Search

This work presents a miniaturized electromagnetic energy harvester (EMEH) based on two coils moving in a head-to-head permanent magnet tower. The two coils are separated by a set distance so that the applied force moves the EMEH from one equilibrium position to another. In this configuration, the harvester produces energy in two different working modes: when a force is applied to the moving part or when an external random acceleration is applied to the whole system. A custom test bench has been designed to characterize the behavior of this energy harvester under a variety of conditions encountered in wearable applications. Notably, at 10 Hz and 1.32 g RMS acceleration, our inertial EMEH demonstrates its capability to sustain a consistent output power of 1696 μW within a total volume of 22.39 cm3, showcasing its efficiency in environments with erratic stimuli typical of wearable and biomedical applications. The presented EMEH is compared with reported inertial EMEH structures to extract its design limitations as well as future improvements, situating the present work in a comprehensive state-of-the-art and defining a generic performance target for biomedical and wearable applications.

Colorimetric characterisation systems based on LEDs and RBG sensors are straightforward to implement, are highly integrable allowing for portable measurement systems and can be constructed using widespread and affordable components. They have already proved to be a satisfactory solution in several applications related to chemical analysis. In this paper, we present an RGB sensor-based prototype for colorimetric characterisation, which can accommodate cuvettes with optical paths of 10 mm and 40 mm. We assessed the impact of experimental condition parameters such as the variability of the analyte volume in the cuvette, as well as the presence of floating particles or deposits at the bottom of the cuvette. While these would not impact the result given by a spectrophotometer that generally has a directional light source, they must be considered in LED/RGB sensor analysers in which the light path is not tightly controlled. We demonstrated that there is a minimal sensor height above the bottom of the cuvette and a minimal analyte level (both depending on the prototype optical path length) above which the analyte volume and the presence of floating particles and deposits have no impact on the prototype output signal. Finally, based on these results, we proposed a test method for a quick dye-displacement assay, in which the reagent is a dye-loaded molecularly imprinted polymer that is poured directly into a cuvette.