Search

• Carbonate cements and chlorite can alter some pore spaces from water-wet to oil-wet. • High oil saturation occurred in tight reservoirs with moderate carbonates or chlorite. • The high quality reservoirs mainly located in between with sandstone-mudstone interfaces and central parts of the sand bodies. Oil accumulation, being difficult and complicated, is an important issue in petroleum exploration researches. Authigenic minerals, such as carbonate cements and chlorite, can in certain reservoirs alter the wettability of some pore spaces from water-wet to oil-wet. Generally, these oil-wet pore spaces are favorable for oil accumulation. The alteration of reservoir wettability induced by authigenic minerals and the impacts on oil accumulation in tight sandstone reservoirs were investigated using a suite of mineralogical and geochemical characterization techniques, including thin section observation, SEM-EDS, XRD, QEMSEM, CL, quantitative grain fluorescence (QGF), fluorescence spectral analysis, contact angle measurement and sealed coring oil saturation testing on the fourth member of the Lower Cretaceous Quantou Formation (K 1 q 4) in the southern Songliao Basin, China. The study shows that the tight sandstone reservoirs are compositionally immature with detrital grains distributed homogeneously. Quartz, carbonates and clay minerals that show heterogeneous distribution characteristics are the major authigenic minerals in some parts of the intergranular pores. The detrital mineral assemblage suggests that the reservoir rocks at deposition and before diagenesis had characterized by strong water-wet properties. With the development of authigenic minerals, carbonate cements and authigenic chlorite tend to alter the wettability of some parts of the existing pore spaces from water-wet to oil-wet. In the K 1 q 4 sandstone reservoirs, oil prefers to accumulate in the cemented residual pore spaces around carbonate cements and chlorite. Reservoirs containing about 4–5% carbonate cements are suggested to be more preferable to oil accumulation. These reservoirs are mainly located between sandstone-mudstone interfaces and central parts of the sand bodies. Chlorites have mainly two effects: on one hand, chlorite alters the wettability of existing pore spaces and provides preferential accumulation sites for oil in the tight sandstone reservoirs, on the other hand it can reduce the adhesion of oil through forming "clay-oil flocs" and promote further migration. Consequently, the reservoirs with moderate amount of carbonate cements or chlorite always show relative high oil saturation in the K 1 q 4 tight sandstones. [ABSTRACT FROM AUTHOR]

Pore-throat size is a very crucial factor controlling the reservoir quality and oiliness of tight sandstones, which primarily affects rock-properties such as permeability and drainage capillary pressure. However, the wide range of size makes it difficult to understand their distribution characteristics as well as the specific controls on reservoir quality and oiliness. In order to better understand about pore-throat size distribution, petrographic, scanning electron microscopy (SEM), pressure-controlled mercury injection (PMI), rate-controlled mercury injection (RMI), quantitative grain fluorescence (QGF) and environmental scanning electron microscopy (ESEM) investigations under laboratory pressure conditions were performed on a suite of tight reservoir from the fourth member of the Lower Cretaceous Quantou Formation (K 1 q 4 ) in the southern Songliao Basin, China. The sandstones in this study showed different types of pore structures: intergranular pores, dissolution pores, pores within clay aggregates and even some pores related to micro fractures. The pore-throat sizes vary from nano- to micro-scale. The PMI technique views the pore-throat size ranging from 0.001 μm to 63 μm and revealed that the pore-throats with radius larger than 1.0 μm are rare and the pore-throat size distribution curves show evident fluctuations. RMI measurements indicated that the pore size distribution characteristics of the samples with different porosity and permeability values look similar. The throat size and pore throat radius ratio distribution curves had however significant differences. The overall pore-throat size distribution of the K 1 q 4 tight sandstones was obtained with the combination of the PMI and RMI methods. The permeability is mainly contributed by a small part of larger pore-throats (less than 30%) and the ratio of the smaller pore-throats in the samples increases with decreasing permeability. Although smaller pore-throats have negligible contribution on reservoir flow potential, they are very significant for the reservoir storage capacity. The pore-throats with average radius larger than 1.0 μm mainly exist in reservoirs with permeability higher than 0.1mD. When the permeability is lower than 0.1mD, the sandstones are mainly dominated by pore-throats with average radius from 0.1 μm to 1.0 μm. The ratio of different sized pore-throats controls the permeability of the tight sandstone reservoirs in different ways. We suggest that splitting or organizing key parameters defining permeability systematically into different classes or functions can enhance the ability of formulating predictive models about permeability in tight sandstone reservoirs. The PMI combined with QGF analyses indicate that oil emplacement mainly occurred in the pore-throats with radius larger than about 0.25–0.3 μm. This result is supported by the remnant oil micro-occurrence evidence observed by SEM and ESEM. [ABSTRACT FROM AUTHOR]

