Search

NT experiments have demonstrated core performance on par with positive triangularity (PT) H-mode without edge-localized modes (ELMs), encouraging further study of an NT reactor core. In this work, we use integrated modeling to scope the operating space around two NT reactor strategies: a high-field, compact fusion pilot plant concept and a low field, high aspect ratio concept. By integrating equilibrium, core transport, and edge ballooning instability models, we establish a range of operating points with less than 50 MW scrape-off layer power and fusion power comparable to positive triangularity (PT) H-mode reactor concepts. Heating and seeded impurities are leveraged to accomplish the same fusion performance and scrape-off layer exhaust power for various pressure edge boundary conditions. Scans over these pressure edge conditions accommodate any current uncertainty of the properties of the NT edge and show that the performance of an NT reactor will be extremely dependent on the edge pressure. The high-field case is found to enable lower scrape-off layer power because it is capable of reaching high fusion powers at a relatively compact size, which allows increased separatrix density without exceeding the Greenwald density limit. An increase in fusion power density is seen at weaker NT. Infinite-n ballooning instability models indicate that an NT reactor core can reach fusion powers comparable to leading PT H-mode reactor concepts while remaining ballooning-stable. Seeded krypton is leveraged to further lower scrape-off layer power since NT does not have a requirement to remain in H-mode. We contextualize the NT reactor operating space by comparing to popular PT H-mode reactor concepts, and find that NT exhibits competitive ELM-free performance with these concepts for a variety of edge conditions while maintaining relatively low scrape-off layer power., Comment: 23 pages, 14 figures. Submitted to Plasma Physics and Controlled Fusion Special Issue on Advances in the Physics Basis of Negative Triangularity Tokamaks

A plasma scenario with negative triangularity (NT) shaping is achieved on MAST-U for the first time. While edge localized modes (ELMs) are eventually suppressed as the triangularity is decreased below $\delta$ < -0.06, an extended period of H-mode operation with Type-III ELMs is sustained at less negative $\delta$ even through access to the second stability region for ideal ballooning modes is closed. This documents a qualitative difference from the ELM-free access conditions documented in NT scenarios on conventional aspect ratio machines. The electron temperature at the pedestal top drops across the transition to ELM-free operation, but a steady rise in core temperature as $\delta$ is decreased allows for similar normalized beta in the ELM-free NT and H-mode positive triangularity shapes.

The MANTA (Modular Adjustable Negative Triangularity ARC-class) design study investigated how negative-triangularity (NT) may be leveraged in a compact, fusion pilot plant (FPP) to take a ``power-handling first" approach. The result is a pulsed, radiative, ELM-free tokamak that satisfies and exceeds the FPP requirements described in the 2021 National Academies of Sciences, Engineering, and Medicine report ``Bringing Fusion to the U.S. Grid". A self-consistent integrated modeling workflow predicts a fusion power of 450 MW and a plasma gain of 11.5 with only 23.5 MW of power to the scrape-off layer (SOL). This low $P_\text{SOL}$ together with impurity seeding and high density at the separatrix results in a peak heat flux of just 2.8 MW/m$^{2}$. MANTA's high aspect ratio provides space for a large central solenoid (CS), resulting in ${\sim}$15 minute inductive pulses. In spite of the high B fields on the CS and the other REBCO-based magnets, the electromagnetic stresses remain below structural and critical current density limits. Iterative optimization of neutron shielding and tritium breeding blanket yield tritium self-sufficiency with a breeding ratio of 1.15, a blanket power multiplication factor of 1.11, toroidal field coil lifetimes of $3100 \pm 400$ MW-yr, and poloidal field coil lifetimes of at least $890 \pm 40$ MW-yr. Following balance of plant modeling, MANTA is projected to generate 90 MW of net electricity at an electricity gain factor of ${\sim}2.4$. Systems-level economic analysis estimates an overnight cost of US\$3.4 billion, meeting the NASEM FPP requirement that this first-of-a-kind be less than US\$5 billion. The toroidal field coil cost and replacement time are the most critical upfront and lifetime cost drivers, respectively.

A new burn control scheme for tokamaks is described where the total fusion power is controlled by adjusting the plasma volume fraction that is packed into power dense regions. In an example spherical tokamak burning plasma, by modifying the plasma edge squareness the total fusion power is doubled at almost constant total plasma volume and fusion power density. Therefore, increased plasma squareness could be extremely beneficial to a fusion reactor and squareness control could be desirable for power load balancing. Experiments have observed the impact of increased edge squareness on modified core plasma volume, highlighting the practical relevance of this approach., Comment: 7 pages, 7 figures

Strongly-shaped diverted negative triangularity (NT) plasmas in the DIII-D tokamak demonstrate simultaneous access to high normalized current, pressure, density, and confinement. NT plasmas are shown to exist across an expansive parameter space compatible with high fusion power production, revealing surprisingly good core stability properties that compare favorably to conventional positive triangularity plasmas in DIII-D. Non-dimensionalizing the operating space, edge safety factors below 3, normalized betas above 3, Greenwald density fractions above 1, and high-confinement mode (H-mode) confinement qualities above 1 are simultaneously observed, all with a robustly stable edge free from deleterious edge-localized mode instabilities. Scaling of the confinement time with engineering parameters reveals at least a linear dependence on plasma current although with significant power degradation, both in excess of expected H-mode scalings. These results increase confidence that NT plasmas are a viable approach to realize fusion power and open directions for future detailed study.

In magnetic confinement fusion devices, the ratio of the plasma pressure to the magnetic field energy, $\beta$, can become sufficiently large that electromagnetic microinstabilities become unstable, driving turbulence that distorts or reconnects the equilibrium magnetic field. In this paper, a theory is proposed for electromagnetic, electron-driven linear instabilities that have current layers localised to mode-rational surfaces and binormal wavelengths comparable to the ion gyroradius. The model retains axisymmetric toroidal geometry with arbitrary shaping, and consists of orbit-averaged equations for the mode-rational surface layer, with a ballooning space kinetic matching condition for passing electrons. The matching condition connects the current layer to the large scale electromagnetic fluctuations, and is derived in the limit that $\beta$ is comparable to the square root of the electron-to-ion-mass ratio. Electromagnetic fluctuations only enter through the matching condition, allowing for the identification of an effective $\beta$ that includes the effects of equilibrium flux surface shaping. The scaling predictions made by the asymptotic theory are tested with comparisons to results from linear simulations of micro-tearing and electrostatic microinstabilities in MAST discharge #6252, showing excellent agreement. In particular, it is demonstrated that the effective $\beta$ can explain the dependence of the local micro-tearing mode (MTM) growth rate on the ballooning parameter $\theta_0$ -- possibly providing a route to optimise local flux surfaces for reduced MTM-driven transport., Comment: 29 pages, 14 figures