Search

The nature of mass transport in plants has recently inspired the development of low-cost and sustainable wood-based electronics. Herein, we report a wood electrochemical transistor (WECT) where all three electrodes are fully made of conductive wood (CW). The CW is prepared using a two-step strategy of wood delignification followed by wood amalgamation with a mixed electron-ion conducting polymer, poly(3,4-ethylenedioxythiophene)-polystyrene sulfonate (PEDOT:PSS). The modified wood has an electrical conductivity of up to 69 Sm-1 induced by the formation of PEDOT:PSS microstructures inside the wood 3D scaffold. CW is then used to fabricate the WECT, which is capable of modulating an electrical current in a porous and thick transistor channel (1 mm) with an on/off ratio of 50. The device shows a good response to gate voltage modulation and exhibits dynamic switching properties similar to those of an organic electrochemical transistor. This wood-based device and the proposed working principle demonstrate the possibility to incorporate active electronic functionality into the wood, suggesting different types of bio-based electronic devices. [ABSTRACT FROM AUTHOR]

To address the rising need of sustainable solutions in electronic devices, the development of electronically conductive composites based on lightweight but mechanically strong wood structures is highly desirable. Here, a facile approach for the fabrication of highly conductive wood/polypyrrole composites through top‐down modification of native lignin followed by polymerization of pyrrole in wood cell wall. By sodium sulfite treatment under neutral condition, sulfonated wood veneers with increased porosity but well‐preserved cell wall structure containing native lignin and lignosulfonates are obtained. The wood structure has a content of sulfonic groups up to 343 µmol g−1 owing to in situ sulfonated lignin which facilitates subsequent oxidative polymerization of pyrrole, achieving a weight gain of polypyrrole as high as 35 wt%. The lignosulfonates in the wood structure act as dopant and stabilizer for the synthesized polypyrrole. The composite reaches a high conductivity of 186 S m−1 and a specific pseudocapacitance of 1.71 F cm−2 at the current density of 8.0 mA cm−2. These results indicate that tailoring the wood/polymer interface in the cell wall and activating the redox activity of native lignin by sulfonation are important strategies for the fabrication of porous and lightweight wood/conductive polymer composites with potential for sustainable energy applications. [ABSTRACT FROM AUTHOR]