Search

Background: The company Ethnocare has developed the Overlay, a new pneumatic solution for managing volumetric variations (VVs) of the residual limb (RL) in transtibial amputees (TTAs), which improves socket fitting. However, the impact of the Overlay during functional tasks and on the comfort and pain felt in the RL is unknown. Methods: 8 TTAs participated in two evaluations, separated by two weeks. We measured compensatory strategies (CS) using spatio-temporal parameters and three-dimensional lower limb kinematics and kinetics during gait and sit-to-stand (STS) tasks. During each visit, the participant carried out our protocol while wearing the Overlay and prosthetic folds (PFs), the most common solution to VV. Between each task, comfort and pain felt were assessed using visual analog scales. Results: While walking, the cadence with the Overlay was 105 steps/min, while it was 101 steps/min with PFs (p = 0.021). During 35% and 55% of the STS cycle, less hip flexion was observed while wearing the Overlay compared to PFs (p = 0.004). We found asymmetry coefficients of 13.9% with the Overlay and 17% with PFs during the STS (p = 0.016) task. Pain (p = 0.031), comfort (p = 0.017), and satisfaction (p = 0.041) were better with the Overlay during the second visit. Conclusion: The Overlay's impact is similar to PFs' but provides less pain and better comfort. [ABSTRACT FROM AUTHOR]

Inertial measurement units and normative values enable clinicians to quantify clinical walking tests and set rehabilitation goals. Objectives of this study were (1) to compare time- and distance-based walking tests in individuals with lower limb amputation (iLLA) and normative values following rehabilitation discharge (T1) and 6 weeks after discharge (T2) and (2) to investigate spatiotemporal and foot kinematic parameters over a 6-minute walk test using inertial measurement units. Twelve iLLA participated in this study. Distance, cadence, stance ratio, loading rate ratio, push-up ratio, path length, and minimum toe clearance were analyzed during 6-minute walk test. Nonparametric repeated-measures analysis of variance tests, Bonferroni corrections, were performed. Time of distance-based walking tests diminished at T2 (P < .02). Compared with normative values, walking performance in iLLA was reduced. Cadence at T2 increased significantly (P = .026). Stance ratio increased in both legs at T2 (P < .05). Push-up ratio tended to decrease at T2 in the amputated leg (P = .0003). Variability of path length and minimum toe clearance at T2 were less than at T1 in the nonamputated leg (P < .05). Spatiotemporal improvement at T2 could be due to prosthesis adaptation in iLLA. The lower performance of the functional walk test compared with normative values could be due to amputation and pain-related fatigue. [ABSTRACT FROM AUTHOR]

Diabetes peripheral neuropathy (DPN) leads to balance impairment among diabetes mellitus (DM). The aims of this study were to (1) distinguish between DM patients who have/do not have DPN and to (2) compare quadriceps' strength and balance performance of DM, DPN, and healthy groups. Fifteen healthy females and 33 females with type 2 diabetic patients participated. The electrodiagnostic method was used to classify diabetic patients into DM and DPN. A dynamometer was used to measure quadriceps' strength. Single-leg standing on a force plate was also used to quantify participants' balance. Smaller conduction velocity and amplitude and greater distal latency of all nerves were observed in the DPN compared with the DM in particular for sensory nerve. In DPN, conduction velocity was asymmetrical. The quadriceps' strength of both legs in DPN and the right leg in DMwas smaller than in the control group. The root mean square of the center of pressure was similar between DMand DPN. But it was larger in DPN than in the control group. DPN is associated with asymmetrical conduction velocity, smaller quadriceps' strength, and weaker balance performance that is suggestive of higher risk of falling. Balance training is recommended for the DPN group during their rehabilitation to reduce their falling risk. [ABSTRACT FROM AUTHOR]

