Search

The effect of external nozzle geometry on the emission of screech tones was studied experimentally. Four conical reflector surfaces, with half-angles ranging from 60° to 90°, were installed around the exit of a round convergent nozzle. The investigation focused on two closely spaced fully-expanded Mach numbers, M j = 1.32 and 1.34. The acoustic far-field was surveyed by a microphone phased array that included a continuously-scanning microphone, the latter enabling high spatial resolution. The isolated jets contained well-known screech mode B and its harmonics. Addition of the reflectors caused significant changes in the modal emission pattern, with tones traditionally linked to mode C occurring at M j = 1.34 but not at M j = 1.32. Tonal components associated with new modes E and F emerge at both Mach numbers when the cone half-angle is 60° or 70°. The noise source distribution generally elongates with decreasing cone angle. Some modes show clear scattering from the reflectors, while others do not. The study underscores the complexity that initial conditions can impart on the modal structure of screech and demonstrates the capability of the continuous-scan beamforming technique in resolving fine features of the source. [ABSTRACT FROM AUTHOR]

This study is motivated by the need for physical models for the jet noise source to be used in practical noise prediction schemes for propulsion–airframe integration concepts. The basis for the source model is an amplitude-modulated traveling wave—the wavepacket. The source is parameterized and the parameters are determined by minimizing the difference between the modeled and experimental sound intensity distributions in the far field. Even though the pressure signal that reaches the far field is highly filtered, sufficient information is available to construct a wavepacket with reasonable physical characteristics. A simple stochastic extension of this concept shows a connection between the shape of the far-field sound pressure level spectrum and the emission polar angle. It suggests that the broadening of the spectrum with increasing polar angle from the downstream axis can be explained on the basis of a single noise source (the wavepacket), rather than the prevailing model of two distinct noise sources, one coherent and the other incoherent. [ABSTRACT FROM AUTHOR]

The paper presents a low-order prediction scheme for the noise change in multistream jets when the nozzle geometry is altered from a known baseline. The essence of the model is to predict the changes in acoustics due to the redistribution of the mean flow as computed by a Reynolds-averaged Navier–Stokes (RANS) solver. A RANS-based acoustic analogy framework is developed that addresses the noise in the polar direction of peak emission and uses the Reynolds stress as a time-averaged representation of the action of the coherent turbulent structures. The framework preserves the simplicity of the Lighthill acoustic analogy, using the free-space Green’s function, while accounting for azimuthal effects via special forms for the space–time correlation combined with source–observer relations based on the Reynolds stress distribution in the jet plume. Results are presented for three-stream jets with offset secondary and tertiary flows that reduce noise in specific azimuthal directions. The model reproduces well the experimental noise reduction trends. Principal mechanisms of noise reduction are elucidated. [ABSTRACT FROM AUTHOR]

The paper presents guidelines for the optimal treatment of signals from microphone arrays that include continuously-scanning sensors. The signals from the scanning sensors are non-stationary due to the time-varying source-sensor distance and the traversing of an acoustic field with spatially-varying statistics. Quasi-stationarity has been sought in past studies by dividing the signals into blocks and applying a frequency-dependent window within each block. Optimal schedules versus frequency for block size and block overlap are proposed that enhance the spatial resolution while containing the computational cost. The guidelines are applied to the acoustic fields emitted by an impinging-jets source and a subsonic turbulent jet in isolation and integrated with a shielding plate. The noise source distributions are obtained through a direct spectral estimation approach in which the error between the modeled and measured far-field statistics is minimized. The ability of the continuous-scan paradigm, coupled with the proposed treatment of the signal, to provide high-definition noise source maps is demonstrated. • Overview of a direct spectral estimation method for acoustic source location. • Signal processing guidelines for continuous-scan phased microphone arrays. • High-resolution noise source maps of an impinging-jets rig. • High-resolution noise source maps of a subsonic jet. • Effect of a shielding plate on the noise emitted by a subsonic jet. • Far-field acoustic surveys of impinging-jets rig and subsonic jet. [ABSTRACT FROM AUTHOR]