Search

An amplitude modulator plays an essential role in the implementation of continuous-variable quantum key distribution (CVQKD), whereas it may bring about a potential security loophole in the practical system. The high-frequency modulation of the actual transmitter usually results in the high rate of the system. However, an imperfect amplitude modulator (AM) can give birth to a potential information leakage from the modulation of the transmitter. To reveal a potential security loophole from the high-frequency AM embedded in the transmitter, we demonstrate an influence on the practical security of the system in terms of the secret key rate and maximal transmission distance. The results indicate the risk of this security loophole in the imperfect AM-embedded transmitter. Fortunately, the legal participants can trace back the potential information leakage that has been produced from the imperfect transmitter at high frequencies, which can be used for defeating the leakage attack in CVQKD. We find the limitations of the imperfect AM-embedded transmitter of the high-frequency quantum system, and hence, we have to trade off the practical security and the modulation frequency of the AM-embedded transmitter while considering its implementation in a practical environment. [ABSTRACT FROM AUTHOR]

This paper proposes a programmable solar‐powered radio frequency (RF) transmitter. It employs a novel five‐layer structure that effectively integrates solar cells, active circuits, and broadband antenna. This design can directly emit RF signals without the need for additional power supply, enabling efficient energy conversion and transmission. In addition, a U‐shaped coupling line model is introduced to evaluate the performance of the active circuit. We fabricated a sample and measured it. The results of the measurements indicate that the proposed RF transmitter can achieve self‐powering and programmable output at any frequency within the range of 2.08–4.1 GHz, with an output power of no less than 14 dBm. Moreover, the solar cells are placed on both sides of the circuits and antenna for energy harvesting, achieving 100% sunlight insolation with a 75.5% coverage ratio. This design can be used for self‐powered green wireless system applications. [ABSTRACT FROM AUTHOR]

Localization of wireless transmitters is traditionally done using Radio Frequency (RF) sensors that measure the propagation delays between the transmitter and a set of anchor receivers. One of the major challenges of wireless localization systems is the need for anchor nodes to be time-synchronized to achieve accurate localization of a target node. Using a reference transmitter is an efficient way to synchronize the anchor nodes Over-The-Air (OTA), but such algorithms require multiple periodic messages to achieve tight synchronization. In this paper, we propose a new synchronization method that only requires a single message from a reference transmitter. The main idea is to use the Carrier Frequency Offset (CFO) from the reference node, alongside the Time of Arrival (ToA) of the reference node messages, to achieve tight synchronization. The ToA allows the anchor nodes to compensate for their absolute time offset, and the CFO allows the anchor nodes to compensate for their local oscillator drift. Additionally, using the CFO of the messages sent by the reference nodes and the target nodes also allow us to estimate the speed of the targets. The error of the proposed algorithm is derived analytically and is validated through controlled laboratory experiments. Finally, the algorithm is validated by realistic outdoor vehicular measurements with a software-defined radio testbed. [ABSTRACT FROM AUTHOR]

The ability to sense propagating electromagnetic plane waves based on their directions of arrival (DOAs) is fundamental to a range of radio frequency (RF) sensing, communications, and imaging applications. This paper introduces an algorithm for the wideband true time delay digital delay Vandermonde matrix (DVM), utilizing Thiran fractional delays that are useful for realizing RF sensors having multiple look DOA support. The digital DVM algorithm leverages sparse matrix factorization to yield multiple simultaneous RF beams for low-complexity sensing applications. Consequently, the proposed algorithm offers a reduction in circuit complexity for multi-beam digital wideband beamforming systems employing Thiran fractional delays. Unlike finite impulse response filter-based approaches which are wideband but of a high filter order, the Thiran filters trade usable bandwidth in favor of low-complexity circuits. The phase and group delay responses of Thiran filters with delays of a fractional sampling period will be demonstrated. Thiran filters show favorable results for sample delay blocks with a temporal oversampling factor of three. Thiran fractional delays of orders three and four are mapped to Xilinx FPGA RF-SoC technologies for evaluation. The preliminary results of the APF-based Thiran fractional delays on FPGA can potentially be used to realize DVM factorizations using application-specific integrated circuit (ASIC) technology. [ABSTRACT FROM AUTHOR]