Search

Measles is the leading cause of death in infants, although a vaccine is available for its prevention. At this stage of measles elimination and eradication, it is so important to confirm clinically diagnosed measles cases in the laboratory but, developing countries have troubles in collecting and maintaining the cold chain of the specimens while transporting them to the laboratories. Therefore, filter papers are good candidates for simplification of specimen collection and transportation. In this research, the effects of the temperature, at which the dried specimens were kept, and the time duration the dried specimens were kept before being tested, were studied. Since there were not enough patients' oral fluid samples available, a nested reverse transcriptase PCR (RT-PCR) that detected measles virus (MV) from dried filter papers was set up using MV infected cells diluted in sterile phosphate-buffered saline (PBS). Dried specimens were stored at -25°C, 4°C, and room temperature for 1 day, 1, 2, and 3 weeks before being tested. This method was then applied to filter paper oral fluids collected from nine clinically diagnosed measles patients in Iran in 2010 which were tested after being kept at room temperature for 1 day, 1 and 3 weeks after preparation. The results showed that dried oral fluids on filter papers are reliable specimens for the detection of MV RNA using nested RT-PCR, but the nested RT-PCR results of low titer viruses dried onto filter papers are not reproducible and reliable., (© 2012 Wiley Periodicals, Inc.)

Poplar chips were pre-treated by Trametes versicolor for 1, 2 and 3 weeks. Pre-treated chips, after washing, have been air dried for kraft pulping to achieve pulp kappa number of about 20. Pulp samples have been analyzed by Bauer Mc Nett, Kajaani analyzer and SEM. The results indicated that fungi pre-treatment of chips can degrade lignin and carbohydrates and affect kraft pulping and fiber characteristics. Higher chemical charge in pulping, lower fine and higher long fiber fraction were observed in pre-treated pulp samples in comparison with others. Fiber length, cross sectional area, width, cell wall thickness and volume index were increased by increasing pre-treatment time while fine length, fiber coarseness and curl have been reduced. Based on the study findings, with respect to higher fiber length, lower fine, and lower fiber curl and coarseness, 2-weeks pre-treatment of chips was recommended to produce acceptable overall fiber properties in kraft pulping., (Copyright © 2010 Elsevier Ltd. All rights reserved.)

Organosolv pulping of bagasse was conducted following a central composite design using a two-level factorial plan involving three pulping variables (temperature: 190-210 degrees C, time: 120-180 min, organic solvent ratio: 40-60% dimethyl formamide). Responses of pulp and handsheets properties to the process variables were analyzed using statistical software (MINITAB 14). Using values of the independent variables the variation ranges considered provided the following optimum values of the dependent variables: 82.7% (yield), 92.9 (kappa number), 1.403% (ash), 370 ml (freeness), 6290 m (breaking length), 9.4 (folding endurance), 5.955 mN m2 g(-1) (Tear index) and 2.811 kN g(-1) (Burst index) for pulps and handsheets. Results showed that acceptable physical and mechanical properties of pulps and papers similar the pulp used for bleaching could be achieved at 210 degrees C for 150 min and 50% DMF. These are the most suitable conditions for obtaining paper sheets with a high breaking length, tear and burst indices. Also bagasse could be pulped with ease to about 55.72% yield with kappa number approximately 35. The cooking temperature was a significant factor while the DMF ratio and cooking time were not as important in term of the properties of the resultant pulps and papers.