Search

The Quick, Easy, Cheap, Effective, Rugged, and Safe (QuEChERS) method was applied to the extraction of 14 organochlorine pesticides (OCPs) residues from commercial fruit pulps available in supermarkets in Fortaleza, Northeastern Brazil. The analyses were carried out by gas chromatography (GC), coupled to an electron-capture detector (ECD), and were confirmed by GC-tandem mass spectrometry (MS). The parameters of the analytical method, such as accuracy, precision, linear range, limits of detection and quantification, were determined for each pesticide. The results showed good linearity (R2≥ 0.9916) and the overall average recoveries were considered satisfactory obtaining values between 69 and 110%, RSD of 2–15 %, except for hexachlorobenzene (HCB) in açai, acerola and guava pulp samples. The OCPs were detected in guava (α–HCH; lindane) and soursop (α, β–HCH isomers) samples. The QuEChERS method and GC–ECD were successfully used to analyze OCPs in commercially available Brazilian fruit pulps and can be applied in routine analytical laboratories. [ABSTRACT FROM AUTHOR]

Phenol is a toxic compound present in a wide variety of foundry resins. Its quantification is important for the characterization of the resins as well as for the evaluation of free contaminants present in foundry wastes. Two chromatographic methods, liquid chromatography with ultraviolet detection (LC-UV) and gas chromatography with flame ionization detection (GC-FID), for the analysis of free phenol in several foundry resins, after a simple extraction procedure (30 min), were developed. Both chromatographic methods were suitable for the determination of phenol in the studied furanic and phenolic resins, showing good selectivity, accuracy (recovery 99-100%; relative deviations <5%), and precision (coefficients of variation <6%). The used ASTM reference method was only found to be useful in the analysis of phenolic resins, while the LC and GC methods were applicable for all the studied resins. The developed methods reduce the time of analysis from 3.5 hours to about 30 min and can readily be used in routine quality control laboratories. [ABSTRACT FROM AUTHOR]

A SPME-GC-MS/MS method for the determination of eight organophosphorus pesticides (azinphos-methyl, chlorpyriphos, chlorpyriphos-methyl, diazinon, fenitrothion, fenthion, malathion, and methidathion) in still and fortified wine was developed. The extraction procedure is simple, solvent free, and without any sample pretreatment. Limits of detection (LOD) and quantitation (LOQ) values in the range 0.1-14.3 µg/L and 0.2-43.3 µg/L, respectively, were obtained. The LOQ values are below the maximum residue levels (MRLs) established by European Regulation for grapes, with the exception of methidathion. Coefficients of correlation (R2) higher than 0.99 were obtained for the majority of the pesticides, in all different wines analyzed. [ABSTRACT FROM AUTHOR]

Seven pyrethroids (bifenthrin, fenpropathrin, λ-cyhalothrin, permethrin, α-cypermethrin, fenvalerate, and deltamethrin) were extracted from water using C18 solid-phase extraction disks, followed by gas chromatography with an electron capture detector (GC-ECD) analysis. The limits of detection in water samples ranged from 0.5 ng L-1 (fenpropathrin) to 110 ng L-1 (permethrin), applying the calibration graph. The effects of different numbers of (re)utilizations of the same disks (up to four times with several concentrations) on the recoveries of the pyrethroids were considered. The recoveries were all between 70 and 120% after four utilizations of the same disk. There was no difference between these recoveries at a confidence level of 95%. [ABSTRACT FROM AUTHOR]