Search

The pulp and paper industry is a high energy consuming and polluting sector, and carbon emissions emitted from this sector are worthy of attention. This article, based upon an analysis of China’s Pulp and Paper Industry (CPPI), provides estimates of each of the following: carbon emissions from energy consumption, pre-treatment sector, combustion of condensed black liquor, and methane emitted from incomplete aerobic digestion during sewage treatment of CPPI. During the study period (2005–2012), total CO 2 emissions ranged from 126.0 Mt to 155.4 Mt. Energy consumption was estimated to be the largest source of carbon emissions, however, due to the application of the local emission inventory rather than the IPCC inventory, energy consumption decreased by 4.7%, a lower percentage than was calculated in a previous study. According to this study’s estimation, the emissions caused by the recovery of biomass energy contributed 26–29% of the total CO 2 emissions. CH 4 generated from sewage treatment accounted for 9–11% of the total carbon emissions. The CO 2 intensity dropped during the study period, which reflected the improvement of energy efficiency in the pulp and paper industry. The outcome of this study provides not only detailed information about CPPI’s carbon emissions, but also a calculation framework for studying carbon emissions from pulp and paper sector in the other regions. It suggests that the local carbon emissions inventory should be used for estimating carbon emissions and to reduce the fossil fuel energy, increase energy recovery from biomass, and that promoting cleaner production is essential to achieve a low carbon development of the pulp and paper industry. [ABSTRACT FROM AUTHOR]

The paper discusses existing trends and prospects for decarbonization in the Commonwealth of Independent States (the CIS), an international organization that regroups Armenia, Azerbaijan, Belarus, Kazakhstan, Kyrgyzstan, Moldova, Russia, Tajikistan, Turkmenistan, and Uzbekistan. The CIS occupies a significant share of Eurasia, representing a large share of global energy consumption and production with a corresponding carbon footprint. These countries and their decarbonization prospects are rarely discussed in the English-language scientific literature. This paper fills in this gap by offering a comprehensive analysis based on statistical data, policy documents, and scenario-based future projections. The results underline that revisiting Nationally Determined Contributions, increasing energy efficiency, and decoupling GDP growth from greenhouse gas emissions are essential to the implementation of the Paris Agreement. The future energy mix should include larger shares of renewable energy, hydrogen, fossil fuels (highly efficient with carbon capture), and nuclear energy to achieve energy security and decarbonize the economy of the region in the long term. [ABSTRACT FROM AUTHOR]

In the context of smart cities, sustainability is an essential dimension. One of the ways to achieve sustainability and reduce the emission of greenhouse gases in smart cities is through the promotion of sustainable energy. The demand for affordable and reliable electrical energy requires different energy sources, where the cost of production often outweighs the environmental factor. This paper aims to investigate the ways smart cities promote sustainability in the electricity sector. For this, a systematic literature review using the PRISMA protocol was employed as the methodological approach. In this review, 154 journal articles were thoroughly analyzed. The results were grouped according to the themes and categorized into energy efficiency, renewable energies, and energy and urban planning. The study findings revealed the following: (a) global academic publication landscape for smart city and energy sustainability research; (b) unbalanced publications when critically evaluating geographical continents' energy use intensity vs. smart cities' energy sustainability research outcomes; (c) there is a heavy concentration on the technology dimension of energy sustainability and efficiency, and renewables topics in the literature, but much less attention is paid to the energy and urban planning issues. The insights generated inform urban and energy authorities and provide scholars with directions for prospective research. [ABSTRACT FROM AUTHOR]

