Search

In this paper, a sample voltage dead-beat control based on differentiative voltage prediction (DVP) and switching-cycle extension (SCE) is presented to achieve optimal transient response for DC-DC converters under discontinuous conduction mode (DCM) operation. Firstly, to improve load transient response, a DVP method is proposed to estimate the load. With the estimated load, the controller realizes load current feedforward and thus improves the transient response with a wide load range. Secondly, an SCE strategy is proposed to enlarge the output current range and output voltage slew rate, both of which have limited value under conventional digital pulse width modulation (DPWM). When the output current reaches the limited value, the proposed strategy increases the switching cycle to enlarge the current range without losing DCM operation. Finally, combining DVP with SCE, the converter not only achieves optimal response in large signal transients, but also doubles the load range in DCM operation. [ABSTRACT FROM AUTHOR]

This paper proposes a fully analytical loss model to reduce circling currents and improve the power efficiency of a class Φ2 inverter. Firstly, analytical expression of the switching node voltage is derived by analyzing its harmonic components. Based on the result, the power switch is modeled as a voltage source, where the circuit is simplified to a linear network and analytical expressions of branch currents are solved. Secondly, root mean square (RMS) values of branch currents and component losses are calculated to form the analytical loss model for a Φ2 inverter. The influence of circuit parameters on the circling current and power efficiency are thoroughly analyzed, which derives optimal design constraints to reduce circling currents of a class Φ2 inverter. Furthermore, detailed design guidance and equations are provided to calculate circuit parameters of a class Φ2 inverter, which reduces its circling currents and improves overall power efficiency. Finally, a class Φ2 inverter prototype is built, and experimental results demonstrate a 7% efficiency improvement compared to conventional empirical design methods. [ABSTRACT FROM AUTHOR]

For very high frequency (VHF) class Φ2 inverter, conventional design method requires complex tuning for parameters. Without fully quantitative calculations, the tuning highly depends on experience that cannot achieve optimal design. In this article, a target function design strategy is proposed based on quantitative harmonic weighting, which simplifies the design procedures and minimizes the switch voltage stress. First, the target switch voltage with minimized peak value is derived by optimizing the harmonic weighting. With the result, the power switch is modeled as a voltage source to simplify the calculations, where the branch currents are solved to provided fully quantitative analysis. Based on the analysis, optimal features of switching node impedance are derived to achieve the target switch voltage. In addition, basic constrains of the resonant tank are analyzed to reduce circling currents. Combining the optimal features and basic constrains of the resonant tank, the circuit parameters are calculated directly, which minimizes the switch voltage stress and improves power efficiency. Compared with conventional design, a 27.12 MHz prototype demonstrates 10.2% reduction in average switch voltage stress and 7.2% improvement in average efficiency. [ABSTRACT FROM AUTHOR]