Search

The consequent-pole (CP) Vernier permanent-magnet (VPM) machine has been developed over the last decade. In VPM machine, the CP structure can produce considerable torque with a half volumn of the PMs compared with the regular structure, so the cost is reduced and the mechanical strength is increased. In this paper, an improvement of chamfering structure on a CPVPM machine is proposed to alleviate the flux leakage and increase the torque density. The chamfered structure is easily machined and will not influence the robustness of the rotor. The comparison results show that under the same volume and copper loss constraint, the proposed structure has smaller cogging torque, smaller torque ripple, larger torque density and larger power factor. [ABSTRACT FROM AUTHOR]

This article investigates the influences of end turn length on consequent-pole Vernier permanent-magnet (CPVPM) machines. Four structures are compared to discuss the tradeoff between the end turn length and the gear ratio, and nine structures are compared to discuss the tradeoff between the end turn length and the winding factor. It is found that, when the end turn length is taken into account, the CPVPM machines with concentrated winding have the potential to produce larger torque than those with the distributed winding. Motivated by the above observations, an integral slot concentrated winding CPVPM machine is proposed to be a promising candidate in VPM machine family, which has high torque capability, small end turn length, good fault tolerance, and desired power factor. The influences of key design parameters are investigated. The machine prototype is manufactured, and the electromagnetic performances are experimentally validated. [ABSTRACT FROM AUTHOR]

This article proposes a novel axially magnetized Vernier permanent-magnet (AMVPM) machine which has permanent magnets (PMs) clamped on both ends of the rotor with alternately magnetized directions. The topology improves the mechanical strength of the structure without weakening the electromagnetic performances. The detailed operating principles are described and the design parameters are optimized. The open-circuit back electromotive force (EMF) is calculated analytically by using the harmonic series expressions. Then, a comparison between the AMVPM machine and regular Vernier permanent-magnet (VPM) machine is analyzed by finite-element analysis (FEA) method. Finally, the machine prototype is manufactured and the electromagnetic performances are experimentally validated. [ABSTRACT FROM AUTHOR]

This article compares the electromagnetic performances of doubly salient permanent magnet (DSPM) machines with different stator iron core segments. Since the permanent magnets (PMs) of the DSPM machines studied in this article exist in pairs, the feasible numbers of PMs in the 12/8-pole DSPM machine are 12, 6, 4, and 2, and thus, the corresponding stator tooth number between two adjacent PMs is 1, 2, 3, and 6, respectively. Therefore, the stator iron core segments of the four DSPM machines have different shapes. Furthermore, to improve the average torque, PMs are inserted into the slots, and flux focusing teeth are adopted. All four machines are designed to achieve larger average torque under the fixed copper loss and envelope size. The comparison shows that the DSPM machine with two stator teeth between adjacent PMs exhibits the largest average torque and the smallest torque ripple. Moreover, the DSPM machine with six stator teeth between two adjacent PMs has the optimal PM utilization. To verify the predicted results, a 12/8-pole DSPM prototype with two stator teeth between adjacent PMs is manufactured and tested. [ABSTRACT FROM AUTHOR]