Search

Boronate affinity ligands (BALs) have gained attention for glycoproteins capture and recognition due to their unique affinity interaction with glycans. In this paper, the effect of azo immobilization of phenylboronic acid on the reduction of adsorption pH of a recombinant glycoprotein (i.e., rhEPO) on hydrogel microparticles was investigated. To evaluate the influence of intraparticle porosity on protein adsorption, microporous (MicroBead) and mesoporous (MesoBead) agarose beads carrying two levels of amine densities were functionalized with azoboronate ligand. Affinity adsorption of the glycoprotein during static and dynamic adsorptions at relatively low pHs of 8 and 7 was studied. Results revealed successful adsorption of rhEPO at pH = 8 through affinity capture of glycans by azoboronate ligands. Increased amine density provided 1.1 and 1.5 times higher static adsorption capacities and dynamic performance efficiencies, respectively. In addition, adsorption capacities and initial adsorption rates of rhEPO on MesoBeads were respectively 1.4 and 2.5–2.8 times of MicroBeads. Also, at pH = 8, MesoBeads recorded higher dynamic recoveries (59 and 91%) compared with microporous ones (46 and 69%) since mesoporosity facilitates intraparticle mass transfer. Reduction of binding pH from 8 to 7 resulted in a sharp decrease in dynamic recovery (14%), indicating the appropriate binding pH of azoPBA to be above 7. The azoboronate affinity ligand is a leading candidate for capturing glycoproteins at relatively low pH. Also, mesoporous microparticles are appropriate tools in more efficient medium-sized protein binding applications. [ABSTRACT FROM AUTHOR]

The combination of chemical and biological treatments is an efficient approach for a complete removal of emerging contaminants such as pharmaceuticals. In this study, the removal of a mixture of anti-inflammatories (naproxen and diclofenac), antibiotics (azithromycin and trimethoprim), and hormones (levonorgestrel and medroxyprogesterone) was investigated using a membrane bioreactor (MBR) coupled with an ozonation system. The results showed complete removal of selected pharmaceuticals only after 50 days of the experiment in the MBR+O3 system, while in the MBR system the average removal rate was 35%. Response surface methodology (RSM) was also utilized to statistically analyze the effects of process parameters and optimize the experimental conditions. Based on the RSM results, experiment time significantly impacted COD, BOD, and TDS removal. Also, the optimal conditions for ozonation time and ozone dose were determined to be 4 min and 5 mg/l, respectively. Based on the optimization approach achieved by RSM, the final concentrations of 44.3, 12.3, and 51.6 mg/l were obtained for COD, BOD, and TDS, respectively. [ABSTRACT FROM AUTHOR]

This study aims to investigate the effect of using Al2O3 nanoparticles (NPs) in membrane structure on the operation condition of the membrane bioreactor. To this end, alumina NPs as the high hydrophilic agents with an approximate size of 40 nm and a concentration of 0–3 wt.% were placed within the PAN polymeric membrane matrix structure with high hydrophilicity and high mechanical resistance over the others via the phase inversion method. Characterization of synthesized nanocomposite membranes was carried out by SEM analysis. In the presence of the alumina NPs, the porosity of the membranes improved. The water contact angle measurement confirmed the superior hydrophilicity of mixed PAN membranes compared to the pure polymeric membranes. The best nanocomposite membrane with better antifouling properties was selected to evaluate the MBR's performance in wastewater treatment and assessed in terms of the resistance, flux recovery, and COD removal rates. The result of a comparison with pure membrane showed that by increasing the Al2O3 amount up to 2wt.%, irreversible fouling resistance mitigated as much as 50%. Moreover, the flux recovery ratio was increased by 15%, and the COD removal rate was also raised as large as 16%. Our investigation illustrated that the presence of alumina NPs has improved the MBR performance and decreased the irreversible fouling resistance of the membrane. [ABSTRACT FROM AUTHOR]