Search

This paper presents fuzzy ${c}$ -means-based yield estimation (FUZYE), a methodology that reduces the time impact caused by Monte Carlo (MC) simulations in the context of analog integrated circuits (ICs) yield estimation, enabling it for yield optimization with population-based algorithms, e.g., the genetic algorithm (GA). MC analysis is the most general and reliable technique for yield estimation, yet the considerable amount of time it requires has discouraged its adoption in population-based optimization tools. The proposed methodology reduces the total number of MC simulations that are required, since, at each GA generation, the population is clustered using a fuzzy ${c}$ -means (FCMs) technique, and, only the representative individual (RI) from each cluster is subject to MC simulations. This paper shows that the yield for the rest of the population can be estimated based on the membership degree of FCM and RIs yield values alone. This new method was applied on two real circuit-sizing optimization problems and the obtained results were compared to the exhaustive approach, where all individuals of the population are subject to MC analysis. The FCM approach presents a reduction of 89% in the total number of MC simulations, when compared to the exhaustive MC analysis over the full population. Moreover, a ${k}$ -means-based clustering algorithm was also tested and compared with the proposed FUZYE, with the latest showing an improvement up to 13% in yield estimation accuracy. [ABSTRACT FROM AUTHOR]

The structure and trigger control strategy have become the most important factors that restrict the performance of the multistage synchronous induction coilgun (MSSICG). However, it is still a difficult task to design MSSICG under overload constraint due to coupling between the multiple parameters. In this paper, the maximization of the emission efficiency and acceleration stationarity is treated as a multiobjective optimization problem. By analyzing the relationship between the number of turns and the other structural parameters of the launch, the multiobjective optimization model of MSSICG is established by the current filament method which was verified by the experimental data and finite-element method. And then the second generation nondominated sorting genetic algorithm (NSGA-II) and multiobjective particle swarm optimization (MOPSO) were employed to optimize the model in order to maximize the energy transfer efficiency while achieving the smooth acceleration of the armature. With the formulated optimization model, a five-stage synchronous induction coilgun is optimized as a special case. A decision-making procedure based on the fuzzy membership function is used for obtaining best compromise solution from the set of Pareto-solutions obtained through NSGA-II and MOPSO. In addition, the optimization performance of the proposed multiobjective optimization model and the single-objective optimization model of the MSSICG was compared. The result of optimization shows that the proposed multiobjective optimization model of MSSICG can effectively improve the performance of the coilgun compared with the single-objective optimization model which takes of the launch velocity and overload acceleration as the combination objective function or only the launch velocity. [ABSTRACT FROM PUBLISHER]

A novel optimization-enabled electromagnetic transient simulation approach is proposed for calculating the resistor setting of a multistage impulse generator for insulation impulse testing of high-voltage transformers. This approach enables test engineers to overcome most of the major challenges attributed to the use of conventional trial-and-error methods for determining resistor settings, including the excessive time consumption and the potential damage to the test transformer due to a greater number of trial tests. The proposed method uses the frequency response of the test transformer to synthesize a circuit model for it. The test setup, including the test transformer and the impulse generator, is simulated using an electromagnetic-transients-type simulator. A genetic-algorithm-based approach is used to optimize the setting of the impulse generator. Optimized resistor values are then used in impulse testing of a three-phase power transformer. Different cases of impulse generator resistor arrangements are studied in this paper and simulated waveforms are compared with those obtained from measurements. [ABSTRACT FROM AUTHOR]