Search

The two-term infiltration equation (Formula presented.) is commonly used to determine the sorptivity, (Formula presented.) (Formula presented.), and product, (Formula presented.) (Formula presented.), of the dimensionless multiple (Formula presented.) and saturated soil hydraulic conductivity (Formula presented.) (Formula presented.) from cumulative vertical infiltration measurements (Formula presented.) (L) at times (Formula presented.) (T). This reduced form of the quasi-analytical power series solution of Richardson's equation of Philip enjoys a solid physical underpinning but at the expense of a limited time validity. Using simulated infiltration data, Jaiswal et al. have shown this time validity to equal about 2.5 cm of cumulative infiltration. The goals of this work are twofold. First, we investigate the extent to which cumulative infiltration measurements larger than 2.5 cm bias the estimates of (Formula presented.) and (Formula presented.). Second, we investigate the impact of epistemic errors on the inferred time validities and parameters. Partial infiltration curves up to 2.5 cm of cumulative vertical infiltration improve substantially the agreement between actual and least squares estimates of (Formula presented.) and (Formula presented.). But this only holds if the data generating infiltration process follows Richardson's equation and experimental conditions satisfy assumptions of soil homogeneity and a uniform initial water content. Otherwise, autocorrelated cumulative infiltration residuals will bias the least squares estimates of (Formula presented.) and (Formula presented.). Our findings reiterate and reinvigorate earlier conclusions of Haverkamp et al. and show that epistemic errors deteriorate the physical significance of the coefficients of infiltration functions. As a result, the parameters of infiltration functions cannot simply be used in storm water and vadose zone flow models to forecast runoff and recharge at field and landscape scales unless these predictions are accompanied by realistic uncertainty bounds. We conclude that the time validity of Philip's two-term equation is an elusive theoretical quantity with arbitrary physical meaning.

Despite previous reports on European growing seasons lengthening due to global warming, evidence shows that this trend has been reversing in the past decade due to increased transpiration needs. To asses this, we used an innovative method along with space-based observations to determine the timing of greening and dormancy and then to determine existing trends of them and causes. Early greening still occurs, albeit at slower rates than before. However, a recent (2011–2020) shift in the timing of dormancy has caused the season length to decrease back to 1980s levels. This shortening of season length is attributed primarily to higher atmospheric water demand in summer that suppresses transpiration even for soil moisture levels as of previous years. Transpiration suppression implies that vegetation is unable to meet the high transpiration needs. Our results have implications for future management of European ecosystems (e.g., net carbon balance and water and energy exchange with atmosphere) in a warmer world.

Many different equations have been proposed to describe quantitatively one-dimensional soil water infiltration. The unknown coefficients of these equations characterize soil hydraulic properties and may be estimated from a n record, (Formula presented.), of cumulative infiltration measurements using curve fitting techniques. The two-term infiltration equation, (Formula presented.), of Philip has been widely used to describe measured infiltration data. This function enjoys a solid mathematical–physical underpinning and admits a closed-form solution for the soil sorptivity, S [L T−1/2], and multiple, c [−], of the saturated hydraulic conductivity, Ks [L T−1]. However, Philip's two-term equation has a limited time validity, tvalid [T], and thus cumulative infiltration data, (Formula presented.), beyond (Formula presented.) will corrupt the estimates of S and Ks. This paper introduces a novel method for estimating S, c, Ks, and tvalid of Philip's two-term infiltration equation. This method, coined parasite inversion, use as vehicle Parlange's three-parameter infiltration equation. As prerequisite to our method, we present as secondary contribution an exact, robust and efficient numerical solution of Parlange's infiltration equation. This solution admits Bayesian parameter estimation with the DiffeRential Evolution Adaptive Metropolis (DREAM) algorithm and yields as byproduct the marginal distribution of Parlange's β parameter. We evaluate our method for 12 USDA soil types using synthetic infiltration data simulated with HYDRUS-1D. An excellent match is observed between the inferred values of S and Ks and their “true” values known beforehand. Furthermore, our estimates of c and tvalid correlate well with soil texture, corroborate linearity of the (Formula presented.) relationship for (Formula presented.), and fall within reported ranges. A cumulative vertical infiltration of about 2.5 cm may serve as guideline for the time-validity of Philip's two-term infiltration equation.

