Search

Objective: The aim of the study was to investigate the physicochemical stability of mitomycin-containing medicinal products for bladder instillation, formulated with urea as excipient (mito-medac®, Mitomycin medac). For comparison, the stability of reconstituted Urocin® and Mitem® bladder instillation was studied., Methods: Mitomycin-containing medicinal products were either reconstituted with the prepackaged 0.9% NaCl solution, nominal volume 20 mL (mito-medac®, Mitem®, Urocin®) or with 20 mL water for injection (Mitomycin medac, Mitem®, Urocin®) to a nominal concentration of 1 mg/mL and stored at room temperature (20-25°C). Samples were taken immediately after reconstitution and after 24 hours. Physicochemical stability was determined by reverse-phase high performance liquid chromatography with photodiode array detection, measurement of pH and osmolarity, and inspection for visible particles or colour changes., Results: The initial pH values of the test solutions reconstituted with prepackaged 0.9% NaCl (5.2-5.6) were significantly lower than those reconstituted with water for injection (6.6-7.4). Solutions reconstituted with 0.9% NaCl solutions rapidly degraded and concentrations fell below the 90% limit after 24 hours of storage. When reconstituted with water for injection, degradation was less rapid. Concentrations of Mitomycin medac and Urocin remained above the 90% limit after 24 hours., Conclusions: The physicochemical stability of mitomycin 1 mg/mL bladder instillation prepared with prepackaged 0.9% NaCl in prefilled PVC bags is less than 24 hours at room temperature. Unfavourable pH values of the solvents cause rapid degradation of mitomycin. Mitomycin solutions reconstituted at the point of care should be administered immediately to avoid degradation and loss of efficacy. Urea added as excipient did not accelerate degradation., Competing Interests: Competing interests: None declared., (© European Association of Hospital Pharmacists 2024. No commercial re-use. See rights and permissions. Published by BMJ.)

Oxytocin is the principal drug and the primary choice for labor induction and postpartum hemorrhage prevention and treatment. The problems associated with oxytocin are not usually from its effectiveness, but they are from its compromised quality which may occur at the point of manufacturing, transportation, and storage. The main objective of this study was to assess the status of oxytocin injection quality and associated factors in the health facilities located in Addis Ababa city, Ethiopia. A laboratory based instrumental quality testing alongside a cross sectional study design was used to evaluate oxytocin injection quality in Addis Ababa city administration from January to June, 2022 according to United States Pharmacopeia (USP 20), and the World Health Organization guideline of post-market medicine quality assessment. Binary logistic regression and cross tabulation analysis were conducted using SPSS 26. Significance was considered at p ≤ 0.05. Out of 107 tested oxytocin injection samples, 92.5% met the limit for oxytocin content, 81.3% for sterility test, and 91.6% for pH value. Overall, quality failure rate was 23.4%, while sterility test failure rate was 18.7%. Lack of reliable refrigerated storage condition [(AOR = 5.62, 95% CI: (1.87, 16.88)], lack of effective cold chain system during distribution [(AOR = 5.5, 95% CI: (1.53, 19.74)], and weak national medicine regulatory system [(AOR = 3.23, 95% CI: (1.13, 9.23)] were among the significantly associated factors for the failure of some of the brands. The study demonstrated that oxytocin injection quality failure rate, failing to meet at least one quality test requirement, is demonstrated in the health facilities of Addis Ababa. The determinant factors for the reported failures are related to storage, distribution, and regulatory system. Hence, these should be addressed by strictly adhering in to the national regulation and providing a comprehensive health promotion on rational use of oxytocin injection should be implemented to assure its quality and safety., (© 2024. The Author(s).)

