Search

Carbon nanotubes (CNTs) are promising blocks for building advanced yarns with unique structural and functional attributes. However, the complexity of fabrication and high cost has hindered the widespread adoption of CNT yarns. In this study, a rapid and continuous twisting wet spun yarn strategy to produce highly densified CNT yarns is presented. The method involves effectively dispersing CNTs in the surfactant dispersion, swiftly removing the surfactant in the coagulation bath and twisting treatment to effectively improve the density of yarn and the orientation of CNT. Detailed characterizations on the influence of each spinning conditions reveal that twisting treatment significantly enhances the packing density of yarns, improves the orientation of CNTs, and mitigates the impact of impurities on conductivity. The resulting CNT yarns exhibit a remarkable tensile strength of 600 MPa, a Young's modulus of ≈40 GPa, and a high conductivity of 8990 S cm−1. When utilized as a yarn heater, the CNT yarn demonstrates an ultra‐fast electrothermal response of over 1000 °C s−1 at a low operating voltage of 5 V. Impressively, the mechanical properties of CNT yarns show good stability during heating. This study provides a perspective of structural engineering for the large‐scale preparation of high‐performance CNT yarns. [ABSTRACT FROM AUTHOR]

Zinc oxide (ZnO) has been widely acknowledged as a highly effective photocatalyst for the degradation of organic pollutants. In this study, we presented silver nanoparticles (AgNPs) embedded ZnO foam photocatalyst (Ag−ZnO) on glass substrates by the chemical bath in‐situ co‐deposition method. Our findings demonstrat that at low Ag‐loading content, metallic Ag0 NPs are embedded within the ZnO foam, while at high Ag‐loading content, they accumulates increasingly from inside to the surface of the foam. With the increase of AgNPs loading from 0.1 mM to 1.5 mM, the absorption of Ag−ZnO foams in the visible light region gradually enhances. The photocatalytic degradation efficiency of rhodamine B (RhB) is the highest in Ag−ZnO foams when the Ag loading concentration reaches 0.8 mM, suggesting an optimal content of Ag for enhanced performance. This trend is attributed to the photo‐induced charge transfer behavior of Ag−ZnO samples. The AgNPs embedded inside the ZnO foam enhance the separation of photo‐induced charges and prevent their recombination. As a result, Ag−ZnO(0.8 mM) foam with more photo‐induced holes participate in the photocatalytic reaction, leading to a remarkably high photocatalytic activity. [ABSTRACT FROM AUTHOR]