Search

Abstract Background Magnetic resonance imaging (MRI) quantification of intramuscular fat accumulation is a responsive biomarker in neuromuscular diseases. Despite emergence of automated methods, manual muscle segmentation remains an essential foundation. We aimed to develop a training programme for new observers to demonstrate competence in lower limb muscle segmentation and establish reliability benchmarks for future human observers and machine learning segmentation packages. Methods The learning phase of the training programme comprised a training manual, direct instruction, and eight lower limb MRI scans with reference standard large and small regions of interest (ROIs). The assessment phase used test–retest scans from two patients and two healthy controls. Interscan and interobserver reliability metrics were calculated to identify underperforming outliers and to determine competency benchmarks. Results Three experienced observers undertook the assessment phase, whilst eight new observers completed the full training programme. Two of the new observers were identified as underperforming outliers, relating to variation in size or consistency of segmentations; six had interscan and interobserver reliability equivalent to those of experienced observers. The calculated benchmark for the Sørensen-Dice similarity coefficient between observers was greater than 0.87 and 0.92 for individual thigh and calf muscles, respectively. Interscan and interobserver reliability were significantly higher for large than small ROIs (all p

Abstract Objective With potential therapies for many forms of Charcot‐Marie‐Tooth disease (CMT), responsive outcome measures are urgently needed for clinical trials. Quantitative lower limb MRI demonstrated progressive calf intramuscular fat accumulation in the commonest form, CMT1A with large responsiveness. In this study, we evaluated the responsiveness and validity in the three other common forms, due to variants in GJB1 (CMTX1), MPZ (CMT1B) and MFN2 (CMT2A). Methods 22 CMTX1, 21 CMT1B and 21 CMT2A patients and matched controls were assessed at a 1‐year interval. Intramuscular fat fraction (FF) was evaluated using three‐point Dixon MRI at thigh and calf level along with clinical measures including CMT examination score, clinical strength assessment, CMT‐HI and plasma neurofilament light chain. Results All patient groups had elevated muscle fat fraction at thigh and calf levels, with highest thigh FF and atrophy in CMT2A. There was moderate correlation between calf muscle FF and clinical measures (CMTESv2 rho = 0.405; p = 0.001, ankle MRC strength rho = −0.481; p

Using fMRI, we investigated how right temporal lobe gliomas affecting the posterior superior temporal sulcus alter neural processing observed during speech perception and production tasks. Behavioural language testing showed that three pre-operative neurosurgical patients with grade 2, grade 3 or grade 4 tumours had the same pattern of mild language impairment in the domains of object naming and written word comprehension. When matching heard words for semantic relatedness (a speech perception task), these patients showed under-activation in the tumour infiltrated right superior temporal lobe compared to 61 neurotypical participants and 16 patients with tumours that preserved the right postero-superior temporal lobe, with enhanced activation within the (tumour-free) contralateral left superior temporal lobe. In contrast, when correctly naming objects (a speech production task), the patients with right postero-superior temporal lobe tumours showed higher activation than both control groups in the same right postero-superior temporal lobe region that was under-activated during auditory semantic matching. The task dependent pattern of under-activation during the auditory speech task and over-activation during object naming was also observed in eight stroke patients with right hemisphere infarcts that affected the right postero-superior temporal lobe compared to eight stroke patients with right hemisphere infarcts that spared it. These task-specific and site-specific cross-pathology effects highlight the importance of the right temporal lobe for language processing and motivate further study of how right temporal lobe tumours affect language performance and neural reorganisation. These findings may have important implications for surgical management of these patients, as knowledge of the regions showing functional reorganisation may help to avoid their inadvertent damage during neurosurgery.

ObjectiveIn the pivotal DEFINE and CONFIRM trials for dimethyl fumarate (DMF), patterns of brain volume changes were different, potentially due to low sample sizes and because MRIs were analyzed at two different reading centers. We evaluated effects of DMF on brain volume change in patients with multiple sclerosis (MS) through reanalysis of pooled images from DEFINE/CONFIRM trials in one reading center.MethodsMRIs from DEFINE/CONFIRM at weeks 0, 24, 48, and 96 from patients randomized to twice-daily DMF or placebo (PBO) were reanalyzed at the Cleveland Clinic to measure brain parenchymal fraction (BPF). To account for pseudoatrophy, brain volume estimates were re-baselined to calculate changes for weeks 48–96.ResultsAcross studies, 301 and 314 patients receiving DMF and PBO, respectively, had analyzable MRIs. In weeks 0–48, mean ± SE percentage change in BPF was −0.44 ± 0.04 vs. −0.34 ± 0.04% in DMF vs. PBO, respectively, whereas in weeks 48–96, mean ± SE percentage change in BPF was −0.27 ± 0.03 vs. −0.41 ± 0.04% in DMF vs. PBO, respectively. The mixed-effect model for repeated measures showed similar results: in weeks 48–96, estimated change (95% confidence interval) in BPF was −0.0021 (−0.0027, −0.0016) for DMF vs. −0.0033 (−0.0039, −0.0028) for PBO (35.9% reduction; p = 0.0025).ConclusionsThe lower rate of whole brain volume loss with DMF in this pooled BPF analysis in the second year vs. PBO is consistent with its effects on relapses, disability, and MRI lesions. Brain volume changes in the first year may be explained by pseudoatrophy effects also described in other MS clinical trials.

