Search

[Display omitted] • An acid–induced dispersive liquid–liquid microextraction is developed. • Analytes are extracted by in situ formation of deep eutectic solvents with formed fatty acids. • The method is successfully used for detection of bisphenol A and alkylphenols. • The method is simple, rapid, sensitive, low cost, and environmentally friendly. • The new method expands the application pathway and scope of deep eutectic solvents. This study describes the development of an acid induced dispersive liquid–liquid microextraction method based on the in situ formation of hydrophobic deep eutectic solvents for the extraction of bisphenol A and alkylphenols from environmental water and beverage samples. Hydrochloric acid altered the hydrophilic-hydrophobic state of fatty acid salts to obtain hydrophobic fatty acids, which formed hydrophobic deep eutectic solvents with analytes in situ to extract the analytes. Under optimized conditions, the limits of detection and limits of quantitation were 0.03–0.1 μg L-1 and 0.12–0.3 μg L-1, the intraday and interday relative standard deviations were less than 3.9 %, and the enrichment factor was 29–32. The recoveries of bisphenol A and alkylphenols were 95.9–104.9 % and 86.9–105.0 %, respectively. The extraction process used only hydrochloric acid and fatty acid salts, and the extraction process required less than 1 min. This method has the advantages of simplicity, speed, low cost and environmental friendliness. [ABSTRACT FROM AUTHOR]

[Display omitted] • A novel, green and environmental benign TC-AALLME-SFDES technique was developed. • Solid DES was used as extraction solvent. • The method was applied for the determination of TCS and APs from water samples. • The green profile of the method was assessed by analytical Eco-Scale and ComplexGAPI. • The method opened up the application of solid DESs in LLME technique. A novel and green microextraction technique, temperature-controlled air-assisted liquid–liquid microextraction based on the solidification of floating deep eutectic solvents (DESs), was developed and applied for the extraction of triclosan and alkylphenols in different environmental waters. Hydrophobic DESs composed of menthol and myristic acid with melting points slightly higher than room temperature (25 ± 2 °C) were prepared and used as extraction solvent. First, the solid DES was transformed into liquid DES while the aqueous sample was heated in a water bath. Then, fine droplets were formed by withdrawing and injecting the mixture of aqueous sample and DES with a 1 mL pipette several times. After extraction, the solidified DES phase was obtained in an ice water bath. And then the analyses were performed by HPLC-UV. The microextraction parameters were investigated by the Plackett-Burman design and central composite design. The analytical parameters of this method were investigated and good linear ranges (0.5/1.0–400 μg/L, R2 ≥ 0.9950), limits of detection (0.1–0.5 μg/L) and precision (≤5.9 %) were obtained. This method was successfully applied for the determination of triclosan and alkylphenols from five water samples with satisfactory recoveries (80.0–104.3 %). Subsequently, the green profile of the method was assessed by analytical Eco-Scale and Complementary Green Analytical Procedure Index. This method has the advantages of simplicity, rapidity, low cost, high sensitivity and green, which expands the application of solid solvents in liquid–liquid microextraction and has a wide application prospect. [ABSTRACT FROM AUTHOR]