Search

Compensation topologies of the inductive power transfer (IPT) converter for electric vehicles (EVs) have been researched in previous works. However, a methodology for designing a compensation topology based on the efficiency of the IPT converter has been barely discussed. This paper proposes an optimal design methodology for compensation parameters to achieve optimal efficiency of the IPT converter with LCC-S. The optimal output voltage is derived using the losses analysis of the IPT converter, and the IPT converter is designed for the optimal output voltage to achieve the optimal efficiency. Furthermore, the battery management (BM) converter on the receiving side is designed based on the output voltage of the IPT converter, the fluctuation range of the coupling coefficient, and the battery charging voltage. The validity of the proposed IPT converter design methodology is verified by designing different compensation parameters and BM converters. The power rating of the three design cases is 3.3 kW with the same magnetic pads satisfying the SAE J2954 WPT 1 class. [ABSTRACT FROM AUTHOR]

Based on the unipolar-duty-cycle (UDC) modulation technique, this article presents a hybrid control strategy for a series–series compensated inductive power transfer (IPT) system. By adjusting the duty cycle and the operating frequency, zero-voltage switching (ZVS) and constant-current output (CCO) can be achieved with varying coupling coefficients and load. Furthermore, as the proposed strategy enables the IPT system to lower the frequency of operation, it provides higher efficiency in the overall output power range than the conventional variable-frequency control methods. The basic principle of the UDC control strategy and its characteristics are introduced, and the system performance under UDC is analyzed and compared with the performance achieved by conventional control methods. Based on this, the UDC closed-loop control scheme, which combines PI control and hysteresis control, is proposed for the dynamic tracking of the ZVS and the CCO under a wide range of coupling coefficients and load. To validate the practicability of the proposed control strategy, a 500-W experimental prototype is configured. The simulation and experimental results indicate that the proposed scheme can stably and accurately track the ZVS and the CCO under varying parameter conditions, and it significantly improves the system efficiency. Especially, the system efficiency is improved by approximately 1.75% under light-load conditions as compared with that of the conventional control method. In addition, since the proposed method employs only one control loop, the cost and complexity of the IPT system are reduced. [ABSTRACT FROM AUTHOR]