Search

Measurements of the phase velocity of compressional sound waves in water-saturated granular materials are reported for the 1.0–2.0 MHz frequency range. The sound speed estimates are based on travel times through granular layer thicknesses ranging from 8 to 17 mm. Three types of granular media were used: 336 μm median diameter glass beads and two natural sands with median diameters of 219 and 406 μm. These grain sizes and frequency range correspond to 0.5 < k a < 1.2 , where k is the wavenumber and a the grain radius. To remove trapped air, the samples were boiled under pressure before transfer to the measurement tank. The results are compared to previously reported experimental results and to the Schwartz and Plona [J. Appl. Phys. 55(11), 3971–3977 (1984)] multiple scattering prediction, confirming negative dispersion for ka > 0.5. Scaling the data by a factor depending on porosity and grain density reduces the spread among the available phase speed estimates by nearly a factor of 2, from 12.5% to 6.9%. [ABSTRACT FROM AUTHOR]

Attenuation and group speed measurements are reported for water-saturated granular materials (natural sand and glass beads) at frequencies of 1.0 to 1.8 MHz. Median grain diameters were 219 to 497 μm, corresponding to k d ≳ 1 , i.e., the scattering regime. The measurements were made for different thicknesses of sediment resting on a reflective surface using a monostatic geometry. The attenuation estimates compare well with previously reported experimental results and to the predictions of multiple scattering theory, confirming in particular the tendency toward f4 dependence for k d ≳ 1. Group speed estimates exhibit the negative dispersion predicted by theory and are comparable in magnitude to previously reported measurements made using transmission geometries. It is found that the available data exhibit a O(10)% spread among the sound speed measurements at a given kd value, and that this spread is reduced to 2.2% when the data are scaled by a factor dependent on porosity and grain density, and that essentially all of the reduction can be attributed to differences in porosity. [ABSTRACT FROM AUTHOR]