The excessive carbon emissions not only intensify the global climate change, but also seriously restrict the sustainable development of social economy. However, improving industrial carbon emissions efficiency is the most directly effective way to reduce emissions. Therefore, accurate measurement and analysis of carbon emissions efficiency and evolution characteristics of China's industrial system is the basis for China to improve carbon emissions efficiency. Based on this, we adopted energy consumption method and input-output method to calculate and analyze the industrial carbon emissions efficiency and evolution characteristics of China from 2002 to 2015. The results show that (1) If carbon emissions from cement production are ignored and only energy-related carbon emissions are considered, the calculation results of carbon emissions efficiency of heavy industry will be overestimated about 30%. (2) Compared with 2002, China's industrial carbon emissions efficiency increased by about twice in 2015. Specifically, the optimization of carbon emissions efficiency in agriculture, construction, light industry and service industry is very obvious, which has increased by 5.65, 5.00, 4.69 and 4.68 times respectively; The optimization of carbon emissions efficiency in power sector, heavy industry, transportation and chemical industry was obvious, which increased by 2.55, 2.01, 1.86 and 1.47 times respectively; The carbon emissions efficiency of the fossil energy sector has decreased by 0.36 times. (3) The carbon emissions efficiency of various industries has significant differences. Among them, agriculture, service industry, light industry and construction industry are generally industries with higher carbon emissions efficiency, while power sector, fossil energy sector, transportation industry, chemical industry and heavy industry are generally industries with lower carbon emissions efficiency, especially power and fossil energy sectors. Based on these, this paper provides policy implications and scientific evidence for accurately improving carbon emissions efficiency from the perspective of carbon emissions efficiency. [ABSTRACT FROM AUTHOR]

Ongoing concern over climate change has led to interest in replacing fossil energy with bioenergy. There are different approaches to quantitatively estimate the climate change effects of bioenergy systems. In the present work, we have focused on a range of published impact assessment methods that vary due to conceptual differences in the treatment of biogenic carbon fluxes, the type of climate change impacts they address and differences in time horizon and time preference. Specifically, this paper reviews fifteen different methods and applies these to three hypothetical bioenergy case studies: (a) woody biomass grown on previously forested land; (b) woody biomass grown on previous pasture land; and (b) annual energy crop grown on previously cropped land. Our analysis shows that the choice of method can have an important influence on the quantification of climate change effects of bioenergy, particularly when a mature forest is converted to bioenergy use as it involves a substantial reduction in biomass carbon stocks. Results are more uniform in other case studies. In general, results are more sensitive to specific impact assessment methods when they involve both emissions and removals at different points in time, such as for forest bioenergy, but have a much smaller influence on agricultural bioenergy systems grown on land previously used for pasture or annual cropping. The development of effective policies for climate change mitigation through renewable energy use requires consistent and accurate approaches to identification of bioenergy systems that can result in climate change mitigation. The use of different methods for the same purpose: estimating the climate change effects of bioenergy systems, can lead to confusing and contradictory conclusions. A full interpretation of the results generated with different methods must be based on an understanding that the different methods focus on different aspects of climate change and represent different time preferences. There are different approaches to quantitatively estimate the climate change effects of bioenergy systems. In the present work, we review fifteen different methods and apply these to three hypothetical bioenergy case studies. Our analysis shows that the choice of method can have an important influence on the quantification of climate change effects of bioenergy. The use of different methods for the same purpose can lead to confusing and contradictory conclusions. [ABSTRACT FROM AUTHOR]

Addressing climate change requires the efforts of all countries with common but differentiated responsibilities. The mitigation responsibilities one country takes greatly depends on its national emission inventories. As a good complement to the production-based accounting (PBA) principle, consumption-based accounting (CBA) principle has been widely concerned. However, few studies focus on emissions equity issues temporally and spatially. In this paper, we explore the characteristics of production-based and consumption-based CO 2 emissions for 14 major economies through multiple-dimension comparisons to get insight into the emissions equity comparisons among major emitters. In particular, four categories of economies with different dynamic features are divided based on their percentage differences between PBA and CBA emissions. Demographical and economic variables are additionally taken into consideration. The results indicate that France and Russia hold extreme characteristic on evaluating the emission difference between two principles, while China and Chinese Taiwan reveal uniquely increasingly larger gaps between two principle emissions. Besides, the per capita CBA emissions grows more prominently and possesses a more obviously positive correlation with their own per capita GDP which confirms that CBA principle is potentially attractive for estimating national emissions. [ABSTRACT FROM AUTHOR]