Abstract Background High speed electric handpieces have recently been growing in popularity among dental professionals. Advantages include smoother surface preparation and increased cutting efficiency. Aim The primary objective was to compare enamel surface roughness following resin cleanup after bracket debonding using highspeed air turbine versus electric handpiece. The secondary objective was to record the time needed for resin-clean up. Method Forty deidentified freshly extracted human premolars were cleaned and sectioned at the cement-enamel junction. The crowns were embedded in acrylic blocks. Enamel surface roughness parameters (Ra, Rz, Rp and Rv) were measured using a stylus profilometer. Brackets were bonded using a light-cure orthodontic adhesive and stored in distilled water for 24 h. Following bracket debonding, the specimens were randomly divided into 2 groups: First group: resin clean-up was carried out using a 12-fluted carbide bur mounted on a high-speed air turbine; and second group: where an electric handpiece was used. Surface roughness parameters were measured following resin clean up and after polishing using pumice and a rubber cup. Time needed for resin clean-up was recorded. Differences in enamel surface roughness and time between groups were compared using repeated measures ANOVA and independent samples t-test, respectively at P ≤ 0.05. Results The electric handpiece groups showed significantly higher values for Ra, Rz and Rp both following resin cleanup and polishing. Time taken for resin cleanup was significantly longer for the electric handpiece group. Conclusion Considering both surface roughness and time, electric handpiece do not seem to add greater effectiveness or efficiency to resin cleanup following orthodontic bracket debonding.

Abstract Background Retainer is a necessary procedure when orthodontic treatment complete to avoid relapse due to periodontal fiber elasticity and to allow for alveolar bone regeneration. Compare the influence of vertical force on the failure of three fixed retainers: CAD/CAM polyether ether ketone (PEEK), CAD/CAM fiber glass reinforced composites (FRCs), and lingual retainer wire “Bond-A-Braid™”. Materials and methods One hundred and eight maxillary first premolars teeth were randomly allocated to three groups: Group A (CAD/CAM PEEK), Group B (CAD/CAM FRC), and Group C (lingual retainer wire " Bond-A-Braid™”). These retainers were bonded using Assure Plus Bonding Resin and GO TO Paste. For each specimen, a loading cycling and thermocycling machine was used. The failure debonding forces were measured on the interproximal segments using a universal testing machine with a cross-head speed of 1 mm/min. The adhesive remnant index (ARI) was calculated after identifying types of failure with a stereomicroscope at (X 20) magnification. Results Group B and group C showed the highest failure bonding forces, with a mean of 209.67 ± 16.15 and 86.81 ± 4.59 N, respectively. However, Group A had a statistically significant lower bond failure force, with a mean value of 45.73 ± 4.48 N. At baseline, there was a statistically significant difference in connector retainer displacement between the three studied groups (p

Abstract Background Development of white spot lesions (WSLs) is common among orthodontic patients. Several measures have been introduced to prevent and remineralize the lesions. Casein phosphopeptide-amorphous calcium phosphate (CPP-ACP) is used for both prevention and remineralization. The effect of its application before bonding is controversial. This systematic review was conducted to investigate the most up to date available literature regarding the effect of CPP-ACP enamel pre-treatment on shear bond strength (SBS) of metallic orthodontic brackets. Methods A search was conducted in electronic databases (MEDLINE (via PubMed), Scopus, Cochrane Library, Web of Science and Google scholar (grey literature)) up to March 29th, 2023. The inclusion criteria included in vitro studies comparing the SBS of metal orthodontic brackets following pre-treatment of enamel using CPP-ACP versus control. The exclusion criteria included study types other than in vitro studies, studies conducted on non-human enamel, or studies using CPP-ACP in combination with another intervention. The included studies were analysed by two reviewers, independently. The risk of bias assessment was done using a modified risk of bias tool. A Meta-analysis was performed. I2 values and Q-test were used for assessment of heterogeneity. Results were displayed in forest plots with a random-effects model. Standardized mean difference, standard error (SE) and 95% confidence intervals were calculated for all studies. Results The search resulted in 76 articles. After duplicate removal and assessment for eligibility, 15 studies were included in the review. High statistical heterogeneity was found among the included studies using I2 values and Q-Test (I2 = 95.147%; Q = 288.456; df = 14; P