Search

• Experiments on the member buckling and ultimate strengths of cold-rolled aluminium alloy channel columns are performed. • The aluminium alloy 5052-H36 materials are used to fabricate the cold-rolled aluminium structural channel columns. • Non-linear FE models are developed using ABAQUS to simulate laboratory experiments and calibrated against the test results. • A parametric study based on FE models is performed to extend the data by varying cross-section dimensions and member lengths. • Experimental and numerical results are ued to calibrate the new design equations for cold-rolled aluminium alloy columns. The paper first presents the development of detailed finite element (FE) models for investigating the member capacity of cold-rolled aluminium alloy 5052-36 channel columns. The numerical non-linear FE models are developed using the commercial FE software package ABAQUS to simulate laboratory experiments and calibrated against the test results. The experimental program was performed by the authors at the University of Sydney and the detailed test results are fully described in a companion paper. The calibrated numerical FE models with actual mechanical properties and measured geometric imperfections in analyses accurately predict the experimental results and behaviours, including flexural and flexural-torsional buckling as well as local-global interaction buckling failure modes. A parametric study is subsequently performed to extend the data range by varying cross-section dimensions and member lengths. The effects of loading eccentricity positions and initial geometric imperfections are also considered in the parametric study. The experimental and numerical results are compared with design strength predictions from current Australian/New Zealand, American and European specifications for aluminium structures in the companion paper. In this paper, the Direct Strength Method (DSM) for the design of compression members as per the Australian/New Zealand standard AS/NZS 4600 for cold-formed steel structures is adopted for comparison. The DSM design rules for cold-formed steel compression members are found to provide more accurate predictions than those of current specifications for aluminium structures and therefore used to propose improved design equations for cold-rolled aluminium alloy columns. Finally, a reliability analysis is performed to evaluate the safety level of current design specifications and the proposed design rules. [ABSTRACT FROM AUTHOR]

• A series of compression tests to investigate member buckling behaviour and ultimate strengths of cold-rolled aluminium alloy channel columns are performed. • The aluminium alloy 5052-H36 materials are used to fabricate the cold-rolled aluminium structural channel columns. • The observed failure modes are flexural, flexural-torsional and local-global interaction buckling failure modes. • The experimental results are compared with predictions by current Australian/New Zealand, North American and European design specifications. Cold-rolled aluminium alloy sections have been recently introduced in Australia as newly developed thin-walled products. To fabricate these sections, the roll-forming process used in cold-formed steel production has been employed, which has proven to be more cost-effective than the conventional extrusion process. This paper describes a series of compression tests to investigate member buckling behaviour and ultimate strengths of cold-rolled aluminium alloy 5052-36 channel columns. Twenty-eight specimens of three commercially available sections (C10030, C25025 and C40030) were tested at the University of Sydney. Two configurations of end boundary conditions were specially designed to capture flexural, flexural-torsional and local-global interaction buckling failure modes. Prior to testing, initial geometric imperfections were measured using a laser scanning method, and flat/corner coupons were tested to determine compressive and tensile strengths of the aluminium alloy material. The experimental results are compared with ultimate column strength predictions by current Australian/New Zealand, North American and European design specifications for aluminium structures. Additionally, the test results provide data for calibration of finite element models of cold-rolled aluminium structural members for use in parametric and similar studies. A companion paper describes such parametric study and the derivation of new design guidelines for member buckling of cold-rolled aluminium channel columns based on the numerical parametric data and the experimental data presented herein. [ABSTRACT FROM AUTHOR]