Search

The dynamic mechanisms of self-ignition and flame propagation during high-pressure hydrogen release through a rectangular tube were experimentally investigated using pressure records, flame detection and high-speed photographs. Experimental results show that the minimum burst pressure for self-ignition decreases with an increase in axial distance to the diaphragm and then remains at an almost constant value. The self-ignition onset at the same location of the tube exhibits a certain randomness even if the intensity of the shock wave produced in the tube is similar. Multiple ignitions were observed at the early stage of hydrogen release. They usually had difficulty to sustainably develop and were extinguished owing to oxygen deficiency. At a subsequent stage, the ignition kernel appears again and grows rapidly in the axial and radial directions, finally converging to a complete flame across the tube width. It was found that the radial growth rate of the flame was lower than the axial growth rate. [ABSTRACT FROM AUTHOR]

In this study, an experimental investigation is conducted to study the effects of CO addition (0%–7.5% vol.) on the self-ignition of pressurized hydrogen leakage. The result shows that more CO addition significantly decreases the likelihood of self-ignition inside the tube and the formation of self-sustained jet flame outside the tube. This can be mostly explained by the reduction of leading shock intensity inside the tube. Furthermore, CO addition effectively inhibits the flame propagation and development inside the tube. For pure hydrogen, the ignited flame quickly develops an intense flame spanning the tube width and eventually form a jet flame in ambient air. However, the H 2 –CO diffusion flame initiated approaching tube sidewall tends to propagate adjacent to the wall or be soon quenched with more CO addition. If the CO-weakened flame spouts to the tube exit, it may not survive the expansion at the tube exit and thus it is quenched. • The shock intensity is reduced in the presence of CO. • The critical pressure for self-ignition increases with CO addition concentration. • Shock intensity variation by CO addition is the main factor affecting self-ignition onset. • Small CO addition can effectively inhibit flame development inside the tube. • H 2 –CO flame spouting from the tube exit tends to be blown out. [ABSTRACT FROM AUTHOR]

This paper studies the effects of triangle obstacles inside the tube on the ignition mechanism and subsequent flame development in a semi-confined space when high-pressure hydrogen sudden release. Smooth tube and obstructed tube with optical glasses are constructed where controlled high-pressure hydrogen are released. High-speed direct photography is used to image the flame evolution while pressure transducers are used to obtain pressure-time traces both inside the tube and exhaust chamber. These cases that hydrogen with various burst pressure jets into the smooth and obstructed tubes are tested. It is found that spontaneous ignition occurs in the boundary layer of the tube in the smooth tube, a complete fire spanning the cross-section is reached as the flame propagates within the mixing region. The appearance of obstacles is found to have a significant effect on the ignition mechanism and flame structure. A two-way dissemination reflected shock wave forms and three possible ignition region emerges surrounding the obstacles. The flame propagation restricted between the leading shock wave and hydrogen jet. The flame experiences a split that the front flame in the vicinity of the obstacle gradually dies out and the rear flame continues propagating within the mixing region. The flame evolution and pressure variation in the exhaust chamber show that obstacles inside the tube do not aggravate the disaster in the semi-confined chamber. [ABSTRACT FROM AUTHOR]

• The strength of shock wave is different before and after obstacles. • Obstacles decrease the minimum burst pressure and self-ignition occurs around obstacles. • Mechanism of self-ignition is different before and after obstacles. • Obstacles before the initial ignition location significantly accelerates initial self-ignition. The safe application of hydrogen has attracted increased attention. In particular, fire and explosion disasters may be induced by self-ignition during high-pressure hydrogen leakage. This study experimentally investigates the effect of obstacles on initial self-ignition when high-pressure hydrogen is suddenly released. High-pressure hydrogen release experiments are performed at burst pressures of 2–8 MPa. The hydrogen flame inside the tube is captured by a high-speed video camera and light sensors, and shock wave variations are measured by pressure transducers. The results show that the presence of obstacles inside the tube significantly affects shock wave flow. It is found in this study that obstacles decrease the minimum burst pressure needed for self-ignition and self-ignition is prone to occur in the vicinity of obstacles. The influence of obstacles on the initial ignition process are different at different self-ignition locations. On the one hand, the reflected shock wave originating from obstacles is the main reason for the promotion of self-ignition upstream of obstacles. On the other hand, the formation of a hydrogen/air mixture under the effect of turbulent flow and multi-dimensional shock waves leads to self-ignition downstream of obstacles. Meanwhile, the presence of obstacles before the initial ignition location (L in) shortens the distance between the ignition location and the burst disk and significantly accelerates the occurrence of initial self-ignition. Obstacles participate in the self-ignition process earlier when they are placed closer to the burst disk. However, obstacles after the initial ignition location (L in) show no effect on the initial ignition process. The results can guide the safe use of high-pressure hydrogen. [ABSTRACT FROM AUTHOR]

Due to the high probability of hydrogen leaking from narrow cracks of the vessels, an experimental study is conducted to investigate the spontaneous ignition of high-pressure hydrogen released into a tube through inlets with different narrowness, including circular, square (length-width ratio χ = 1), and two slit shapes of χ = 2 and 3, with the same area. Pressure transducers and photoelectric sensors are used to detect shock wave dynamic variation and ignition occurrence. The results indicate that narrow inlets weaken the shock wave intensity and speed, and the weakening effect increases with narrowness. Moreover, spontaneous ignition is affected. The minimum burst pressure required for spontaneous ignition is higher in the cases with square and slit inlets. Most significantly, when χ is 3 , it is 2.5 times that of circular inlet. Meanwhile, for narrow inlets, the ignition flame intensity and speed are enhanced, and the inlet of χ = 2 has the greatest impact. • The influence of narrow releasing ports on self-ignition hydrogen is investigated. • Narrow ports weaken the shock wave intensity and speed. • It requires higher burst pressure for self-ignition under narrow ports. • The flame intensity is enhanced under narrow ports. • Different narrowness of the ports brings different effects. [ABSTRACT FROM AUTHOR]

Experiments on shock waves propagation, spontaneous ignition, and flame development during high-pressure hydrogen release through tubes with symmetrical obstacles (O 1-1) and asymmetrical obstacles (O 1-2) are conducted. The obstacle's side is triangular with a length of 4 mm, a height of 3.6 mm, and its width is 15 mm. In the experiments, a reflected shock wave generates and propagates both upstream and downstream when the leading shock wave encounters the obstacle. At the same burst pressure, the reflected shock wave intensity in tube O 1-1 is significantly greater than that in tube O 1-2. Moreover, the presence of obstacles in the tube can induce spontaneous ignition. The minimum burst pressures for spontaneous ignition for tubes O 1-1 and O 1-2 are 2.84 MPa and 3.28 MPa respectively, lower than that for the smooth tube. Furthermore, both the initial ignition position and ignition time are greatly advanced in obstruction tubes, mainly affected by obstacle positions and burst pressures. Finally, the flame separation process near the obstacle is observed. After passing the obstacle, the flames grow rapidly in radial and axial directions on the tube sidewalls. And at the same burst pressure, the flame convergence time in tube O 1-2 is usually longer than that in tube O 1-1. • The influence of obstacles arrangements on self-ignition hydrogen is investigated. • Reflected shock wave forms and propagates both upstream and downstream. • The presence of the obstacles can facilitate the occurrence of self-ignition. • Obstacles arrangements have great effects on ignition positions and ignition time. • The flame separation is observed inside both obstruction tubes. [ABSTRACT FROM AUTHOR]