Reliable and highly resolved information about onshore wind energy potential (WEP) is essential for expanding renewable energy to eventually achieve carbon neutrality. In this pilot study, simulated 60 m wind speeds (ws60m) from a km‐scale, convection‐permitting 3.3 km‐resolution ICON‐LAM simulation and often‐used 31 km‐resolution ERA5 reanalysis are evaluated at 18 weather masts. The estimated ICON‐LAM and ERA5 WEPs are then compared using an innovative approach with 1.8 million eligible wind turbine placements over southern Africa. Results show ERA5 underestimates ws60m with a Mean Error (ME) of −1.8 m s−1 (−27%). In contrast, ICON‐LAM shows a ME of −0.1 m s−1 (−1.8%), resulting in a much higher average WEP by 48% compared to ERA5. A combined Global Wind Atlas‐ERA5 product reduces the ws60m underestimation of ERA5 to −0.3 m s−1 (−4.7%), but shows a similar average WEP compared to ERA5 resulting from the WEP spatial heterogeneity. Plain Language Summary: Onshore wind energy is expected to play a major role in the global energy transition. However, reliable and highly resolved information on the onshore wind energy potential (WEP) crucial for expansion planning is missing over southern Africa. This study evaluated high resolution 3.3 km ICON‐LAM atmospheric simulations and 31 km ERA5 reanalysis against 60 m wind speed (ws60m) observations and compared the corresponding derived WEPs. The results show that ERA5 underestimates ws60m by 27%, resulting in a 48% lower WEP assessment than ICON‐LAM, whose ws60m simulation results show a very small bias. Underestimation of wind energy yields may hinder further expansion of wind energy, as less economic performance is expected, which underlines the importance of highly resolved weather data. Key Points: Simulated ERA5 and km‐scale ICON‐LAM wind speeds are evaluated and corresponding southern Africa wind energy potentials are calculatedERA5 underestimates 60 m wind speed, whereas ICON‐LAM produces lower biases in the wind speed simulationsHigher wind energy potentials are revealed from wind speeds simulated by ICON‐LAM compared to ERA5, which is often used for such assessments [ABSTRACT FROM AUTHOR]

This comment challenges the perspective of Gao et al. (2023) that is rejecting the role of soil processes in hydrology. We argue that the authors present a false dichotomy between soil-centric and ecosystem-centric views. These two views of hydrology are complementary and reflect on the inherent multiscale complexity of hydrology where soil processes dominate at certain scales but other processes may become important at the catchment scale. We recognize the need for a new scale-aware framework that reconciles the interplay between soil processes at small scales with emergent behaviors driven by vegetation, topography, and climate at large scales. [ABSTRACT FROM AUTHOR]

Electromagnetic (EM) coupling effects including both inductive and capacitive coupling have long been an essential problem in broad-band spectral electrical impedance tomography (sEIT) measurements at the field scale. Efforts have been made to remove EM coupling numerically or to suppress the effects by modified data acquisition strategies. For near-surface applications with relatively small survey layouts, inductive coupling can be well removed in the mHz to kHz frequency range. With the use of shielded coaxial cables and so-called active electrodes where the amplifiers are mounted at the electrodes, capacitive coupling in sEIT measurements can also be reduced. However, it remains challenging to cope with capacitive coupling between the cable shield and the ground, especially in resistive field conditions. The aim of this study is to deal with this type of capacitive coupling effect by identifying and filtering out sEIT measurements that are strongly affected by capacitive coupling. Based on a correction method for capacitive coupling proposed in a previous study, an approach to estimate measurement errors due to capacitive coupling is presented first. In the second step, a workflow was proposed to calculate the capacitive coupling strength (CCS) for each electrode configuration, which is defined as the ratio of the imaginary part of the impedance induced by capacitive coupling and the imaginary part of the impedance due to the subsurface electrical conductivity. In the final step, measurements with low CCS were selected for inversion and the results were compared with inversion results obtained using the previously developed correction approach. It was found that the filtering method based on CCS is more capable in tackling capacitive coupling compared to using model-based corrections. Spectrally consistent sEIT results up to kHz were obtained using the newly developed filtering method, which were not achieved in previous work using model-based correction. [ABSTRACT FROM AUTHOR]

Plant water uptake and plant and soil water status are important for the soil water balance and plant growth. They depend on atmospheric water demand and the accessibility of soil water to plant roots, which is in turn related to the hydraulic properties of the root system and the soil around root segments. We present a simulation model that describes water flow in the soil–plant system mechanistically considering both root and soil hydraulic properties. We developed an approach to upscale three‐dimensional (3D) flow in the soil toward root segments of a 3D root architecture to a model that considers one‐dimensional flow between horizontal soil layers and radial flow to root segments in that layer. The upscaled model couples upscaled linear flow equations in the root system with an analytical solution of the nonlinear radial flow equation between the soil and roots. The upscaled model avoids simplifying assumptions about root hydraulic properties and water potential drops near roots made in, respectively, soil‐ and root‐centered models. Xylem water potentials and soil–root interface potentials are explicitly simulated and show, respectively, large variations with depth and large deviations from bulk soil water potentials under dry soil conditions. Accounting for hydraulic gradients in the soil around root segments led to an earlier but slower reduction of transpiration during a drought period and a better plant water status with higher nighttime plant water potentials. Core Ideas: Root water uptake depends on root and soil hydraulic properties.Water uptake at root element scale was upscaled to the root system scale.The upscaled model can be implemented in one‐dimensional soil water flow models.Low conductance of dry soil prevents low nighttime plant water potentials. [ABSTRACT FROM AUTHOR]