Objective: To assess the implementation of the bedside medication preparation process in an Intensive Care Unit, following a quality improvement cycle., Method: A quasi-experimental study with non-paired samples, pre- and post-implementation, conducted in an Intensive Care Unit of a public hospital in southern Brazil, from September 2022 to April 2023, following the guidelines of the Standards for Quality Improvement Reporting Excellence 2.0. Adherence to bedside medication preparation, interruptions during preparation, adequate storage, identification and validity of multidose medications, and recording of storage refrigerator temperature were evaluated. Shapiro-Wilk and Mann-Whitney U tests were used for data analysis, and Carter's Positivity Index was used to determine compliance with observed practices., Results: Forty-five audits were conducted pre-intervention and 122 audits three months after the implementation of the improvement cycle. All variables showed significant improvements. Overall compliance increased from 46% to 80% in the pre- and post-implementation periods, respectively, indicating a transition from "undesirable" to "safe" care stratum., Conclusion: The study revealed a positive relationship between the implementation of a quality improvement cycle focused on medication preparation and improvements in patient safety.

The correct storage of vaccines is vital to ensuring that they work effectively and keep patients safe. In this article the author explains how to ensure compliance with regulations without placing an undue burden on community nursing staff.

Microbial challenge in-use studies are performed to evaluate the potential for microbial proliferation in preservative-free single-dose biological products after first puncture and potential accidental contamination during dose preparation (e.g., reconstitution or dilution) and storage. These studies, in addition to physicochemical in-use stability assessments, are used as part of product registration to define in-use hold times in Prescribing Information and in the pharmacy manual in the case of clinical products. There are no formal guidance documents describing regulator expectations on how to conduct microbial challenge in-use studies and interpret microbial data to assign in-use storage hold times. In lieu of guidance, US Food and Drug Administration (FDA) regulators have authored publications and presentations describing regulator expectations. Insufficient or unavailable microbial challenge data can result in shortened in-use hold times, thus microbial challenge data enables flexibility for health care providers (HCPs) and patients while ensuring patient safety. A cross-industry/FDA in-use microbial working group was formed through the Innovation & Quality (IQ) Consortium to gain alignment among industry practice and regulator expectations. The working group assessed regulatory guidance, current industry practice via a blinded survey of IQ Consortium member companies, and scientific rationale to align on recommendations for experimental design, execution of microbial challenge in-use studies, and a decision tree for microbial data interpretation to assign in-use hold times. Besides the study execution and data interpretation, additional considerations are discussed including the use of platform data for clinical stage products, closed system transfer devices (CSTDs), transport of dose solutions, long infusion times, and the use of USP <797> by HCPs for preparing sterile drugs for administration. The recommendations provided in this article will help streamline biological product development, ensure consistency on assignment of in-use hold times in biological product labels across industry, and provide maximum allowable flexibility to HCPs and patients while ensuring patient safety., (© PDA, Inc. 2024.)

Objective: Unsafe opioid-related practices can lead to abuse, diversion, and accidental overdoses. In this study, we aimed to describe the patterns and beliefs regarding the storage, disposal, and use of opioids among Chinese patients with cancer in their home settings, which remain unclear., Methods: A multicenter cross-sectional survey was conducted in Hubei Province from October 2022 to June 2023. We collected information on the storage, disposal, and use of opioids among cancer pain inpatients in the oncology department. Logistic regression was used to estimate the factors associated with unsafe disposal and use of opioids., Results: The survey included 221 patients with a median age of 62 years. Only 3.2% stored their opioids under lock and key, and 49.8% were unaware of proper disposal methods. Nearly one-fifth (19.5%) reported having received information on the safe storage (14.0%) and/or disposal (10.0%) of opioids. A total of 44.3% reported unsafe use by sharing (1.8%), losing (4.1%), or taking opioids at a higher dose than prescribed (42.5%). Patients who did not receive information on the safe disposal of opioids (OR = 4.57, P = .0423), had a history of alcohol use (OR = 1.91, P = .0399), and used opioids other than morphine (OR = 2.31, P = .0461) had higher odds of unsafe disposal practices. Individuals with an associate degree/bachelor's degree or above were less likely to dispose of (OR = 0.36, P = .0261) and use (OR = 0.31, P = .0127) opioids unsafely., Conclusion: A significant proportion of Chinese patients with cancer exhibit unsafe practices in the storage, disposal, and use of opioids. The study highlights an urgent need for implementing routine education programs and drug "take-back" initiatives to improve opioid-related practices., (© The Author(s) 2024. Published by Oxford University Press.)