Search

Ultrahigh-speed magnetization switching mechanism is strongly pursued, as it can improve the write performance of the magnetic random access memory (MRAM) and further extend the application area of spintronics. Currently, a well-studied switching mechanism is the spin transfer torque (STT), whose speed, however, is limited by an intrinsic incubation delay. Recently, spin–orbit torque (SOT) was proposed to solve the speed bottleneck of the STT. In this paper, we evaluate the potential of two types of SOT-MRAMs, whose data can be ultrafast written based on the recently discovered field-free SOT mechanisms, respectively. A cross-layer analysis is presented involving device modeling, circuit-level optimization, and architecture-level evaluation. First, the principle of the magnetization switching is analyzed with the macrospin simulation. Then, the optimization strategies at the circuit level are generalized through the SPICE-type simulation. Finally, we build up the memory architecture with the SOT-MRAMs, STT-MRAM, and static RAM. Their read/write performances are evaluated with NVSim software. It is demonstrated that one of the studied SOT-MRAMs shows the promising prospect in the non-volatile memory, especially suitable for high-capacity cache. [ABSTRACT FROM AUTHOR]

Spin-transfer torque magnetic random access memory (STT-MRAM) has emerged as a promising candidate for the next-generation high-speed, low-power, and scalable nonvolatile memory technology. Its advantageous features have attracted much attention in the area of research and development, and a number of preindustrial prototypes and small-scale products have been demonstrated. One expects to widely commercialize it in the next few years. One of the critical issues that blocks STT-MRAM’s wide commercialization is its low sensing reliability due to the relatively small tunnel magnetoresistance ratio of the magnetic tunnel junction (MTJ) and the continuously increasing process variations, especially as technology process scales down to the deep submicrometer nodes (e.g., 40 nm). In this paper, we present a variation-tolerant high-reliability sensing circuit for deep submicrometer STT-MRAM. This circuit, using triple-stage sensing and charge transfer amplification, is able to tolerate significantly the process variations and improve greatly the sensing margin by sacrificing some sensing time. Using a CMOS 40 nm design kit and a precise STT-MTJ compact model, transient and Monte Carlo simulations have been carried out to demonstrate its sensing performance. [ABSTRACT FROM AUTHOR]

With the process node further scaling down, the bit cell of magnetic random access memory (MRAM) device suffers from severe failure and reliability problems due to its process variation. In this article, we explored the variability of a promising toggle spin torques MRAM (TST-MRAM) in detail, which achieves ultrafast switching speed and high endurance and is expected to be applied as upper-level caches. Our research is conducted with a 14 nm FinFET design kit, the basic performance of TST-MRAM and different pulse conditions are explored, and then the variation effect of device parameters is discussed and compared in detail as well as the write error rate (WER) under different voltages. The results demonstrate that the variation of access transistors dominates the variability, where the transistor in the spin–orbit torque (SOT) branch has a greater negative impact than the transistor in the spin transfer torque (STT) branch. To further reduce WER, a better structure with diodes of bit cell is proposed. [ABSTRACT FROM AUTHOR]