Background: The International Committee of the Red Cross supports a worldwide program of prosthetic fitting and rehabilitation. In this context, a prosthetic foot was developed and widely distributed in least developed countries.Study Design: Prospective, randomized, double-blind, controlled study.Objective: To compare patient satisfaction and energy expenditure during ambulation between a low-cost prosthetic foot designed with a polypropylene keel (CR-Equipements™ solid ankle cushion heel, International Committee of the Red Cross) to a well-recognized solid ankle cushion heel foot with a wooden keel (solid ankle cushion heel foot, Otto Bock).Methods: A total of 15 participants with unilateral transtibial amputation were evaluated using the two prosthetic feet in a randomized prospective double-blind crossover study. Main outcomes were patient satisfaction questionnaires (Satisfaction with Prosthesis Questionnaire and prosthetic foot satisfaction) and energy expenditure (oxygen consumption-mL/kg/min, oxygen cost-mL/kg/m, and heart rate-bpm).Results: There were no significant differences between the two prosthetic feet for satisfaction and energy expenditure.Conclusion: The low-cost solid ankle cushion heel foot with polypropylene keel provides comparable satisfaction and similar energy expenditure as the solid ankle cushion heel foot with wooden keel. Clinical relevance The results of this study support the application and widespread use of the CR-Equipements™ solid ankle cushion heel foot. From a cost-effectiveness standpoint, patients are well satisfied and exhibit similar outcomes at a substantially lower cost. [ABSTRACT FROM AUTHOR]

Anatomical knee joint features and osteoarthritis (OA) severity are associated, however confirming causals link to altered knee loading is challenging. This study leverages statistical shape models (SSM) to investigate the relationship between joint shape/alignment and knee loading during gait in knee OA (KOA) patients to understand their contribution to elevated medial knee loading in OA. Musculoskeletal (MSK) models were created for the mean as well as the first eight SSM principal modes of variation (−3,−2,−1, +1, +2, +3 standard deviations for each mode) and used as input to a MSK modeling framework. Using an identical KOA gait pattern (i.e., joint kinematics and ground reaction forces), we ran simulations for each MSK model and evaluated medial compartment loading magnitude and contact distribution at the instant of first and second peak of knee joint loading. An increase in external rotation, posterior tibia translation and a decrease in medial joint space and medial femoral condylar size predisposed the medial compartment knee joint to overloading during gait. This was coupled with an anterior and medial shift in contact location with increasing external rotated tibial position and increasing posterior tibial translation with respect to the femur. Next, results also highlighted a posterior shift of the medial compartment loading location with decreasing medial joint space. This study provides important population‐based insights on how knee shape and alignment predispose individuals with KOA to elevated medial compartmental knee loading. This information can be crucial in assessing the risk for medial KOA development and progression. [ABSTRACT FROM AUTHOR]

Background: The International Committee of the Red Cross supports a worldwide program of prosthetic fitting and rehabilitation. In this context, a prosthetic foot was developed and widely distributed in least developed countries., Study Design: Prospective, randomized, double-blind, controlled study., Objective: To compare patient satisfaction and energy expenditure during ambulation between a low-cost prosthetic foot designed with a polypropylene keel (CR-Equipements ™ solid ankle cushion heel, International Committee of the Red Cross) to a well-recognized solid ankle cushion heel foot with a wooden keel (solid ankle cushion heel foot, Otto Bock)., Methods: A total of 15 participants with unilateral transtibial amputation were evaluated using the two prosthetic feet in a randomized prospective double-blind crossover study. Main outcomes were patient satisfaction questionnaires (Satisfaction with Prosthesis Questionnaire and prosthetic foot satisfaction) and energy expenditure (oxygen consumption-mL/kg/min, oxygen cost-mL/kg/m, and heart rate-bpm)., Results: There were no significant differences between the two prosthetic feet for satisfaction and energy expenditure., Conclusion: The low-cost solid ankle cushion heel foot with polypropylene keel provides comparable satisfaction and similar energy expenditure as the solid ankle cushion heel foot with wooden keel. Clinical relevance The results of this study support the application and widespread use of the CR-Equipements ™ solid ankle cushion heel foot. From a cost-effectiveness standpoint, patients are well satisfied and exhibit similar outcomes at a substantially lower cost.