Search

In order to break limited step-down ratio range and poor regulation capacity in the conventional resonant switched-capacitor converters for rectifier application, a single-stage ac/dc rectifier based on the dual-resonance switched-capacitor converter is proposed in this article. Through utilizing a dual-resonant structure and nonoverlapping strategy to realize wide continuous voltage gain of the proposed converter, high power factor (PF) and low total harmonic distortion (THD) based on the narrow dead zone are guaranteed by operating at high step-down conversion ratio in this converter topology. Moreover, the voltage gain is concentrated between resonant frequency and double resonant frequency to achieve a narrow switching frequency range for rectifier application. Furthermore, operating at flat voltage stress curves to obtain low voltage stress character. Comprehensive mode analysis, input PF and THD, and stress analysis are given, and analysis results indicate that the proposed power factor correction converter can work with soft turn on and zero-current turn off; high efficiency is realized. Finally, an experimental prototype with 85–130 Vac input and 47 Vdc/44 W output is built and tested for verifying the operation modes and PFC performance, and the comparison between different rectifiers and the proposed one is provided. [ABSTRACT FROM AUTHOR]

The bipolar DC bus configuration has been widely used in DC nano-grids due to its flexibility and stability. Input-parallel-output-series (IPOS) converters are utilized in bipolar DC bus and RES applications due to their simple structure. However, there is a big challenge with this structure. To ensure system safety and stability, the two output voltages of an IPOS converter need to be balanced. On this basis, an IPOS three-state boost converter with a balanced output voltage is proposed in this paper. At the same time, output voltage balance can be obtained by adjusting the duration of the three-state converter based on the volt-second balance method. In the proposed strategy, a switch series diode is added to the IPOS Boost converter topology, and the voltage across the main inductor can be changed through one degree of freedom, where the corresponding output voltage is regulated due to a change in inductor voltage. In addition, under different dead time conditions, adjusting the gate drive of the switch can be used to achieve voltage balance. Moreover, a comprehensive analysis and relative calculations are provided. Finally, a 20–200 V prototype is built to verify the analysis. [ABSTRACT FROM AUTHOR]