in SV control alone. Thus, local load connection to DER can remain intact during synchronization with proposed pre‐synchronization method, unlike virtual current based methods. Normally, phase‐locked loop used for synchronization purpose, uses a first order loop filter such as a PI controller. In the proposed pre‐synchronization control, the inherent low pass filter of SV scheme itself is used as a loop filter. Transient response analysis is presented in this work, based on small signal transfer functions derived from the proposed method. From the theoretical analysis of proposed pre‐synchronisation control, design of the parameters is presented. Thus, there is no trial and error basis for parameters tuning in the proposed method, as compared to virtual current based methods. Validation of proposed pre‐synchronisation control through experiments are presented for all initial conditions. The transient response analysis, effectiveness of proposed method during local load changes and grid integration are verified by experimental results. [ABSTRACT FROM AUTHOR]

Single-stage DC-AC converter systems (SSCSs) are developed by merging both DC-DC and DC-AC conversion processes. These SSCS transfer power from photovoltaics (PV) to loads/grid in one stage. In this study, a PV-based grid tied single-stage DC-AC converter system (GTSS) for low-voltage PV systems is presented. Generally, when SSCSs are connected to the grid, grid voltage template is used to generate reference current which is to be tracked. In doing so, the GTSS delivers power to the grid at a power factor other than unity. A suitable control scheme is implemented in this study to control active and reactive powers' flow from the GTSS to the grid while continuously operating PV at maximum power point. The proposed control scheme of GTSS has attributes such as less complexity and requires simple proportional integral controller. Modelling of control loops in the proposed control scheme is mentioned. A detailed MATLAB/SIMULINK-based simulation and experimental studies are conducted to validate the proposed control scheme. [ABSTRACT FROM AUTHOR]

In a variable switching frequency control scheme, it is challenging to design the voltage source inverter (VSI) parameters without knowing the maximum and minimum switching frequencies. The switching frequency variation depends on the system parameters. Therefore, the expression for frequency variation in one inverter topology does not hold in other topologies. The design of hysteresis current controlled four-leg shunt active power filter (APF) requires the switching dynamics analysis to ensure satisfactory performance of the inverter. In this study, a detailed analysis on the switching dynamics of hysteresis current controlled four-leg VSI and design of various inverter components for compensating unbalanced and nonlinear loads are presented. The results obtained from these analyses can be used in any applications involving hysteresis current controlled four-leg VSI. These results are supported by detailed simulation studies conducted on a three-phase four-leg shunt APF system using Matlab/Simulink. The theoretical studies and design of passive components are also verified by conducting experiments on a prototype of four-leg shunt APF developed in the laboratory. [ABSTRACT FROM AUTHOR]