Search

A flameless atomic absorption method for the coextraction of platinum and palladium from biological and environmental samples by high molecular weight amine (HMWA) is given. Also, methods for lead determination in biological samples by use of extraction flameless analysis and direct aspiration-flame analysis are reported. A study of lead contamination of Vacutainer tubes is given.

Nineteen samples of honey taken from grocery shelves, near zinc mines, adjacent to an industrial area, and near a major highway, and one sample collected in 1899 were subjected to spark source mass spectrometry to determine the concentration of most of 47 elements in the honey. Certain samples of honey produced by bees in the vicinity of the New York State Thruway appeared to contain elevated levels of certain elements known to be emitted by traffic, such as aluminum, barium, calcuim, copper, magnesium, nickel, palladium, and silicon, but the true source of these elements was uncertain. Honey that had come into contact with metal containers in processing contained the greatest amounts of zinc and tin.

Results of an epidemiology study of populations living near a freeway and in the high desert area of Southern California for levels of platinum, palladium and lead are presented. Three age groups (children, young adults, and mature adults) were sampled twice for blood, urine, hair, and feces. Air, water, and soil samples were collected in the areas of the residences of the two populations. The primary objective of this study was to obtain baseline levels of these metals prior to the introduction of the catalytic muffler. The samples were collected in September 1974.

Composition, microstructure, castability, mechanical properties, and heat treatment characteristics of two gold-palladium-silver-based alloys were studied. The materials exhibited compositional as well as microstructural differences. Clinically acceptable castings could not be obtained when manufacturers' recommended casting temperatures were used. Ultimate tensile strength, yield strength, modulus of elasticity, and Brinell hardness values for the alloys were comparable. The elastic limit of Cameo, however, was significantly higher than that of vivo-star. Maximum rehardening of annealed castings occurred on reheat treatment at temperatures between 1,200 and 1,300 F. As-cast specimens, however, were not heat hardenable. The sequence of heat treatments used in the application of porcelain reduced slightly the hardness of both alloys. Hardness of the metal substructures was not increased by return of porcelain-coated specimens to a 1,250 F oven for final heat treatment.