Search

A paper-based membrane coated by graphitic carbon nitride (g-C3N4) is prepared via a dip-coating method and used as a separator for sodium metal batteries with merits of low cost and environment-friendliness. Introduction of g-C3N4 effectively improves the ionic conductivity and the structural stability of the separator. Compared with traditional polyethylene separators and Al2O3-coated separators, the g-C3N4-coated separators show better electrolyte wettability, thermal stability, and electrochemical stability. Therefore, Na||Na3V2(PO4)3 battery using the g-C3N4-coated separator exhibits better cycling stability and higher rate capability. These results prove that the g-C3N4-coated paper-based separator is expected to become the next generation of low-cost and high-safety separator in sodium metal batteries. [ABSTRACT FROM AUTHOR]

A paper-supported inorganic composite (PIC) separator is prepared by spraying Al 2 O 3 particles onto both surfaces of a commercial paper substrate. The as-prepared PIC separator shows excellent thermal stability without any shrinkage at 130 °C for 30 min, superior wettability towards the electrolyte, with a contact angle of 0°, and high ionic conductivity compared with that of the conventional polyethylene (PE) separator. The graphite|LiCoO 2 full-cells with the PIC separator exhibit good cycling and rate performance. In the nail penetration tests, the pouch cell assembled with the PIC separator shows high safety characteristics. Given the advantages of the PIC separator, it is a good potential replacement for the polyolefin separators used in high-safety lithium-ion batteries. [ABSTRACT FROM AUTHOR]

Current methods of monitoring breathing require cumbersome, inconvenient, and often expensive devices; this requirement sets practical limitations on the frequency and duration of measurements. This article describes a paper-based moisture sensor that uses the hygroscopic character of paper (i.e. the ability of paper to adsorb water reversibly from the surrounding environment) to measure patterns and rate of respiration by converting the changes in humidity caused by cycles of inhalation and exhalation to electrical signals. The changing level of humidity that occurs in a cycle causes a corresponding change in the ionic conductivity of the sensor, which can be measured electrically. By combining the paper sensor with conventional electronics, data concerning respiration can be transmitted to a nearby smartphone or tablet computer for post-processing, and subsequently to a cloud server. This means of sensing provides a new, practical method of recording and analyzing patterns of breathing. [ABSTRACT FROM AUTHOR]