Search

Multimode near-stoichiometric (NS) Ti:LiNbO3 planar waveguide was fabricated by Ti-diffusion followed by post-Li-rich vapor transport equilibration. The crystalline phase, composition and guided modes in the planar waveguide were characterized. The refractive index profile in the waveguide is constructed from the measured mode indices using the inverse Wentzel–Krames–Brillouin method and correlated with the Ti profile obtained from secondary ion mass spectroscopy analysis. The results show that the LiNbO3 phase dominates in the waveguide layer and the waveguide has an NS composition. The index increase has a linear relation to Ti-concentration for both cases of ordinary and extraordinary rays, and the relationship is considerably different from those of some congruent or NS bulk materials or waveguides. A comparison of various congruent and NS bulk materials or waveguides allows to conclude that the relationship changes from congruent to NS composition, from one fabrication method to another and from bulk material to waveguide configuration. [ABSTRACT FROM PUBLISHER]

Zr4+/Ti4+-codoped LiNbO3 plates were prepared by local codiffusion of stacked ZrO2 and Ti metal films coated onto Z-cut congruent LiNbO3 substrates in wet O2 at 1060°C. The metal and oxide films have different thicknesses and coating sequences. After diffusion, the Zr4+ doping effect on the refractive index of LiNbO3 and the Li2O out-diffusion issue were studied by the prism coupling technique. The codiffusion characteristics of Zr4+ and Ti4+ were studied by secondary ion mass spectrometry. The results show that the Zr4+ doping has little contribution to the refractive index of the crystal. Li2O out-diffusion is not measurable. In the Zr4+-only diffusion case, the diffusivity of Zr4+ is four times smaller than that of Ti4+. In the Zr4+/Ti4+ codiffusion case, the Ti4+ codiffusion assists the Zr4+ diffusion. The Zr4+ diffusivity increases linearly by two more times with the increase in initial Ti film thickness from 0 to 200 nm. On the other hand, the Zr4+ affects the Ti4+ diffusion little. Neither the ZrO2 film thickness nor the coating sequence of Ti metal and ZrO2 oxide films influences the diffusivity of the two ions. All the codiffusion characteristics are explained. A Zr4+/Ti4+ codiffusion model is suggested that consists of two independent diffusion equations with a Zr4+ diffusivity dependent of Ti4+ concentration and a constant Ti4+ diffusivity. In addition, the existence of a waveguide in the Zr4+/Ti4+-codoped layer is verified experimentally, and the optical-damage-resistant feature of the waveguide is verified by two-beam hologram recording experimental results. [ABSTRACT FROM AUTHOR]

Multi-mode Ti:LiNbO 3 planar waveguide was fabricated by in-diffusion of 100-nm-thick Ti-metal film coated onto a near-stoichiometric LiNbO 3 substrate prepared by vapor transport equilibration. The crystalline phase and composition in the waveguide were characterized. The guided modes in the planar waveguide were characterized by prism coupling technique. The refractive index profile is constructed from the measured mode indices using the inverse Wentzel–Krames–Brillouin method, and correlated with the Ti 4+ - concentration profile, which was obtained from secondary-ion-mass-spectroscopy analysis. The results show that the waveguide still retains the LiNbO 3 phase, its composition is near-stoichiometric. The index change and Ti 4+ -concentration follow an exponential relationship with a power index 0.4 for an ordinary ray and 1.07 for an extraordinary ray. A comparison of various congruent and near-stoichiometric bulk materials or waveguides allows to conclude that the relationship is different from congruent to near-stoichiometric composition, from one fabrication method to another, and from bulk material to waveguide configuration. The difference is explained qualitatively. [ABSTRACT FROM AUTHOR]

Diffusion-doping is an effective, practical method to improve material properties and widen material application. Here, we demonstrate a new physical phenomenon: diffusion control of an ion by another in LiNbO3 and LiTaO3 crystals. We exemplify Ti4+/Xn+ (Xn+ = Sc3+, Zr4+, Er3+) co-diffusion in the widely studied LiNbO3 and LiTaO3 crystals. Some Ti4+/Xn+-co-doped LiNbO3 and LiTaO3 plates were prepared by co-diffusion of stacked Ti-metal and Er-metal (Sc2O3 or ZrO2) films coated onto LiNbO3 or LiTaO3 substrates. The Ti4+/Xn+-co-diffusion characteristics were studied by secondary ion mass spectrometry. In the Xn+-only diffusion case, the Xn+ diffuses considerably slower than the Ti4+. In the Ti4+/Xn+ co-diffusion case, the faster Ti4+ controls the diffusion of the slower Xn+. The Xn+ diffusivity increases linearly with the initial Ti-metal thickness and the increase depends on the Xn+ species. The phenomenon is ascribed to the generation of additional defects induced by the diffusion of faster Ti4+ ions, which favors and assists the subsequent diffusion of slower Xn+ ion. For the diffusion system studied here, it can be utilized to substantially shorten device fabrication period, improve device performance and produce new materials. [ABSTRACT FROM AUTHOR]