Renewable energy is recognized in Africa as a means for climate change mitigation, but also to provide access to electricity in sub‐Saharan Africa, where three‐quarters of the global population without electricity resides. Reliable and highly resolved renewable energy potential (REP) information is indispensable to support power plants expansion. Existing atmospheric data sets over Africa that are used for REP estimates are often characterized by data gaps, or coarse resolution. With the aim to overcome these challenges, the ICOsahedral Nonhydrostatic (ICON) Numerical Weather Prediction (ICON‐NWP) model in its Limited Area Mode (ICON‐LAM) is implemented and run over southern Africa in a hindcast dynamical downscaling setup at a convection‐permitting 3.3 km horizontal resolution. The simulation time span covers contrasting solar and wind weather years from 2017 to 2019. To assess the suitability of the novel simulations for REP estimates, the simulated hourly 10 m wind speed (sfcWind) and hourly surface solar irradiance (rsds) are extensively evaluated against a large compilation of in situ observations, satellite, and composite data products. ICON‐LAM reproduces the spatial patterns, temporal evolution, the variability, and absolute values of sfcWind sufficiently well, albeit with a slight overestimation and a mean bias (mean error (ME)) of 1.12 m s−1 over land. Likewise the simulated rsds with an ME of 50 W m−2 well resembles the observations. This new ICON simulation data product will be the basis for ensuing REP estimates that will be compared with existing lower resolution data sets. Plain Language Summary: There are still approximately 580 million people in Africa without reliable electricity supply. Renewable energy is broadly accepted as an important solution for Africa to fill the power supply gap and to mitigate climate change. Renewable energy potential (REP) information is thereby imperative for the expansion of renewable energy power planning. With conventional REP estimates, challenges are often linked to the meteorological input data, due to either the relatively coarse spatial resolution, data gaps in space and time, or data quality in general. In this study, we implemented and ran the atmospheric model ICOsahedral Nonhydrostatic (ICON) from the German Weather Service and partners at 3 km high‐resolution. The renewable energy variables wind speed and solar irradiance from these simulations are evaluated against an extensive in situ observations data set, as well as satellite, and other composite data products. In a comparison with more than 200 stations from three different in situ observation networks, it can be shown that ICON can reproduce REP‐related variables with a level of sophistication that the data is likely to offer added value over conventional inputs to REP assessments. The study is an example on how numerical models can fill in gaps in data‐scarce regions to produce useable information. Key Points: A new convection‐permitting regional ICOsahedral Nonhydrostatic (ICON) model setup over southern Africa is presented and evaluatedThe spatially and temporally highly resolved ICON wind and solar fields are inputs for improved renewable energy potential estimatesICON outputs agree well with hourly in situ observations and satellite data; wind speeds are slightly overestimated [ABSTRACT FROM AUTHOR]

Land surface models (LSMs) are an important tool for advancing our knowledge of the Earth system. LSMs are constantly improved to represent the various terrestrial processes in more detail. High-quality data, freely available from various observation networks, are being used to improve the prediction of terrestrial states and fluxes of water and energy. To optimize LSMs with observations, data assimilation methods and tools have been developed in the past decades. We apply the coupled Community Land Model version 5 (CLM5) and Parallel Data Assimilation Framework (PDAF) system (CLM5-PDAF) for 13 forest field sites throughout Europe covering different climate zones. The goal of this study is to assimilate in situ soil moisture measurements into CLM5 to improve the modeled evapotranspiration fluxes. The modeled fluxes will be evaluated using the predicted evapotranspiration fluxes with eddy covariance (EC) systems. Most of the sites use point-scale measurements from sensors placed in the ground; however, for three of the forest sites we use soil water content data from cosmic-ray neutron sensors, which have a measurement scale closer to the typical land surface model grid scale and EC footprint. Our results show that while data assimilation reduced the root-mean-square error for soil water content on average by 56 % to 64 %, the root-mean-square error for the evapotranspiration estimation is increased by 4 %. This finding indicates that only improving the soil water content (SWC) estimation of state-of-the-art LSMs such as CLM5 is not sufficient to improve evapotranspiration estimates for forest sites. To improve evapotranspiration estimates, it is also necessary to consider the representation of leaf area index (LAI) in magnitude and timing, as well as uncertainties in water uptake by roots and vegetation parameters. [ABSTRACT FROM AUTHOR]