Search

The Low-Level RF (LLRF) control circuits of linear accelerators (LINACs) are conventionally realized with heterodyne based architectures, which have analog RF mixers for up and down conversion with discrete data converters. We have developed a new LLRF platform for C-band linear accelerator based on the Frequency System-on-Chip (RFSoC) device from AMD Xilinx. The integrated data converters in the RFSoC can directly sample the RF signals in C-band and perform the up and down mixing digitally. The programmable logic and processors required for signal processing for the LLRF control system are also included in a single RFSoC chip. With all the essential components integrated in a device, the RFSoC-based LLRF control platform can be implemented more cost-effectively and compactly, which can be applied to a broad range of accelerator applications. In this paper, the structure and configuration of the newly developed LLRF platform will be described. The LLRF prototype has been tested with high power test setup with a Cool Cooper Collider (C\(^3\)) accelerating structure. The LLRF and the solid state amplifier (SSA) loopback setup demonstrated phase jitter in 1 s as low as 115 fs, which is lower than the requirement of C\(^3\). The rf signals from the klystron forward and accelerating structure captured with peak power up to 16.45 MW will be presented and discussed.

Photonic addressing of superconducting circuits has been proposed to overcome wiring complexity and heat load challenges, but superconducting-photonic links suffer from an efficiency-noise trade-off that limits scalability. This trade-off arises because increasing power conversion efficiency requires reducing optical power, which makes the converted signal susceptible to shot noise. We analyze this trade-off and find the infidelity of qubit gates driven by photonic signals scales inversely with the number of photons used, and therefore the power efficiency of the converter. While methods like nonlinear detection or squeezed light could mitigate this effect, we consider generating higher frequency electrical signals, such as millimeter-waves (100 GHz), using laser light. At these higher frequencies, circuits have higher operating temperatures and cooling power budgets. We demonstrate an optically-driven cryogenic millimeter-wave source with a power efficiency of $10^{-4}$ that can generate ${1}~\mathrm{\mu W}$ of RF power at 80 GHz with 1500 thermal photons of added noise at 4 K. Using this source, we perform frequency-domain spectroscopy of superconducting NbTiN resonators at 80-90 GHz. Our results show a promising approach to alleviate the efficiency-noise constraints on optically-driven superconducting circuits while leveraging the benefits of photonic signal delivery. Further optimization of power efficiency and noise at high frequencies could make photonic control of superconducting qubits viable at temperatures exceeding 1 kelvin., Comment: 14 pages, 8 figures

Ultrafast electron diffraction using MeV energy beams(MeV-UED) has enabled unprecedented scientific opportunities in the study of ultrafast structural dynamics in a variety of gas, liquid and solid state systems. Broad scientific applications usually pose different requirements for electron probe properties. Due to the complex, nonlinear and correlated nature of accelerator systems, electron beam property optimization is a time-taking process and often relies on extensive hand-tuning by experienced human operators. Algorithm based efficient online tuning strategies are highly desired. Here, we demonstrate multi-objective Bayesian active learning for speeding up online beam tuning at the SLAC MeV-UED facility. The multi-objective Bayesian optimization algorithm was used for efficiently searching the parameter space and mapping out the Pareto Fronts which give the trade-offs between key beam properties. Such scheme enables an unprecedented overview of the global behavior of the experimental system and takes a significantly smaller number of measurements compared with traditional methods such as a grid scan. This methodology can be applied in other experimental scenarios that require simultaneously optimizing multiple objectives by explorations in high dimensional, nonlinear and correlated systems.

A high-energy electron-positron collider has been widely recognized by the particle physics community to be the next crucial step for detailed studies of the Higgs boson and other fundamental particles and processes. Several proposals for such colliders, either linear or circular, are currently under evaluation. Any such collider will be required to reach high lumimosities, in order to collect enough data at a reasonable time scale, while at the same time coping with high rates of background particles produced from beam-beam interactions during the collisions. In this paper, we analyze the luminosity and beam-beam interaction characteristics of the Cool Copper Collider (C$^3$) and perform a comparison with other linear collider proposals. We conclude that C$^3$ can reach the same or higher collision rates as the other proposals, without having to cope with higher beam-induced background fluxes. Thus, C$^3$ emerges as an attractive option for a future electron-positron collider, benefiting from the collective advancements in beam delivery and final focus system technologies developed by other linear collider initiatives., Comment: 21 pages, 11 figures, 5 tables ; includes supplemental material. Accepted for publication in PRAB - Physical Review Accelerators and Beams