Search

Changes in the properties of resin-based polymers exposed to the oral environment can emerge when chlorhexidine (CHX) is incorporated to develop bioactive systems for treating denture stomatitis. Three reline resins loaded with CHX were prepared: 2.5 wt% in Kooliner (K), 5 wt% in Ufi Gel Hard (UFI), and Probase Cold (PC). A total of 60 specimens were submitted to physical aging (1000 cycles of thermal fluctuations, 5–55 °C) or chemical aging (28 days of pH fluctuations in artificial saliva, 6 h at pH = 3, 18 h at pH = 7). Knoop microhardness (30 s, 98 mN), 3-point flexural strength (5 mm/min), and surface energy were tested. Color changes (ΔE) were determined using the CIELab system. Data were submitted to non-parametric tests (α = 0.05). After aging, bioactive K and UFI specimens were not different from the controls (resins without CHX) in mechanical and surface properties. Thermally aged CHX-loaded PC specimens showed decreased microhardness and flexural strength but not under adequate levels for function. The color change was observed in all CHX-loaded specimens that underwent chemical aging. The long-term use of CHX bioactive systems based on reline resins generally does not impair removable dentures' proper mechanical and aesthetic functions. [ABSTRACT FROM AUTHOR]

The most commonly used material in dental implants and their abutments is titanium. Zirconia is a more aesthetic alternative to titanium abutments; however, it is much harder. There are concerns that zirconia could damage the surface of the implant over time, especially in less stable connections. The aim was to evaluate the wear of implants with different platforms connected to titanium and zirconia abutments. A total of six implants were evaluated, two of each connection type: external hexagon, tri-channel, and conical connections (n = 2). Half of the implants were connected to zirconia abutments, and the other half to titanium abutments (n = 3). The implants were then cyclically loaded. The implant platforms were evaluated by digital superimposing micro CT files and calculating the area of the loss surface (wear). In all the implants, a statistically significant loss of the surface area (p = 0.028) was observed when comparing the area before and after cyclic loading. The average lost surface area was 0.38 mm2 with titanium abutments and 0.41 mm2 with zirconia abutments. The average lost surface area was 0.41 mm2 with the external hexagon, 0.38 mm2 with the tri-channel, and 0.40 mm2 with the conical connection. In conclusion, the cyclic loads induced implant wear. However, neither the type of abutment (p = 0.700) nor the connection (p = 0.718) influenced the amount of surface area lost. [ABSTRACT FROM AUTHOR]