Search

This paper investigates the influence of a constant carrier phase shift on the DC-link capacitor harmonic current of cascaded converters used in fuel-cell and mild-hybrid electric vehicles. In these applications, a DC-DC converter can be adopted between the battery and the motor drive inverter in a cascaded structure, where the two converters share the same DC-link. Since the DC-link capacitor of such a system represents a critical component, the optimization of the converter operation to limit the current stress and extend the lifetime of the capacitor is an primary objective. This paper proposes the use of a carrier phase shift between the modulations of the two converters in order to minimize the harmonic current of the DC-link capacitor. By harmonic analysis, an optimal carrier phase shift can be derived depending on the converter configuration. Analytical results are presented and validated by hardware-in-the-loop experiments. The findings show that the pulse width modulation carrier phase shift between the interleaved boost converter and the voltage source motor drive inverter has a significant influence on the DC-link capacitor current and thus on its lifetime. A case study with two-cell and three-cell interleaved boost converters shows a possible DC-link capacitor lifetime extension of up to 390%. [ABSTRACT FROM AUTHOR]

In this work, a multilevel 42-sided polygonal space vector structure for suppression of lower order harmonics for open-end induction motor (OEIM) drive applications is proposed. The proposed power circuit topology consists of two inverters feeding an OEIM from either side. The main inverter fed with a single dc-link providing active power for motoring operation is switched at low switching frequency. The secondary inverter fed with a capacitive supply is switched at high frequency to suppress lower order harmonics upto 39th order, up to the base speed of operation allowing maximum utilization of the dc-link. The advantages of lower order harmonic suppression in motor phase voltage, for polygonal space vector structures, are combined with multilevel inverter topology. This offers various advantages like multilevel operation with low inverter switching for the main power delivery inverter and harmonic suppression throughout the modulation range. The low switching frequency primary inverter generates harmonics of the order $6*k \pm 1$ , where $k = 1, 2, 3,{\ldots }$. The harmonics are suppressed by the capacitor-fed secondary inverter, which supplies only reactive power for suppression of lower order harmonics in motor phase voltage. Use of a single dc-link facilitates four-quadrant operation of the inverter. The proposed scheme is validated for steady-state and dynamic performance by experimental results. [ABSTRACT FROM AUTHOR]

In this article, a nonlinear high-gain observer (NHGO)-based second-order sliding mode (SOSM) control strategy is proposed for the three-phase three-level neutral-point-clamped (NPC) converter. This controller applies the advanced SOSM algorithm both in the voltage regulation loop and in the power tracking loop, which provides a fast dynamic for the dc-link voltage, and also assures a good steady-state behavior for the NPC converter. Additionally, an NHGO technique is implemented in the voltage regulator combining with the SOSM algorithm. The conventional observer-based controllers suffer from the destructive effects of measurement noise, and it can only be addressed by diminishing the observer gain, which sacrifices the observer property. The NHGO technique adopts a time varying gain, that is, high gain in transient while low gain in steady state, which minimizes the adverse influence of measurement noise. The tuning method of the proposed NHGO-based SOSM controller is given to simplify the implementation process. Finally, the simulation and experimental results of the proposed control scheme for the NPC converter are given and compared with the conventional PI controller as well as the well-known linear extended state observer-based control method, which validates the feasibility and superiority of the proposed controller. [ABSTRACT FROM AUTHOR]

This article proposes a sliding-mode-observer (SMO)-based control strategy to regulate the dc-link voltage for a three-phase two-level active front end (AFE). The SMO is designed for the voltage control loop to estimate the external load which is abruptly connected to the AFE dc-link and consequently causes the dc-link voltage fluctuation. The estimated load value is used to compensate the voltage loop controller, therefore, the voltage loop gains more robustness against the load perturbation and its disturbing effect is greatly reduced. The effectiveness and advantage of the proposed control strategy has been verified through theoretical analysis, simulations, and the real-application experiments conducted on a 5 KVA laboratory AFE. The results show that the proposed control strategy provides obvious improvement of the dc-link voltage control performance comparing with the conventional PI controller and demonstrates stronger robustness against the operating point variations caused by the changes in external load and dc-link capacitance. [ABSTRACT FROM AUTHOR]

Modular multilevel converters have become the prominent topology for medium- and high-voltage applications. The performance of these converters highly depends on the accuracy of the used modulation approach, for which the capacitor voltage of submodules (SM) are usually assumed to be equal. This article exhibits that ignoring the capacitor voltage differences among SMs adversely affects the system performance. This becomes more obvious the larger the capacitor voltage differences are. Hence, this article proposes a more accurate feedforward modulation approach that takes into account either the instantaneous capacitor voltage value and the real output voltage in the modulation stage. As a result, in applications where larger SM voltage differences are expected, the current distortion and control performance are improved. Particularly, switching–saving approaches benefit from this method as it enables their operation with reduced switching losses without the downsides of increased distortion due to capacitor voltage differences. The proposed approach is analyzed and compared with the nearest-level modulation and with the level-shift PWM. Simulations and experimental validation are presented to confirm the effectiveness of the proposed technique. [ABSTRACT FROM AUTHOR]

