Search

In many areas, such as speech processing, communication, and measurement systems, where the actual signal is not directly available, Wiener deconvolution is a widely used signal restoration technique. The accuracy of the estimated signal in Wiener deconvolution is determined by the unknown filter parameter. To compute this unknown parameter, complex and time-consuming numerical as well as iterative computation approaches were proposed in the literature, which also often compute an unoptimized unknown filter parameter. To address the computational problem and estimate a more accurate unknown filter parameter, the authors reported an analytical solution in a prior work for a given signal to noise ratio. However, it was revealed that the actual optimum parameter value also varies with noise also. In this paper, the authors propose a new analytical solution for optimum parameter estimation that includes noise as well. The authors compared the modified analytical solution to existing numerical computation methods for different values of Signal to Noise Ratio and demonstrated that the proposed methods’ optimum parameter estimation is always close to the actual optimum value, which resulted in more accurate signal deconvolution. Proposed mathematical solutions are also verified with experimental signals, acquired in a laboratory. [ABSTRACT FROM AUTHOR]

The surface voltage of an insulator assumes importance for understanding tracking and flashover characteristics. Until now, determination of surface voltage of insulating surfaces is left to simulation software and such simulations are left unverified experimentally, leading to uncertainty of the results, which may sometimes be erratic with improper choice of boundary or initial conditions or inaccurate material properties, nonlinearities etc. The paper presents a novel method, using which the surface voltage of any insulating surface such as insulator strings or transformer bushings can be measured. Unlike a conducting surface, the measurement of insulating surface voltage using voltage dividers would be erratic as the measuring arrangement itself will vary the voltage division due to the local unknown impedance between the insulated surface and hv conductor. Recently a method for measurement of surface voltage of an insulated conductor using cylindrical strips was reported. In this paper, based on analytical derivations, a more generalized method of measurement, applicable to any point on an insulating surface of arbitrary geometry is proposed using circular-disc strips. The proposed experimental method is applied to insulator strings and transformer bushings and validated by simulation of the entire systems. The simulation and experimental results are in excellent agreement. [ABSTRACT FROM AUTHOR]

The converter transformers are reported to fail generally on the thyristor-valve side, where complex alternating voltage waveforms superimposed with dc voltages would occur. The effect of these waveforms on the failure and endurance of the valve side winding insulation of the transformers is not yet understood, which is investigated here. In this paper, the voltage waveforms occurring in a converter transformer are obtained through PSCAD/EMTDC for a typical double pole ±500 kV, 1000 MW DC-link HVDC transmission system based on the CIGRE benchmark system. The waveforms are then amplified using a High Voltage amplifier for experimental breakdown investigations. Stepped-stress damage equalization method has been used for obtaining the lifetime characteristics from failure data. A comparison with life curve under pure sinusoidal and actual alternating voltages with superimposed dc and harmonic voltage has been made to understand why the converter transformers generally failed on the valve side. The results first time give fundamental reasons for the possible failure of the converter transformers and put forth important design considerations. [ABSTRACT FROM AUTHOR]