Search

This study continues the discussion on the surface modification of polymers using an atmospheric pressure plasma (APP) reactor in air. These results complement prior research focusing on nonpolar polymers. Polymers, such as polyethylene terephthalate, polyetheretherketone, and polymethyl methacrylate, containing structurally bonded oxygen are studied, representing a range of properties such as oxygen content, crystalline/amorphous structure, polarity, functionality, and aliphatic/aromatic structure. APP induces superior wetting properties on the hydrophilic polymer surfaces with rapid and uniform modification within 0.5 s of exposure. The amorphous structures undergo additional modification for longer exposure. Moreover, the aliphatic chain structures require longer plasma exposure to reach surface modification equilibrium. The polar polymers reach a limit level of modification corresponding to a minimum water contact angle of about 50°. The surface polarity increases on average by a factor of approximately two. The equilibrium values of the adhesion work attained after post-processing recovery fall within a limited range of about 100–120 mJ/m2. The enhancement of surface functionality through the creation of oxidized groups primarily depends on the initial oxygen content and reaches a limit of about 40 at.% oxygen. The surface properties of the treated polar surfaces exhibit good stability, comparable to that of the previously tested nonpolar polymers. [ABSTRACT FROM AUTHOR]

The research aims towards a novel methodology of ZnO impregnation onto polyamide supports, in order to attain a special inorganic-organic hybrid polymer material, with increased UV-barrier attributes and high hydrophobicity. The experimental approach employed ZnO micro particles powder. Solutions with different concentrations of ZnO powder dispersed in methanol are prepared as anti-UV finishing agent and applied onto polyamide fabric. The responsive behaviour of this complex polymer network to UV irradiation, the photo protective performance and its time stability, also the hydrophobic character are assessed by different characterization techniques. The proposed method has advantages, like: easy standardization, at lower production cost, resulting a high homogeneity and dispersion of ZnO micro particles into the textile polymeric network. The covered polymeric supports show better photo protective response, higher hydrophobicity and control on the surface charge induced by irradiation. This method granted enhanced quality, comfort and long term stability of the intelligent/smart garments.