Search

Minimizing the carbon footprint of the aviation industry is of critical importance for the forthcoming years, allowing the mitigation of climate change through fossil fuel economy. Significant progress toward this goal can be achieved through the aerodynamic optimization of wing surfaces. In a previous study, a custom-designed wing equipped with an Eppler 420 airfoil, including an appendant custom-designed blended winglet, was developed and studied in flight conditions. The present paper researches potential improvements to the aerodynamic behavior of this wing by attempting to regenerate the boundary layer. The main goal was to achieve passive control of the boundary layer, which would be approached by means of two different configurations. In the first case, dimples were added at the points where the separation of the boundary layer was expected, for the majority of the wing surface; in the second case, bumps of the same diameter were added at the same points. Both wings were studied in two different Reynolds (Re) numbers and five angles of attack (AoA). The computational fluid dynamics (CFD) simulations were implemented using a pressure-based solver, the spatial discretization was conducted with a second-order upwind scheme, and the k-omega SST (k-ω SST) turbulence model was applied by utilizing the pseudo-transient method. The experimental procedure was conducted in an open-type subsonic flow wind tunnel, for Reynolds 86,000, with 3D-printed models of the wings having undergone suitable surface treatment. The numerical and experimental results converged, showing a degradation in the wing's aerodynamic performance when bumps were implemented, as well as a slight improvement for the configuration with dimples. [ABSTRACT FROM AUTHOR]

This paper presents the results of an experimental study to evaluate the possibility of using SLM additive technology to produce structures with specific surface morphological features. Qualitative and quantitative tests were conducted on samples fabricated by 3D printing from titanium (Ti6Al4V)-powder-based material and analysed in direct relation to the possibility of their use in medicine for the construction of femoral stem and models with a specific degree of porosity predicted by process-control in the self-decision-making 3D printing machine. This paper presents the results of the study, limitations of the method, recommendations that should be used in the design of finished products, and design proposals to support the fabrication process of 3D printers. Furthermore, the study contains an evaluation of how the printing direction affects the formation of certain structures on the printed surface. The research can be used in the development of 3D printing standardization, particularly in the consideration of process control and surface control. [ABSTRACT FROM AUTHOR]

Passive heat exchangers (HXs) form an inseparable part of the manufacturing industry as they provide high-efficiency cooling at minimal overhead costs. Along with the aspects of high thermal cooling, it is essential to monitor pressure loss while using plate-fin HXs because pressure loss can introduce additional power costs to a system. In this paper, an experimental study was conducted to look at the effects of dimples on the pressure drop characteristics of single plate-fin heat exchangers. To enable this, different configurations of National Advisory Committee for Aeronautics (NACA) fins with smooth surfaces and 2 mm-diameter dimples, 4 mm-diameter dimples and 6 mm-diameter dimples were designed and 3D printed using fused deposition modelling (FDM) of ABS plastic. The depth to diameter ratio for these dimples was kept constant at 0.3 with varied diameters and depths. These were then tested using a subsonic wind tunnel comprised of inlet and outlet pressure taps as well as a hot wire velocimeter. Measurements were taken for pressure differences as well as average velocity. These were then used to calculate friction factor values and to compare the smooth fin to the dimpled fins in relation to their relative pressure drop performance. It was observed that for lower velocities the 4 mm dimples provided minimum pressure drop, with a difference of 58% when compared to smooth fins. At higher velocities, 6 mm dimples increased the pressure drop by approximately 34% when compared to smooth fins. It can also be concluded from the observed data in this study that shallower dimples produce lower pressure drops compared to deeper dimples when the depth to diameter ratio is kept constant. Accordingly, deeper dimples are more effective in providing drag reduction at lower velocities, whereas shallower dimples are more effective for drag reduction at higher velocities. [ABSTRACT FROM AUTHOR]