This article proposes a novel robust control strategy for three-phase power converters operated under unbalanced grid conditions. A consolidated control objective is obtained in the stationary $\alpha \beta$ frame, which can be flexibly adjusted according to the degree of oscillation in the active and reactive powers and the balance of the three-phase current. Based on the dynamics of the converter and control objective, a control scheme in a cascaded framework is presented, in which an adaptive observer is applied to estimate the positive and negative sequences of the grid voltage. In the current tracking loop, a super-twisting algorithm current controller coupled with a super-twisting differentiator is implemented to track the current references, featuring rapid dynamics, and improved robustness. Additionally, in the voltage regulation loop, an effective composite controller is developed to regulate the dc-link voltage, where a super-twisting observer is used to estimate the load disturbance, thereby improving the performance of the converter. The experimental results are provided to confirm the effectiveness and superiority of the proposed control strategy. [ABSTRACT FROM AUTHOR]

A finite control set model predictive control (FCS-MPC) strategy consists of a prediction model, a cost function and an optimization algorithm. Consequently, the performance of the FCS-MPC depends on the proper design of these three elements. This article assesses the influence of the prediction model of an uninterruptible power supply (UPS). Since the load connected to the voltage source inverter (VSI) affects the dynamic of the system state variables, the load dynamic should be included in the system model. This makes the design of the prediction model a challenge because the load connected to the VSI is generally unknown. To deal with this uncertainty, this work proposes an augmented prediction model based on a state observer that includes as many harmonic components as necessary to accurately represent the output current. The performance of the FCS-MPC for a UPS is evaluated in a laboratory prototype using the proposed and the conventional prediction models. Experimental results show that the proposed solution provides a more accurate representation of the output current, improving the system performance. [ABSTRACT FROM AUTHOR]

This article proposes an inverter topology for the first time for suppression of all lower order harmonics (5th, 7th, 11th, 13th, etc.) up to 39th harmonic. The lower order harmonic suppression is achieved by switching the 42-sided polygonal vectors, which eliminates harmonics in phase voltage without using a passive LC filtering technique. The power circuit topology uses a single dc-link supply for the primary inverter. The secondary inverter is fed with a capacitive supply. A novel topology is proposed for the dense six-level secondary inverter. The lower order harmonics in phase voltage are suppressed using the secondary inverter, which acts like a switched-capacitive filter. This article also proposes a novel capacitor voltage-balancing scheme for the first time, which achieves voltage balancing for secondary inverter capacitors. The voltages of secondary inverter capacitors are balanced using the power balance relationship between the primary inverter and the motor load. An experimental study of the topology and the capacitor-balancing scheme is presented for the validation of proposed scheme. [ABSTRACT FROM AUTHOR]

Modular converters such as the multilevel cascaded H-bridge (CHB) are an attractive option for multiple applications mainly because of inherent modularity and fault-tolerant operation. This article is focused on the CHB converter operating with unbalanced conditions (different dc voltages and/or modulation indexes). Under these circumstances, applying the conventional control and modulation strategies, the output voltage harmonic spectrum is degraded. In this article, a generalized variable-angle phase-shifted pulsewidth modulation (PS-PWM) technique for CHB converters with a large number of power modules (> 3) is presented. The method considers all possible cells’ combinations to form groups and assigns the role of each cell in the group. This cell role defines the identifier of the cell in the variable-angle PS-PWM technique. In the steady state, in each group of cells, the harmonic distortion of the CHB output voltage located at twice the carrier frequency ƒc is eliminated, while the distortion at 4ƒc is also diminished. Experimental results show how the proposed technique achieves superior harmonic performance without introducing any significant disadvantage. [ABSTRACT FROM AUTHOR]

Grid-connected photovoltaic (PV) systems can provide grid support features by implementing flexible power point tracking (FPPT) strategies. Conventionally, the FPPT algorithms are based on linear search algorithms, such as perturb and observe. These solutions offer good practical results but usually lead to oscillations around the steady-state operating point. The main contribution of this article is to propose a binary search based FPPT (BNS-FPPT) algorithm. BNS is a computer-science-based searching algorithm that performs a logarithmic search within a sorted data array until the target voltage value is found. Compared to sequential searching algorithms, the proposed BNS-FPPT algorithm conducts a nonlinear search and avoids waving around the final value, reducing the steady-state error. In this article, the basics of the BNS-FPPT are described in detail. In addition, experimental results are conducted on a laboratory setup to compare the BNS-FPPT performance against a state-of-the-art solution. The results show that compared to linear search-based FPPT algorithms, the proposed BNS-FPPT is able to provide the required grid support functionalities, and avoid waving around the final operation point. [ABSTRACT FROM AUTHOR]