[Display omitted] • Archetype development, model components and potential applications for UBEM are discussed. • Stochastic and dynamic occupancy models are among the most desired improvements for UBEM. • UBEM could be suitable for high accuracy predictions of future climate change scenarios. • Integration of socio-economic data in UBEM is promising but not currently applied. • Assigning value year from renovation records is tempting but could entail several pitfalls. Due to rapid urbanisation and the significant contribution of cities to worldwide energy use and greenhouse gas emissions, urban energy system planning is growing more important. Urban building energy modelling (UBEM) draws increasing attention in the energy modelling field due to its inherent capacities for modelling entire cities or building stocks, and the potential of varying data inputs, approaches and applications. This review aims to identify best practices and improvements for UBEM applications by examining previous research, with a focus on the currently least established approaches. Different archetype development procedures are analysed for common problems, six main under-developed input approaches or parameters are identified, and applications for future scenario development are surveyed. By analysing previous studies in related fields, this paper provides an overview of gaps in the published research and possible additions to future UBEM projects that can help expanding the existing modelling procedures. Comprehensive human behaviour models with additional aspects beyond occupant presence are identified as a major point of interest. Further research on socio-economic parameters, such as household income and demographics, are also suggested to further improve modelling. This study also underlines the potential for utilising UBEM as a tool for evaluating future climate change scenarios. [ABSTRACT FROM AUTHOR]

The realization of national climate change commitments, as agreed through international negotiations, requires local action. However, data is still insufficient to make accurate statements about the scale of urban emissions (UNHABITAT, 2011). The need of comparable emission inventories at city level, including smaller cities, is widely recognized to develop evidence-based policies accounting for the relation between emissions and institutional, socio-economic and demographic characteristics at city level. This paper presents a collection of harmonized greenhouse gases (GHG) emission inventories (the "CoM sample 2013") at municipal level directly computed by the cities and towns that participate in the EU Covenant of Mayors initiative. This is the mainstream European movement of local and regional authorities who voluntarily commit to reduce GHG emissions by 20% or more by 2020. The "CoM sample 2013" (http://edgar.jrc.ec.europa.eu/com/data/index.php? SECURE=123, doi:10.2904/EDGARcom2013) has been carefully checked to ensure its internal consistency and its congruity with respect to internationally accepted guide values for emission factors. Overall, it provides valuable data for the analysis of the heterogeneity of final energy consumption and greenhouse gas emissions of cities. [ABSTRACT FROM AUTHOR]

The paper determines the effect of selected cultivation technologies, including production chain energy inputs (growing, harvest, heap forming) on greenhouse gas emissions (GHGs) to the atmosphere. The data for the study was collected from 13 actually operating family farms ranging in size from 2 to 13 ha, located in the Podlaskie voivodship (Poland). GHG and ammonia (NH3) emissions from natural and mineral fertilisation as well as GHGs from energy carriers in a form of fuels (ON) were estimated. The average GHG emissions from the sources analysed were 1848.030 kg·CO2eq·ha−1 and 29.492 kg·CO2eq·t−1 of the green forage yield. The average NH3 emissions per hectare were 15,261.808 kg NH3 and 248.871 kg NH3·t−1 of yield. The strongest impact on the environment, due to the GHG emissions to the atmosphere, thus contributing to the greenhouse effect, is due nitrogen fertilisation, both mineral and natural. On average, in the technologies under study, 61% of the total GHG emissions came from fertilisation. The GHG emissions were correlated with the energy efficiency, calculated at the previous research stage, of the production technologies applied. There is a negative correlation (r = −0.80) between the features studied, which means that the higher the energy efficiency of the silage maize plantations, the lower the air pollution emissions in a form of the GHGs from the sources under study. It is so important to prevent environmental degradation to continue, conduct in-depth, interdisciplinary research on reducing the energy consumption of crop production technologies and striving to increase energy efficiency. [ABSTRACT FROM AUTHOR]

This paper reviews the many criticisms that Integrated Assessment Models (IAMs)—the bedrock of mitigation analysis—have received in recent years. Critics have asserted that there is a lack of transparency around model structures and input assumptions, a lack of credibility in those input assumptions that are made visible, an over-reliance on particular technologies and an inadequate representation of real-world policies and processes such as innovation and behaviour change. The paper then reviews the proposals and actions that follow from these criticisms, which fall into three broad categories: scrap the models and use other techniques to set out low-carbon futures; transform them by improving their representation of real-world processes and their transparency; and supplement them with other models and approaches. The article considers the implications of each proposal, through the particular lens of how it would explore the role of a key low-carbon technology—bioenergy with carbon capture and storage (BECCS), to produce net negative emissions. The paper concludes that IAMs remain critically important in mitigation pathways analysis, because they can encompass a large number of technologies and policies in a consistent framework, but that they should increasingly be supplemented with other models and analytical approaches. [ABSTRACT FROM AUTHOR]