Search

The generation of abrasive particles is an unavoidable consequence of sliding electrical contact wear in conductive slip rings (SRs). The adhesion of abrasive particles to the insulators may lead to a decrease in flashover voltage, posing a risk to satellite power transmission. In this paper, the effect of abrasive particles on flashover is first studied. Surface abrasive particles can distort the surface electric field of the dielectric, absorb scattered electrons, and then re-emit them, thereby accelerating the development and formation of secondary electron avalanches. Flashover test results indicate that surface abrasive particles lead to a significant reduction in flashover voltage. To mitigate the impact of particle adhesion on flashover, a method of constructing particle traps on the surface of insulators is proposed. The location and structural parameters of the particle trap are further optimized and determined. The flashover test results using planar dielectric samples and SR insulator samples both demonstrate that the optimized particle trap can significantly improve the flashover voltage. The dielectric maintains high electrical strength even when particles are trapped in particle traps. The physical details of the impact of particles on flashover and the effect of particle traps are analyzed utilizing an electron movement simulation, corroborating the experiment from a microscopic aspect. [ABSTRACT FROM AUTHOR]

Frequency Domain Spectroscopy (FDS) is a powerful tool to study the dielectric properties of oil-paper insulation, which is widely used under high electric field strength. The motion of charge carriers under high electric field strength will cause new dielectric characteristics in FDS curves, from which more information could be extracted for insulation state assessment. In this paper, FD spectra are measured under high electric field strength. The electric field dependence of the loss peak in middle frequency and the characteristics of dielectric loss in low frequency are studied. With the influence of trapping on the motion of charge carriers under electric field being considered, charge carriers hopping polarization model and charge carriers motion dependent conductance model are proposed. The trap energy level of oil-paper insulation decreases when the moisture content increases, thus, the motion characteristics of charge carriers change, leading to decreasing loss peak in middle frequency and inverse dielectric loss characteristics in low frequency. These two models introduce the influence of traps on carrier motion into the dielectric response and enable one to gain a better understanding of the dielectric properties of oil-paper insulation under high electric field strength. [ABSTRACT FROM AUTHOR]

Plasma bullet is the formation and propagation of a guided ionization wave (streamer), normally generated in atmospheric pressure plasma jet (APPJ). In most cases, only an ionization front produces in a dielectric tube. The present study shows that two or three ionization fronts can be generated in a single quartz tube by using a microwave coaxial resonator. The argon APPJ plumes with a maximum length of 170 mm can be driven by continuous microwaves or microwave pulses. When the input power is higher than 90 W, two or three ionization fronts propagate independently at first; thereafter, they confluence to form a central plasma jet plume. On the other hand, the plasma bullets move independently as the lower input power is applied. For pulsed microwave discharges, the discharge images captured by a fast camera show the ionization process in detail. Another interesting finding is that the strongest lightening plasma jet plumes always appear at the shrinking phase. Both the discharge images and electromagnetic simulations suggest that the confluence or independent propagation of plasma bullets is resonantly excited by the local enhanced electric fields, in terms of wave modes of traveling surface plasmon polaritons. [ABSTRACT FROM AUTHOR]

Electric assisted combustion for hydrogen enriched hydrocarbons may even extend the lean burn limit and provide the further improvement on combustion stability. This study investigates the effect of hydrogen enrichment and DC electric field on lean CH 4 /air flame propagation. Electric field inside the chamber was generated by mesh and needle electrodes. Effect of hydrogen enrichment on the ion mole fraction in the flame was discussed based on reaction mechanism included neutral and ion reactions. The flame propagation images, flame displacement speed were used to evaluate the combined influences of hydrogen enrichment and electric field on propagating flame. Results showed that the hydrogen addition would increase positive ions mole fraction and the peak value is mainly determined by H 3 O+. This would be due to that CH increases with hydrogen fraction, which is the main species in the initial reaction for the ion reactions. Electric field effect about flame propagation was suppressed with hydrogen addition due to the competition between the increment in ion mole fraction and the decrement in flame time. Electric assisted combustion is more evident at leaner conditions and elevated pressure. The ratio of ionic wind velocity to flow velocity may be the determined factor to predict the electric field effect about propagating flame. The tendency based on this ratio is in accordance with the experimental results for various hydrogen fraction and equivalence ratio at elevated pressure. • Hydrogen enrichment combined with electric assisted combustion was studied at elevated pressure. • Electric assisted combustion will be suppressed with hydrogen addition. • Electric assisted combustion will be more efficient at elevated pressure. • Ratio of ionic wind velocity to flow velocity may be the determined factor of electric assisted combustion. [ABSTRACT FROM AUTHOR]

In this work, samples of oil-immersed paper with different moisture levels and aging condition were studied. Frequency domain spectroscopy (FDS) of the samples was examined at 40 °C under different excitation voltages. A non-linear phenomenon in frequency domain dielectric response with different moisture contents and aging condition was observed. The non-linear phenomenon appears to be related to the hindrance effect of cellulose on the movement of ions and the Poole-Frenkel effect on the concentration of ions. With aging, the nonlinear loss peaks at different frequencies caused by the effect of nonlinear conductance and interface polarization appear in the FDS results. The non-linear phenomenon was modeled and verified experimentally. The characteristic parameters and quantitative method to estimate moisture content and the degree of aging degree of oil-immersed paper can be obtained by the proposed method. [ABSTRACT FROM AUTHOR]