Search

The study presents the results of a numerical analysis of the effectiveness of the use of personal protective equipment of various designs on the spread of pollutants marked with CO2 emitted during human breathing. In the study of 3D geometry the upper part of the human torso and head was developed. The simulated person was supplied with different personal protective equipment covering the human face (PPE). Two types of face shields worn at a different distance from the face and one fabric face mask was analysed. The reference geometry with no personal protective equipment was also analysed. Transient calculation with full breathing model including breath-in and breath-out and species transport were simulated. The results showed that different PPE generates different airflow patterns in the vicinity of the human face. The most efficient in reducing infection risk is by wearing a face mask or face shields at a small distance from the face, as they most effectively reduce CO2 concentration in the surrounding air. However, they also increase the re-inhalation risk of high CO2 concentration which affects human well-being.

Paper present the experimental and numerical analysis of biomass photopyrolysis process. The experimental tests is performed on the solar pyrolysis installation, designed in Institute of Thermal Technology, Gliwice. It consist of the copper reactor powered by artificial light simulating sun. The paper shows the result of the solar pyrolysis of wood. The yield of the main fraction as a function of the process temperature is presented. Additionally the gas composition is determined. The numerical model is prepared in the Ansys Fluent 18.2 software, which allow at the same time for capturing geometry of the real system and easy change of input data. The results indicate that both the product yields (liquid, solid and gaseous) and gas components shares are strongly influenced by pyrolysis parameters and feedstock composition.

The role of interzonal airflows is especially pronounced in naturally ventilated buildings. In such buildings, reversed airflows in the ventilation stacks might occur as well. This affects the air exchange rate and contaminant distribution in buildings. A significant increase in carbon dioxide concentration is a characteristic phenomenon for poorly ventilated rooms. This paper demonstrates the application of metabolic carbon dioxide concentration measurements for interzonal airflow estimation in naturally ventilated buildings. The presented method is based on the continuous measurements of CO2 concentration at one point in each zone. These measurements are used to estimate airflow pattern in a multizone building by applying an inverse analysis. The developed methodology employs an iterative Levenberg-Marquardt procedure to maximise the nonlinear likelihood function. The validity of the method was verified against measurements carried out in a single naturally ventilated room. Further, the method was applied to calculate the airflow pattern in two apartments in Poland, containing 4 and 6 zones. The obtained results revealed very poor ventilation in both investigated apartments and reversed airflow in exhaust ducts. The amount of fresh air entering the rooms was insufficient to ensure good indoor air quality. The developed methodology can be effectively used as a diagnostic tool to identify the potential problems with ventilation systems. [ABSTRACT FROM AUTHOR]

Work presents an investigation of chloride penetration of HC-500 prestressed concrete slabs made of precast concrete. This type of concrete slabs is widely used to construct floors in steel or reinforced concrete framing buildings. In such solutions ceiling can be considered as a simple-supported beam. Considered precast concrete was made of C50/C60 concrete with use of Portland cement CEM II 52.5 R. Investigated specimens were sampled directly from the upper part of prestressed concrete slabs. The process of chloride penetration in concrete can be described by the non-linear diffusion equation. In the paper Bayesian inverse technique was applied to estimate diffusion coefficient of chloride in concrete treated as a saturated porous material. Unknown distribution of estimated parameters was sampled with use of Metropolis-Hastings algorithm which allowed us to obtain unknown values and their error bounds. Obtained values of diffusion coefficient were confronted against values obtained with use of norms: NT BUILD 443 and ASTM C 1556 - 03 and against previously developed methodology based on the analytical solution of the diffusion equation.