The tight sandstones of the Cretaceous Quantou formation are the main exploration target for hydrocarbons in the southern Songliao basin. Authigenic quartz is a significant cementing material in these sandstones, significantly reducing porosity and permeability. For efficient predicting and extrapolating the petrophysical properties within these tight sandstones, the quartz cement and its origin need to be better understood. The tight sandstones have been examined by a variety of methods. The sandstones are mostly lithic arkoses and feldspathic litharenites, compositionally immature with an average framework composition of Q 43 F 26 L 31 , which are characterized by abundant volcanic rock fragments. Mixed-layer illite/smectite (I/S) ordered interstratified with R = 1 and R = 3 is the dominating clay mineral in the studied sandstone reservoirs. Two different types of quartz cementation modes, namely quartz grain overgrowth and pore-filling authigenic quartz, have been identified through petrographic observations, CL and SEM analysis. Homogenization temperatures of the aqueous fluid inclusions indicate that both quartz overgrowths and pore-filling authigenic quartz formed with a continuous process from about 70 °C to 130 °C. Sources for quartz cement produced are the conversion of volcanic fragments, smectite to illite reaction and pressure solution at micro stylolites. Potassium for the illitization of smectite has been sourced from K-feldspar dissolution and albitization. Silica sourced from K-feldspars dissolution and kaolinite to illite conversion is probably only minor amount and volumetrically insignificant. The internal supplied silica precipitate within a closed system where the transport mechanism is diffusion. The quartz cementation can destroy both porosity and permeability, but strengthen the rock framework and increase the rock brittleness effectively at the same time. [ABSTRACT FROM AUTHOR]

Understanding reservoir heterogeneity and associated diagenesis, have a paramount importance for efficient petroleum exploration and development strategies. Diagenetic variations and factors that control these processes have, therefore, been investigated in this study using petrographic and geochemical methods, including cathodoluminescence, scanning electron microscopy, x-ray fluorescence, electron probe microanalyses and stable isotope analysis. Mechanical compaction and chemical diagenesis trends have obviously varied as a function of rock types and geological locations. The conglomerate reservoirs with high content of tuffaceous matrix and characterized by poor sorting showed stronger compaction. The tuffaceous matrix displays a large degree of dissolution during the progressive burial diagenesis due to its thermodynamic instability. The tuffaceous matrix in Na-rich conglomerate reservoir rocks mainly transformed into analcite, while it transformed into illite in K-rich conglomerate reservoir rocks. In most conglomerate reservoirs far away from deep-rooted faults, calcite cements are indicated to have been sourced from the decarboxylation of organic matter in the interbedded mudstones. Carbonate cements in conglomerate reservoirs near the deep-rooted faults possibly formed from hydrothermal fluids or thermochemical oxidation of pre-existing methane accumulations. This study can serve us an excellent example for the control of sediment composition and paleo-fluid evolution on diagenetic variations in fan-delta conglomerate reservoirs. • Compaction and dissolution in conglomerate reservoirs were controlled by sediment composition and texture. • Authigenic silicoaluminate minerals formation in conglomerate reservoirs were controlled by sediment composition. • Carbonate cements formation in conglomerate reservoirs were controlled by paleo-fluids evolution. [ABSTRACT FROM AUTHOR]

The Eocene sandstones in the northern Dongying Sag, Bohai Bay Basin, China, are reservoirs for large accumulations of hydrocarbons. The sandstones are mainly lithic arkoses and feldspathic litharenites, texturally and compositionally immature. These sandstones have a wide range of porosity (0.4–37%) and permeability (0.004–6969 mD) and show an overall decrease in reservoir quality from 1500 m to 5000 m below sea level. The reduction in reservoir quality is a product of several digenetic processes; these include compaction, precipitation of dolomite and calcite in eodiagenetic stage; compaction, feldspar dissolution, precipitation of quartz cements and clays (kaolin and illite) and precipitation of ferrocalcite and ankerite in mesodiagenetic stage. Mineral distribution pattern and isotopic composition suggest carbonate cements in sandstones originate from sources outside the sandstones. Carbonate cementation, together with compaction reduced the sandstones’ porosity and permeability significantly. In a sandstone bed, marginal sandstones with distance to sandstone/mudstone interface less than one meter always have lower porosity than central sandstones. As burial depth exceeds 4000 m, marginal sandstones have very low porosities (<5%), indicating that thin sandstone beds (<2 m) were totally destroyed by cementation and compaction, and only thick sandstone beds (>2 m) can be potential effective reservoirs. Feldspar dissolution and precipitation of clays and quartz cements have little impact on absolute porosity. Mineral distribution pattern and quantitative data show that leached feldspars are the internal source of authigenic quartz and clays in sandstones, and the volume difference between feldspar secondary porosity and related authigenic cements is generally less than 0.25%. However, although there is little or no net import of matter to the sandstones, the pore architecture changes dramatically. Primary macropores are lost as clays and quartz precipitate while the proportion of microporosity increases, occurring mainly between clay crystals. The overall result is that permeability is significantly degraded. [ABSTRACT FROM AUTHOR]