Search

δ-AlOOH is regarded as a potential water carrier that is stable in the Earth’s lower mantle down to the core-mantle boundary along the cold slab geotherm; thus, knowledge of its structural evolution under high pressure is very important for understanding water transport in the Earth’s interior. In this work, we conducted Raman scattering and luminescence spectroscopic experiments on δ-AlOOH at pressures up to 34.6 and 22.1 GPa, respectively. From the collected Raman spectra, significant changes in the pressure dependence of the frequencies of Raman-active modes were observed at ~8 GPa, with several modes displaying softening behavior. In particular, the soft A1 mode, which corresponds to a lattice vibration of the AlO6 octahedron correlated to OH stretching vibrations, decreases rapidly with increasing pressure and shows a trend of approaching 0 cm−1 at ~9 GPa according to a quadratic polynomial extrapolation. These results provide clear Raman-scattering spectroscopic evidence for the P21nm-to-Pnnm structural transition. Similarly, the phase transition was also observed in the luminescence spectra of Cr3+ in both powder and single-crystal δ-AlOOH samples, characterized by abrupt changes in the pressure dependences of the wavelength of the R-lines and sidebands across the P21nm-to-Pnnm transition. The continuous decrease in R2-R1 splitting with pressure indicated that the distortion of the AlO6 octahedron was suppressed under compression. No abnormal features were clearly observed in our Raman or luminescence spectra at ~18 GPa, where the ordered symmetrization or fully centered state with hydrogen located at the midpoint of the hydrogen bond was observed by a previous neutron diffraction study. However, some subtle changes in Raman and luminescence spectra indicated that the ordered symmetrization state might form at around 16 GPa.

Mineral dehydration in the subduction zone enormously affects Earth’s geodynamics and the global geochemical cycles of elements. This work uses Raman spectroscopy and X-ray diffraction to investigate the dehydration process of antigorite under compression and shear loading conditions in a rotational diamond anvil cell (RDAC) at room temperature. In order to compare the shear effects, T301 stainless steel and Kapton plastic are applied as the gasket materials. In the experiment using a high-strength T301 stainless steel gasket, two new broad OH-stretching peaks of H2O and H3O2− appear at 3303 and 3558 cm−1, respectively, at 1.7 GPa. The original sharp OH-stretching peaks of antigorite at 3668 and 3699 cm−1 remain, while the central pressure is increased to 8.0 GPa, and the largest pressure gradient is about 2.5 GPa in the sample chamber. In another experiment with a low-strength gasket of Kapton plastic, two new OH-stretching broad peaks of H2O and H3O2− also start to appear at 3303 and 3558 cm−1, respectively, at a lower pressure of 0.3 GPa, but the original sharp OH-stretching peaks of antigorite at 3668 and 3699 cm−1 almost completely vanish as the central pressure reaches 3.0 GPa, with the largest pressure gradient at around 4.8 GPa. The comparison between the two experiments shows that antigorite is easier to dehydrate in the chamber of a Kapton plastic gasket with a larger gradient of shear stress. However, its axial compression stress is lower. The high-pressure Raman spectra of MgO2(OH)4 octahedron and SiO4 tetrahedron in the low wavenumber zones (100–1200 cm−1) combined with the micro-beam X-ray diffraction spectrum of the recovered product strongly support the structural breakdown of antigorite. This investigation reveals that the water-bearing silicate minerals have strong shear dehydration in the cold subduction zone of the plate, which has important applications in predicting the physical and chemical properties of subduction zones and deducing the rate of plate subduction.

The presence of the van der Waals (vdW) gap in layered materials creates a wealth of intriguing phenomena different to their counterparts in conventional materials. For example, pressurization can generate a large anisotropic lattice shrinkage along the vdW stacking orientation and/or a significant interlayer sliding, and many of the exotic pressure-dependent properties derive from these mechanisms. Here we report a giant piezoresistivity in pressurized \(\beta \text{’}\)-In2Se3. Upon compression, a six-orders-of-magnitude drop of electrical resistivity is obtained below 1.2 GPa in \(\beta \text{’}\)-In2Se3 flakes, yielding a giant piezoresistive gauge \({\pi }_{P}\) of -5.33 GPa− 1. Simultaneously, the sample undergoes a semiconductor-to-semimetal transition without a structural phase transition. Surprisingly, linear dichroism study and theoretical first principles modelling show that these phenomena arise not due to shrinkage or sliding at the vdW gap, but rather are dominated by the layer-dependent atomic motions inside the quintuple layer, mainly from the shifting of middle Se atoms to their high-symmetric location. Our work not only provides a prominent piezoresistive material but also points out the importance of intralayer atomic motions beyond vdW gap.