Search

We measured shear wave splitting from SKS data recorded by the transcontinental NECESSArray in NE China to constrain lithosphere deformation and sublithospheric flows beneath the area. We selected several hundreds of high quality SKS/SKKS waveforms from 32 teleseismic earthquakes occurring between 09/01/2009 and 08/31/2011 recorded by 125 broadband stations. These stations cover a variety of tectonic terranes, including the Songliao basin, the Changbaishan mountain range and Zhangguancai range in the east, the Great Xing'an range in the west and the Yanshan orogenic belt in the southwest. We assumed each station is underlaid by a single anisotropic layer and employed a signal-to-noise ratio (SNR) weighted multi-event stacking method to estimate the two splitting parameters (the fast polarization direction φ , and delay time, δt ) that gives the best fit to all the SKS/SKKS waveforms recorded at each station. Overall, the measured fast polarization direction lies more or less along the NW–SE direction, which significantly differs from the absolute plate motion direction, but is roughly consistent with the regional extension direction. This suggests that lithosphere deformation is likely the general cause of the observed seismic anisotropy. The most complicated anisotropic structure is observed beneath the southern Great Xing'an range and southwest Songliao basin. The observed large variations in splitting parameters and the seismic tomographic images of the area are consistent with ongoing lithospheric delamination beneath this region. [ABSTRACT FROM AUTHOR]

In order to better understand the deep subduction geometry of the Pacific plate and genesis of intraplate volcanism in northeast China (NE China), we computed a total of 45,505 receiver functions from 788 teleseismic events recorded by 255 stations (NECESSArray temporal and permanent stations) in NE China. We used a common-conversion-point stacking (CCP) method to generate a 3D reflectivity volume beneath the study area. To position the P-to-S conversions to the correct depths, we employed 3D crustal and mantle models as references to make time to depth conversion. The 3D reflectivity volume was generated in an area between 115°–135°E and 40°–49°N, in the depth range of 300 to 800 km. We found significant topographic relief on the 660-km discontinuity across the study area. In particular, in a westward Pacific plate subduction section between 40°N and ∼45.5°N, the 660-km discontinuity is depressed by as much as ∼30–40 km along the western extension of the deep seismicity. The depression is elongated along the strike of the deep seismicity and is confined to a 200–300 km region in the E–W direction of subduction. To the west of this depression the 660-km discontinuity is uplifted by 5–10 km in a rectangular area of ∼100 km by 200 km centered at about 125°E and 43°N. In the north, the 660-km discontinuity is moderately depressed (∼20 km) in a broad area that extends further west. The high and low regions in the 660-km topographic map correlate, respectively, with low- and high-velocity anomalies in the P- and S-wave tomographic velocity images at the same depth. Our results suggest that slab stagnation might not be occurring in the southern part of the NE China, where the Changbaishan volcanic complex is located, thus the magmatism is unlikely caused by dehydration of the flat-lying Pacific slab in the transition zone. The low velocity mantle upwelling arising from a gap of stagnant slabs is a likely source that feeds the volcanic complex in NE China. [ABSTRACT FROM AUTHOR]