Search

Dual active bridge is often considered in many dc/dc converter applications where high efficiency, input/output voltage ratio, and power level are required. Recently, a predictive control technique, named moving discretized control set model predictive control has been introduced, in order to achieve faster dynamics and stable operation throughout the power and terminal voltage ranges, considering global control parameters. However, even if this technique provides flexible multi-objective control, its large signal stability remains in questions. In this article, the proposed control design is described in detail, and its large signal stability is analyzed, considering the case of a dual active bridge converter operating in single-phase shift. The obtained results show insights into factors that stabilize or destabilize the converter operation. The proposed control and stability analysis is validated through both simulation and experimental testing. [ABSTRACT FROM AUTHOR]

The implementation of finite-control-set model predictive control (FCS-MPC) in voltage source inverters (VSIs) can make the system suffer from poor current harmonics performance, which may complicate the design of the required AC filter. To overcome this shortcoming, a carrier-based modulated model predictive control (CB-MMPC) strategy is proposed in this paper. This method enables the utilization of existing PWM modulation techniques with FCS-MPC, where a modulation waveform with zero-sequence signal injection is generated and compared to a triangular carrier wave, while optimizing the selection of the switching states. As it is shown, the studied CB-MMPC strategy not only considerably improves the current total harmonic distortion (THD) but also attains the performance of fast current dynamic response and robustness as the traditional FCS-MPC. Herein, the detailed implementation of the CB-MMPC control strategy is given, while considering its application to the current feedback control loop of a three-phase three-wire two-level VSI modulated at constant switching frequency. Finally, PLECS circuit simulation and a 3-kW VSI prototype are used to verify the superiority and the effectiveness of the presented CB-MMPC strategy. This is also benchmarked to the FCS-MPC and dead-beat based controllers. [ABSTRACT FROM AUTHOR]