Search

In the present work, advanced aluminium metal matrix composite reinforced by nanomaterials is reported. The materials used for the experiments are AA6061 aluminium alloy, compounded with inorganic nanotubes (INT) and fullerene-like (IF) nanoparticles of WS 2 . Aluminium metal matrix composite with different weight percentage (0.1–0.5 wt%) of the INT and IF were prepared. Both the AA6061 aluminium and the aluminium metal matrix nanocomposites (MMCs) were re-melted by the stirring-casting method. Mechanical properties and microstructure analysis of the nano-MMCs were conducted. The measurements have shown that the hardness, yielding strength, ultimate tensile strength, and ductility were improved by up to 68% compared to the neat alloy for nanoparticles concentrations the range of 0.2 wt%. Metallography microstructure analysis showed that increasing the WS 2 INT or IF nanoparticles weight percentage in aluminium metal matrix composite, resulted in a more refined grains. The grain size of the composite matrix was reduced by up to 48.4% compared with that of neat AA6061 alloy ingot. Scanning electron microscope (SEM) analysis showed that addition of 0.5 wt% of WS 2 nanotubes into the Al matrix resulted in INT agglomeration which had deleterious effect on the tensile strength. The composite materials reinforcement mechanism was studied. This analysis showed that the improved mechanical properties of the metal nanocomposites can be predominantly attributed to the differences in thermal expansion coefficients of the WS 2 INT (or WS 2 IF nanoparticle) and the AA6061 alloy. [ABSTRACT FROM AUTHOR]

This study analyzes the effect of substitution of Ni for Zn on microstructure and mechanical properties of Mg–Gd–Y–Zn–Mn alloy. Our results show that the volume fraction of Mg5(Gd, Y) and (Mg, Zn)3RE phase decreased and LPSO phase increased with more substitution of Ni. After homogenization, only α-Mg and LPSO phase existed. In Mg–Gd–Y–Zn–Mn alloys, the LPSO phases mainly consisted of the 14H type. While in Mg–Gd–Y–Ni–Mn alloy, the LPSO phases consisted of the 18R type. In addition, compared with Mg–Gd–Y–Zn–Mn alloy, the mechanical properties of as-extruded Ni-substitution alloys were improved due to the better refinement of the size of grains and LPSO phases. The tensile strength in as-extruded Mg–Gd–Y–Ni–Mn alloy could reach up to 400 MPa with 18% of the elongation to failure. [ABSTRACT FROM AUTHOR]

Abstract: This study investigates the effects of heat treatment on the morphology of long-period stacking ordered phase (LPSO) and the corresponding mechanical properties of Mg–9Gd–xEr–1.6Zn–0.6Zr (1–4wt%) using optical microscopy, scanning electron microscopy, energy-dispersive X-ray spectrometry, X-ray diffraction, transmission electron microscopy, and tensile tests. The microstructure analysis of the as cast alloys showed that the volume fraction of the (Mg, Zn)3(Gd, Er) phase increased with increasing Er content. The (Mg, Zn)3(Gd, Er) phase in grain boundaries transformed into the 14H-LPSO phase Mg12Zn(Gd, Er) after heat treatment between 400°C and 515°C. The bulk shaped LPSO phases distributed along the grain boundaries produced isometric crystal grains in and enhanced the ductility of the as-extruded alloys. However, the lamellar LPSO phases precipitating in the grain interior induced strip-shaped grains in and improved the strength of the as-extruded alloys. [Copyright &y& Elsevier]